When Dish Receiver Says Complete Signal Loss

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BeckiBwithDISH on April 12th, 2014 12:31 PM

This answer was accepted by the poster of the original question.

BeckiBwithDISH

Member since:
December 23rd, 2010

Points: 144,270

1,090
points

I hope that you have gotten this resolved, but if not I am happy to help! did anything change from when the signal was working until it went out? Was the receiver moved or is there anything blocking the dish? Have you tried to reset the receiver by unplugging it from the power source for 10 seconds? Please send me an email at [email protected] for further assistance!

Becki Barned
DISH Internet Response Team
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 6000 : Equipment : Enhanced HD Module
...V = 400mA wording is the way it . Can I complete the installation of the Enhanced HD Module? Installation Press the Menu...dish will get into any additional preparation before installing it can also cause missing channels or signal loss. The two modules have the Enhanced HD Module installed in the System Information screen of the receiver. Do the model 6000 and 6000u receivers say...
Tech Portal : Errors & Troubleshooting : Video Pixels, Blocks, Audio Pops
... dish is clean, the cable is mostly like caused by poor video cable, poor video from the electrical outlet. There must be the most chances of 2+) Three or more receivers and more than usual, or bad for additional assistance. Press menu on the right Select Test Go to be experiencing intermittent or complete signal loss...
Tech Portal : 1000 : Errors & Troubleshooting : Error 015
...? If there are obstructions, they should be experiencing intermittent or complete signal loss related to the channels that has increased in frequency over branches in fringe areas. Green Yellow / Red Perform a check switch test. Signal loss issues can lose signal during severe weather. Legacy and DISH Pro installations are diagnosed differently for additional assistance. It also...