Dishnetwork Remote Wont Work On Sat

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on March 13th, 2014 10:56 AM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi there allrelfidd,
My name is Kimberly and I form part of the Social Media Department with DISH. It is a pleasure to help you. If your remote is currently not allowing you to access your guide and change channels please make sure that your remote is on the correct mode which is, Satellite Mode. How do you know if the remote is on SAT mode? You can find out by pressing any button on the remote and pay attention to the four mode buttons located at the top pf the remote and check to see if the SAT clear button is the one that lights up. If your remote is on SAT mode but is still not changing channels it will most likely need to be readdressed to the receiver. Follow this link for detailed information on how to address your remote to the receiver http://www.mydish.com/support/remote-control?WT.svl=contentarea If you have additional questions please feel free to reach me at: [email protected]

Kimberly Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Equipment : IR-to-UHF Upgrade Kit
...UHF Pro Upgrade Kit enables an ultra-high frequency (UHF) remote to control those components. Plug in SAT mode. Verify the converter has an unobstructed line of the ...a receiver located in a suitable location near the receiver? What if the IR blast cannot work with an IR remote control, even through participating DISH Network Retailers, DNSC installers and direct Used for: 1000,...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... that may offer assistance with your equipment. We do not receive IR signals. Verify function of remote. To verify the code works, try the codes listed in bold first, if available, followed by pressing and releasing the SAT button. Press and release the Power button. If there is no code programmed into the...
Tech Portal : Remotes : 6.4 IR/UHF Pro : Troubleshooting
... a blue If the customer has a 522, 625, or a 921 receiver verify that came with the replacement remote and not with the working remote. DO NOT PRESS RECORD, use regular programming steps. IR TV/VCR/AUX Mode SAT In AUX Mode If the batteries are installed correctly and are generally not interchangeable between the receiver...