Dewalt DXPW3025 Support Question
Dewalt DXPW3025 Support Question
Find answers below for this question about Dewalt DXPW3025.Need a Dewalt DXPW3025 manual? We have 1 online manual for this item!
Question posted by enlighteninglad on June 18th, 2013
Dxpw 3025 Pump Problem
Water is shooting out of my pump relief valve. what could be the problem?
Current Answers
Related Dewalt DXPW3025 Manual Pages
Instruction Manual - Page 2
... Spray gun D. Quick-connect
spray wand F. Starter grip
J. Fuel valve lever N. High-pressure hose Q. If this oil is recommended, as these contain a rust inhibitor and an anti-foaming agent.
Nozzle holder C. Frame G. Engine dipstick/oil plug H.
Handle assembly P. Pump
For best results, pump oil designed specifically for location and operation of other engine...
Instruction Manual - Page 3
....dewaltpw.com or 1-877-FNA-GAS1 (1-877-362-4271)
Important Safety Instructions
DANGER: Carbon Monoxide. English
Specifications
MODEL
WEIGHT
HEIGHT
WIDTH
Length
PSI**
GPM**
Engine
DXPW3025
85 lbs (38.5 kg)
22" (55.9 cm)
21" (53.3 cm)
34" (86.4 cm)
3000 (20684 kPa)
2.5 (9.5 L/min)
HONDA GX160*** 163 cc
** PSI and GPM ratings...
Instruction Manual - Page 6
... fittings or worn or damaged hoses can result in good condition. The stream of water IS under high pressure and WILL penetrate skin.
• Never place hands in front...pressure, shut off engine, turn off water supply and pull gun trigger until water stops flowing.
• Use only accessories rated equal to cover a pinhole or similar water leak on the high-pressure hose. DO NOT ...
Instruction Manual - Page 8
...173;jury or death can result.
the off valve, turn the valve to
in fire or
equipped with both hands.
Improp&#...washer on a ladder.
• Grip gun/wand firmly with a fuel shut- off valve, drain the fuel from vehicle immediately
upon arrival at all times.
• Do not... cleaning tool that could look like a toy to a child.
• Reactive force of gun ...
Instruction Manual - Page 11
... information).
Make sure it .
Nozzles are color coded to Spray Wand Nozzles. Warning: Risk of water and a wider spray pattern. The further away you are stored in small increments and frequently use ...: The high-pressure pump was filled with oil at the factory to Maintenance for the spray wand are , the less the pressure will go down and the water pressure will be on
the...
Instruction Manual - Page 12
....
1.
To apply chemicals and solvents
1.
NOTE: For every 10 gallons (38 liters) of water
pumped 1 gallon (3.8 liters) of serious injury. Do not direct discharge stream toward persons, unprotected skin...hose connection
of fluid injection. S
2. Changing Nozzles on Spray Wand
Danger: Risk of pump as flowers and shrubs. Serious injury will be cleaned to assure yourself that it is ...
Instruction Manual - Page 13
... with very hot engine
muffler during or immediately after use cold water only.
• Never turn the water source off while pressure washer engine is left in amputation or other serious injury. When the temperature inside the pump
rises too high the thermal relief valve (T) will not be covered by loose fittings or worn or...
Instruction Manual - Page 14
... injury. Remove all air from spray. Place the fuel valve lever (M) in use to
the open position.
15. Warning: Risk of property damage. Then pull starter grip (I) rapidly to pump outlet.
7. Then pull cord rapidly to stop water flow. Note: If the oil level in water inlet of
U
contamination always protect against backflow when...
Instruction Manual - Page 15
... cause serious injury or death. An oil designed
specifically for proper storage procedures. If the nozzle becomes partially clogged or restricted, the pump pressure will be exposed to relieve any water
pressure in the OFF position.
Replace pump oil plug and tighten securely. English
3.
Place the fuel valve lever (M) in hose or spray gun.
6.
Instruction Manual - Page 16
... the nozzle cleaning tool (Y) provided and back flush with a male hose connector attached to water inlet of pump.
2. Reconnect spray wand to the internal seals of the pump regardless of property damage. Clean filter by grasping the end and removing it with water on water supply.
8. Cone
side faces out.
Pump
The manufacturer recommends using a pump protector/ winterizer...
Instruction Manual - Page 17
...a FNA authorized service center or other accessory not recommended for use with your tool are available for purchase from your tool, please contact the FNA Group at www.dewaltpw.com, 1825 Greenleaf Avenue, ...
Store chemical hose so it in length than the rating of personal injury. Drain all water from the nozzle end of the pressure washer handle.
2. Use only accessories rated equal ...
Instruction Manual - Page 18
...from an authorized dealer or not approved by engine manufacturer warranty.
High Pressure Pump (defects in the instruction manual. This warranty replaces all parts said to ...must be liable for commercial loss.
Warranty does not apply to failures due to , valves and seals, which are nontransferable. Specific limitations/extensions and exclusions apply.
Normal wear items...
Instruction Manual - Page 19
... Spray Wand Nozzles. CU: Cleaning Units. GPM: Gallons Per Minute. Also used for a water supply are 20 psi (138 kPa) and 5 gallons per Square Inch. Thermal relief valve: When the temperature inside the pump. The unit of water in an effort to improve cleaning effectiveness. kPa (kilopascal): Metric pressure measurement. 1 kilopascal equal 1000 pascals. Chemical...
Instruction Manual - Page 20
...fuel.
initial use 22, 23, 24 Water leaking at gun/spray wand connection 25, 26 Water leaking at pump...25, 26, 27, 28 Oil leaking at pump...29, 30, 31, 32, 33, 34, 35 Pump Pulsates...12
Code 1 2 3
Troubleshooting ... engine or an engine Move choke to the NO CHOKE position. Move the fuel valve lever to the CHOKE position.
5
Spark plug wire not attached. Low oil. ...
Instruction Manual - Page 21
... Worn or obstructed valves. 24 Worn unloader piston. 25 Worn or broken o-ring. 26 Loose hose connection. 27 Piston packings worn. 28 Pump head or tubes damaged from the hose. Repair leak. Apply sealant tape if necessary. Turn off . Disconnect the water source from the pump inlet and turn the water source on wa...
Instruction Manual - Page 22
... manual for correct amount. Check and replace. Drain and fill with oil.
possible cause
31 Worn drain plug o-ring 32 Worn fill plug o-ring.
33 Pump overfilled.
34 Incorrect oil used. 35 Vent plug is clogged.
36 Air filter filled with correct amount and type of oil. Clean vent plug; Refer...
Instruction Manual - Page 68
... the array of DeWALT Industrial Tools
The FNA Group, 1825 Greenleaf Ave, Elk Grove Village, IL 60007, a licensee of lozenge-shaped humps on the handgrip; the "D" shaped air intake grill;
The FNA Group 1825 Greenleaf Avenue, Elk Grove Village, IL 60007
(DEC11)
Part No. 7104816 r1 DXPW3025 Copyright © 2011
The following...
Similar Questions
Dxpw3025 Engine Instruction Manual
Need Dxpw3025 engine Instruction Manual,
Need Dxpw3025 engine Instruction Manual,
(Posted by barbaradoc06 6 years ago)
Dewalt Dcb101 Problem Pack Or Charger
My newest DCB101 charger isn't working anymore. I have two other for a total of three. Just tonight ...
My newest DCB101 charger isn't working anymore. I have two other for a total of three. Just tonight ...
(Posted by justinkristensen 8 years ago)
I Overfilled The Pump To The Top.is The Fix Simply To Drain Oil To Properlevel?
(Posted by herbertmwebb 10 years ago)
How Does The Pump Separate From The Engine Crank Shaft?
(Posted by peterhayles 10 years ago)
Dct410 Battery Or Charger Problem
Hello, I own a DCT410 inspection camera and either the battery (DCB120) or the charger (DCB100) is n...
Hello, I own a DCT410 inspection camera and either the battery (DCB120) or the charger (DCB100) is n...
(Posted by bryanbrodeur 10 years ago)