My Remote#2 Will Not Let Me Select A Channel As It Interfers With Remote #1.

The receiver we have is #722 DVR. just installed yesterday. On back of remote 2, is our TV down stairs, it says to hit Ch60 and go and then select channel we want to watch. I have done this and it interferes with remote #1 for TV upstairs to the same channel. On #1 we select the channel we are watching and it will come on #2 also. We cannot get seperate channels for each TV.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MikeHDISHNetwork on January 7th, 2013 7:59 AM

This answer was accepted by the poster of the original question.

MikeHDISHNetwork

Member since:
December 23rd, 2010

Points: 51,920

1,100
points

Hi myrosemill, my name is Mike Houston a Social Media Representative at DISH. I am more than happy to help you with your TV2 remote. The first thing you will want to make sure the receiver is in dual mode. I will provide you our link that better explains and if you have further questions please e-mail me at [email protected]. Here is the link I have promised you: http://www.mydish.com/support/same-video-2-tvs

Mike Houston DISH Network

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Errors & Troubleshooting : Audio/Video Distorted
... light on , TV1 (Green) TV2 (Blue) All TVs? Change the TV2 television up to cycle through the TV's inputs/channels. Connect the receiver TV1 TV SET OUT to the TV. Verify the the satellite system is properly grounded One function of electrical interference on the receiver's front panel is needed to watch satellite programming on a different electrical circuit. A loose...
Tech Portal : (choose receiver model) : Troubleshooting : Off-Air Digital/HD Antenna
... the power unit in ? Select System Setup, Installation, HDTV Setup. If that receives signal from the front panel power button. Select Save to lose signal every time it rains, though. Enter the channel number for the channel you will generally provide better results. When finished, select Save. Select Remove, then select Save. You may interfere with access to find analog...
Tech Portal : (choose receiver model) : Troubleshooting : Off-Air Analog
... are having difficulty receiving off-air broadcast channels or have an 8VSB off-air digital tuner only. * * Digital off-air can only be viewed on TV1 (222, 622, 722) with the exception of recorded events, which can be purchased from interfering with only a small portion of analog TV signals for optimal antenna selection. A larger outdoor type...