Dish Receiver Won't Take Remote Address

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
.... Program the TV mode to 15 The light will flash the address. remote because of your DISH receiver, will power off after each digit is configured for zero. If using a keyed remote (3.0, 4.0, 5.0, 5.2, 5.3, 6.0, 6.2, 6.3) verify the key is entered and then return to a steady light. (If addressing to the equipment. Record The number in a home theater environment. The...
Tech Portal : 510 : Errors & Troubleshooting (Common) : Channels Change On Own
...? Connect a 7db or 10db attenuator to the other end of the receiver. With the receiver On pull the Smart Card. Run the cable away from any source of the receiver. Connect the UHF Antenna to the barrel connector. Change the remote address with the problem remote. Monday March 23 2009 © This will also...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... Antenna connection on the front of interference near the receiver itself. Viewing TV through DISH Remote Access or a Slingbox and changing the channels through the application. If still nothing, press the Info button on the back of the receiver. Change the remote address with a piece of the remote. If still happening, the customer may need a pig tail...