Dewalt DXPW3835 Support Question
Dewalt DXPW3835 Support Question
Find answers below for this question about Dewalt DXPW3835.Need a Dewalt DXPW3835 manual? We have 1 online manual for this item!
Question posted by Serrano5402 on December 7th, 2022
I Got A Dxpw3835 Pressure Washer. One Of My Valves Is Leaking Water. Need Th
I got a dxpw3835 pressures washer. One of my valves is leaking water. Need the part number for seal.
Current Answers
Answer #1: Posted by SonuKumar on December 7th, 2022 8:50 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,622,780
Member since:
May 9th, 2021 Points: 16,622,780
https://www.oemtoolparts.com/dewalt-parts/dewalt-dxpw3835-parts-list
https://www.toolpartspro.com/dewalt-parts/dewalt-dxpw3835-parts-list
https://www.searspartsdirect.com/model/6a8a60gffq-000280/dewalt-dxpw3835-gas-pressure-washer-parts
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Dewalt DXPW3835 Manual Pages
Instruction Manual - Page 2
...Engine K. Gas cap O. High-pressure pump R. K L M
I . Throttle control lever L. Handle assembly P. Professional Spray gun D. Fuel valve lever N. Pump
For best results... D High-pressure hose Q. Top handle
Engine
Refer to the engine instruction manual for pressure washers is not available, an SAE 30W non-detergent oil may be used. English
DXPW3835 Pressure Washer
A. Quick-connect...
Instruction Manual - Page 3
... cc OHV
** PSI and GPM ratings determined in accordance with the Pressure Washers Manufacturers Association (PWMA) standard PW101.
*** HONDA™ is used under license from open windows, doors and vents. INC.
WARNING: Indicates a potentially hazardous situation which , if not avoided, may leak into your house. Using an engine indoors can build up in...
Instruction Manual - Page 4
...tank.
• Use care in the manual. Know how to stop the product and bleed pressures quickly. If the product is not equipped and will expand fuel in the tank... state of California. Do not overreach or stand on unstable support.
Danger: Risk of Nozzle.
Move pressure washer away from cigarette sparks, electrical arcing, exhaust gases and hot engine components ...
Instruction Manual - Page 5
...could lead to accidental ignition. Equip areas with fire extinguisher suitable for high-pressure washers. Avoid enclosed areas such as garages, basements, etc..., insecticides, or any other corrosive compound.
5
English
• Operating the pressure washer in an explosive environment could result in a fire....
Instruction Manual - Page 6
... not use a lance and/or lance/ gun combination that is leaking or damaged.
• Never touch, grasp or attempt to cover a pinhole or similar water leak on the high-pressure hose. Replace the hose immediately if it
• Your pressure washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh, which could...
Instruction Manual - Page 7
... SPRAY
What can happen
How to prevent it
• Unsafe operation of your pressure washer could lead to serious injury or death to ...173;come familiar with the operation and controls of the pressure washer.
• Keep operating area clear of all times.
• Never defeat the safety features of this...
Instruction Manual - Page 8
...
off valve, drain the fuel from vehicle immediately upon arrival at all times.
• Do not overreach or stand on an unstable support.
• Do not use pressure washer while standing on a protective mat
when transporting to protect
against damage to avoid fuel
carpet, paint or other
leaks...
Instruction Manual - Page 9
... spray directed at the joint between the tire and rim.
Keep children away from the pneumatic tire sidewall. Add air in serious injury.
• On pressure washers rated above 1600 psi (11032 kPa) use and while inflating tires; English
WARNING: RISK of Bursting
What can happen
How to prevent it
• Con...
Instruction Manual - Page 10
Direct spray away from attempting to lift too
• The pressure washer is too heavy to be lifted by one
heavy an object. ...operated product before lifting. Tighten until snug.
10 SAVE THESE INSTRUCTIONS
FOR FUTURE USE
INSTALLATION
Pressure Washer Assembly (Fig. 1)
1. Use only household detergents, cleaners and degreasers recommended for use with the F...
Instruction Manual - Page 11
... secure. 5.
Add air in the nozzle holder (B) on the surface to match colored nozzles
on
the nozzle holder. Refer to increase pump pressure. A higher pressure setting than the rating of water and a wider spray pattern. English
EE
DD
R
O
4.
The further away you are color coded to be on the panel assembly (A). NOTICE: DO...
Instruction Manual - Page 12
...chemical/
cleaning solution. Turn engine off before squeezing gun trigger.
NOTE: For every 10 gallons (38 liters) of water
pumped 1 gallon (3.8 liters) of fluid injection. Do not use . DO NOT use on wood
15˚ ... Before spraying, check the item to resist damage from your pressure washer is running. English
Nozzle Color Red
Spray Pattern 0˚
Uses
powerful pinpoint for...
Instruction Manual - Page 13
...Leaks caused by warranty. See a physician immediately! WARNING: Risk of spray wand, refer to rinse system thoroughly. Wipe any pets or animals.
If pump is
running or hot. Wipe up Procedure
1. Refer to lower
T
the temperature inside the pump
rises too high the thermal relief valve... hot water, use cold water only.
• Never turn water supply off while pressure washer engine ...
Instruction Manual - Page 14
... English
3. The cone side faces out.
5. Place the fuel valve lever (M) in water inlet of injury from the pump and high pressure
V
hose by depressing trigger until a steady stream
of gun to the CLOSED position
as needed.
14. Then pull starter grip (I) rapidly to stop water flow. Warning: Risk of 5
gallons per minute at 20...
Instruction Manual - Page 15
...50 hours of property damage. How To Change Pump Oil
BB AA
1. Place the fuel valve lever (M) in hose or spray gun.
6. NOTICE: Risk of operation and every 300... storage procedures. NOTE: The pressure washer frame is used .
6. CC
4. If the pressure washer is equipped with pump oil.
Tighten securely.
5. Turn water source off while pressure washer engine is drained, replace oil...
Instruction Manual - Page 16
...seals of the pump regardless of property damage. Y 4. Reconnect spray wand to hose as shown.
16 Start pressure washer and place spray wand into water inlet of pump.
2. To Clean the Water...necessary.
1. Shut off the pressure washer and turn on both sides...Connect length of garden hose
to water inlet of garden hose with ... spark plug wire. 3. Direct water supply into spray wand to the...
Instruction Manual - Page 17
...
Recommended accessories for use of any accessory for purchase from spray gun and wand.
Pressure Washer
1. Drain all water from water inlet of personal injury.
NOTICE: Risk of pump.
6. If you need assistance in cradle of the pressure washer. WARNING: The use with your tool are available for your local dealer or authorized service center. Pull engine starter...
Instruction Manual - Page 18
..., abuse, accidental damage, negligence, improper use, maintenance, or storage. See engine manual. High Pressure Pump (defects in material and workmanship) Includes nozzles, hoses, spray guns, wands
Ninety (90) days from date of purchase.
Neither is limited to , valves and seals, which are final. This warranty covers defects in material and workmanship and not...
Instruction Manual - Page 19
...) and 5 gallons per Square Inch. Refer to Chemicals and Cleaning Solvents. Water supply: All pressure washers must have a source of measure for air pressure, hydraulic pressure, etc. Chemical injection system: Mixes cleaners or cleaning solvents with the water. The valve will open and release a gush of water in an effort to re-circulate within pump when the gun...
Instruction Manual - Page 20
initial use 22, 23, 24 Water leaking at gun/spray wand connection 25, 26 Water leaking at pump...25, 26, 27, 28 Oil leaking at pump...29, 30, 31, 32, 33, 34, 35 Pump Pulsates...12
...your dealer. Add required amount of the more frequently encountered malfunctions, their causes and corrective actions. Pressure builds up after two pulls on a hot engine or an engine that has been exposed to ...
Instruction Manual - Page 21
... engine, then the water source. Low water supply. Make sure end of high-pressure hose. (Troubleshooting Codes cont.)
Code 8 9 10 11 12 13 14
possible cause Fuel valve closed. POSSIBLE SOLUTION Move the fuel valve lever to remove all air from the pump inlet and turn on water source. Repair leak. Air in hose...
Similar Questions
Need Help
I have the 3600 psi pressure washer it runs fine but don't have any pressure at all. Seems to build ...
I have the 3600 psi pressure washer it runs fine but don't have any pressure at all. Seems to build ...
(Posted by 2210dannyfoster 9 months ago)
What Is The Black Knob On Top Of The High Pressure Pump Used For?
(Posted by jsdsilva 1 year ago)
Builds Up Pressure But Doesn't Shut Off
My compressor builds pressure, but doesn't shut off at the pressure that it is set at, instead it go...
My compressor builds pressure, but doesn't shut off at the pressure that it is set at, instead it go...
(Posted by fndjr33 8 years ago)
Is The Valve On The Pump Chemical Feed Inlet An On/off Valve?
Is this a flow rate valve that always remains partially open or is it supposed to close tight?
Is this a flow rate valve that always remains partially open or is it supposed to close tight?
(Posted by gerstnert 10 years ago)