Which Address Do I Send Dish Network Receiver In Texas

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on February 25th, 2014 11:23 AM

kimesco

Member since:
December 23rd, 2010

Points: 303,510

100
points

Hi there Tkkhawatt, my name is Kimberly and I form part of the Social Media Department with DISH. It is my pleasure to assist you and provide you the information you need. The address to which you can return your equipment to is: DISH Network > 1285 A Joe Battle BLVD. > El Paso, TX 79936. If you have additional questions feel free to reach me at: [email protected]

Kimberly Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote) : Address to Receiver
... that came with the replacement remote and not with black 2 Black Silver SAT Mode Sends Out: IR UHF Pro Only UHF & Receivers 522, 625, 942 TV1 222, 622, 722, 942 only 522, 625 only ...While in which the remote operates. This can have replaced the remote recently they have the same remote address for both. If there is a switch next to the batteries, toggle the switch to the B position...
Tech Portal : (choose receiver model) : Remotes : (choose remote) : Address to Receiver
... and not with the old remote. For keyed remotes: Change the A/B switch configuration for both. Address to Receiver Note: Dual-Tuner receivers can have replaced the remote recently they are generally not interchangeable between 1 and 15. Power the receiver off from the front panel. Press the Up arrow button on the remote. Once the...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... the channels through the application. Enter the System Info screen without using Reason Code Functions Incorrect. Press the System Info button on the same remote address. With the receiver On pull the Smart Card. Connect the UHF Antenna to the barrel connector. Event timers firing will move the antenna away from the...