Dewalt DCL074 Support Question
Find answers below for this question about Dewalt DCL074.Need a Dewalt DCL074 manual? We have 1 online manual for this item!
Question posted by Oneculdawg on April 17th, 2023
How To Factory Reset Dcl074 Bluetooth
Current Answers
Answer #1: Posted by MarkivShah on April 17th, 2023 11:33 PM
- Turn off the speaker: Make sure the speaker is turned off by pressing and holding the power button until the LED indicator turns off.
- Press and hold the volume up and play/pause buttons: Press and hold the volume up and play/pause buttons simultaneously until the LED indicator flashes rapidly.
- Release the buttons: Once the LED indicator starts flashing rapidly, release the volume up and play/pause buttons.
- Wait for the reset to complete: The LED indicator will flash rapidly for a few seconds, and then it will stop flashing once the reset is complete. The speaker will also emit a tone to indicate that the reset was successful.
- Turn on the speaker: Turn on the speaker by pressing and holding the power button until the LED indicator lights up.
After performing a factory reset, the speaker will be returned to its original settings and all paired devices will be cleared. You will need to pair your devices again to use the speaker with Bluetooth.
Answer #2: Posted by SonuKumar on April 18th, 2023 6:58 AM
- Charge the battery: Make sure the battery is fully charged. If the battery is low, the light may not work properly.
- Check the battery contacts: Make sure the battery contacts are clean and free from debris. Dirty contacts can prevent the battery from making a proper connection with the light.
- Check the bulb: If the bulb is damaged or burned out, the light will not work. Try replacing the bulb with a new one.
- Check the switch: If the switch is not functioning properly, the light will not turn on. Make sure the switch is clean and free from debris. If the switch is damaged, it may need to be replaced.
- Check the wiring: If the wiring is damaged or frayed, it can cause the light to malfunction. Inspect the wiring and look for any signs of damage. If the wiring is damaged, it may need to be repaired or replaced.
If none of these steps resolve the issue, it may be necessary to have the light serviced by a professional technician or contact Dewalt customer service for further assistance.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Dewalt DCL074 Manual Pages
Similar Questions
the 2 AC outlets will not work but everything else is? What is wrong
Stuck in hot/cold delay of charging phase.Need some kind of rese
when connected to Bluetooth, phone cannot control the volume of the radio
I can't use the radio after I hit the Bluetooth button