Dewalt D55141 Support Question
Dewalt D55141 Support Question
Find answers below for this question about Dewalt D55141.Need a Dewalt D55141 manual? We have 1 online manual for this item!
Question posted by fndjr33 on November 7th, 2015
Builds Up Pressure But Doesn't Shut Off
My compressor builds pressure, but doesn't shut off at the pressure that it is set at, instead it goes till the pressure relief valve blows off and keeps running.
Current Answers
Answer #1: Posted by waelsaidani1 on November 8th, 2015 12:27 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
Hello here is how to fix this: http://fix-my-compressor.com/air-compressor-will-not-stop/
Related Dewalt D55141 Manual Pages
Instruction Manual - Page 2
... delay
Specifications
MODEL WEIGHT HEIGHT WIDTH LENGTH AIR TANK CAPACITY (GALLONS) APPROX CUT-IN PRESSURE APPROX. Check Valve G. Air Tank Drain Valve I
A
H
G
2 Safety Valve H. Air Tank Pressure Gauge C. English
D55141 Air Compressor
A. CUT-OUT PRESSURE SCFM @ 100 PSI (689.5 kPa)
D55141 30 lbs. (13.61 kg) 10.5" (266.7 mm) 19.125" (485.8 mm) 21.375 (542.9 mm...
Instruction Manual - Page 3
...
HOW TO PREVENT IT
• It is normal for electrical contacts within the motor and pressure switch to these chemicals: work in death or serious injury.
CAUTION: Indicates a potentially hazardous....
• Always operate the compressor in death or serious injury.
When using such tools. IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US TOLL FREE AT:...
Instruction Manual - Page 4
...toxic vapors, or solid particles from any wall or obstruction that would restrict the flow of compressor.
• Operate compressor in an open area at least 12" (30.5 cm) away from the air tank... safety data sheets for use . Do not operate unit indoors or in any of the compressor ventilation openings will cause serious overheating and could cause fire.
• Unattended operation of treating...
Instruction Manual - Page 5
...attempt to inflate small low pressure objects such as children's toys, footballs, basketballs, etc. Attachments & accessories:
• Exceeding the pressure rating of air tools, spray guns, air ...Failure to alter the factory set operating pressures. All pressure vessels should be UM coded (for assistance. HOW TO PREVENT IT
• Never operate the compressor outdoors when it may be ...
Instruction Manual - Page 6
...people or animals.
• Always turn the compressor off and bleed pressure from the air hose and air tank before attempting maintenance, attaching tools or accessories. Loose clothes, jewelry, or ...; Keep your clothing.
• Never operate the compressor with side shields when using the compressor.
• Never point any nozzle or sprayer toward any exposed metal parts on compressor during...
Instruction Manual - Page 7
...
air compressor.
• Keep operating area clear of all persons, pets, and obstacles.
• Keep children away from this product may contribute to hearing loss.
• Always wear certified safety equipment: ANSI S12.6 (S3.19) hearing protection.
PRESSURE SWITCH
The pressure switch automatically starts the motor when the air tank pressure drops below the factory set cut...
Instruction Manual - Page 8
When the air compressor reaches cut -out pressure setting, the
safety valve (G) will shut off the air
compressor at its factory set pressure
(slightly higher than or equal to the tank pressure. This pres-
Grasp the hose and pull to ensure coupler is open, allowing compressed air to remain inside the air tank. F
CHECK VALVE
When the air compressor is operating, the...
Instruction Manual - Page 9
...when installing or disconnecting to the cord set and plug (J) with this unit contains a grounding pin (L). Repairs to prevent hose whip. 1. Instead of using an extension cord, increase ...CAUTION: Certain air compressors can be made by fuses, use of damage.
4. Ensure regulated pressure gauge reads 0 PSI (0 kPa). 2. DO NOT USE AN ADAPTER.
3. Do not use . The cord set or plug MUST...
Instruction Manual - Page 10
... when driving to avoid a loss of balance. See
Voltage and Circuit Protection under Maintenance. 6. Ensure
regulated pressure gauge reads 0 PSI (0 kPa).
7. Attach hose and accessories.
10 Compatibility
Air tools and accessories that are run off the compressor must be compatible with petroleum products, an air line filter for proper cooling. NOTE: Always use vibration...
Instruction Manual - Page 11
...-clockwise) fully to permit air to escape and prevent air pressure build up (Fig. 1)
1. The compressor will corrode and weaken the air tank causing a risk of air tank rupture. 5. Run the compressor for the first time and when the check valve or a compressor pump/motor has been replaced.
1. See Regulator under Preparation for safety, operation and maintenance...
Instruction Manual - Page 12
... starting service.
Grasp black lever on the air compressor.
1. Drain air tank. 4. NOTE: Take note of the positions and locations of in removing moisture, dirt, etc. If the safety valve does not work properly, over-pressurization may be regulated and must be disposed of valve.
12 English
MAINTENANCE
The following procedures must be followed...
Instruction Manual - Page 13
... available for all service calls: Model Number Serial Number Date and Place of the air compressor. We will repair, without charge, any defects due to or higher than the rating... REPLACEMENT: If your warning labels become illegible or are warranted for one year from your tool, please contact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-DEWALT for a ...
Instruction Manual - Page 14
... when accessory is called cut -out pressure. It builds to a certain high pressure before the motor automatically shuts off is used. English
GLOSSARY
CFM: Cubic feet per square inch; The high pressure at which the motor shuts off , protecting your air compressor, it is , the air compressor pump should not run , air pressure in pressure. SCFM: Standard cubic feet per minute...
Instruction Manual - Page 15
...valve plate 5
Air leaks from safety valve...6
Knocking Noise...6
Pressure reading on the regulated pressure gauge drops when an accessory is used 7
Compressor ...Pressure switch does not shut off motor when compressor Set the On/Off switch to OFF, if the unit does not shut
reaches cut-out pressure
off contact a DEWALT factory service center or a DEWALT
authorized service center.
2
Pressure...
Instruction Manual - Page 16
... to operate accessory. If it is higher than the CFM or pressure supplied by pulling on ring. Remove, clean or replace. Replace.
16 Decrease amount of bursting.
Tighten fittings.
Operate safety valve manually by your air compressor, a larger compressor is needed to occur when an accessory is used, adjust the regulator as instructed in...
Instruction Manual - Page 52
... Road, Baltimore, MD 21286 (AUG06) Form No. the "D" shaped air intake grill; the kit box configuration; A16639 r3 D55141 Copyright © 2006 DEWALT
The following are trademarks for one or more DEWALT power tools: the yellow and black color scheme; and the array of lozenge-shaped humps on the surface of pyramids...
Similar Questions
Compressor Will Not Shut Off. Pressure Goes Up Until Safety Valve Opens
(Posted by mcdougaldwilliam 2 years ago)
Compressor Won't Build Pressure. I Replaced The Manifold. The Compressor Goes
compressor won't build pressure. I have replaced the manifold and it will only go to about 40 psi. I...
compressor won't build pressure. I have replaced the manifold and it will only go to about 40 psi. I...
(Posted by Tbassgolf 3 years ago)
Will Not Build Over 30 Lb. Never Quit Running
Will not build over 30 lb. Of pressure keeps running
Will not build over 30 lb. Of pressure keeps running
(Posted by thomasdavis359 6 years ago)
Compressor Not Building Pressure
Why is it my compressor runs but wont build any pressure even when I mess with the rregulatorit does...
Why is it my compressor runs but wont build any pressure even when I mess with the rregulatorit does...
(Posted by eller7350 10 years ago)