Cub Cadet XT1 LT42 with IntelliPower Support Question
Cub Cadet XT1 LT42 with IntelliPower Support Question
Find answers below for this question about Cub Cadet XT1 LT42 with IntelliPower.Need a Cub Cadet XT1 LT42 with IntelliPower manual? We have 2 online manuals for this item!
Question posted by vsawyer on September 21st, 2021
Electric Throttle Control Stopped Working. Mowing At Idol
The person who posted this question about this Cub Cadet product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by techyagent on September 21st, 2021 7:13 PM
techyagent
Member since:
June 17th, 2014 Points: 4,799,790
Member since:
June 17th, 2014 Points: 4,799,790
If your lawn mower will idle, but stalls on throttle, check the muffler and carburetor. ... If your lawnmower will start up and idle, but then dies when you throttle it up, you might have a problem with the carburetor. The carburetor brings air and fuel together and mixes them in a perfect ratio for combustion.
Please check this link below:-
Thanks
Techygirl
Answer #2: Posted by SonuKumar on September 22nd, 2021 1:00 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,613,800
Member since:
May 9th, 2021 Points: 16,613,800
How do I know if my Cub Cadet solenoid is bad?
First, turn the ignition key to the "On" position. Look for the large terminal posts on the solenoid where the thick red wires connect to the solenoid. Touch the metal shaft of a screwdriver to both of the large terminals at the same time. If the engine turns over and starts, the solenoid is bad and should be replaced.
https://homeguides.sfgate.com/tell-starter-solenoid-bad-kohler-riding-mower-engine-101991.html
https://manualzz.com/doc/53187632/cub-cadet-lt42-with-intellipower-xt1-enduro-lt-42-in.-547...
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Cub Cadet XT1 LT42 with IntelliPower Manual Pages
Operation Manual - Page 2
...
14. Read, understand and follow all controls and their ability to operate the riding tractor...mowing pattern to avoid discharge of dry leaves. Failure to do not point it is in a large percentage of the tractor. Stop tractor if anyone .
4. Replace gasoline cap and tighten securely.
8. Stop...or sandals.
6. Wear sturdy, rough-soled work shoes and close-fitting slacks and shirts....
Operation Manual - Page 3
... soaked debris. Rapid acceleration could cause the front of a responsible adult other sources of control and tip-over backwards, which could cause sliding or a loss of age to lift ... excessive speed.
21. Children
1. Do not mow on slopes. Never remove gas cap or add fuel while the engine is extremely flammable and the vapors are stopped.
7. Wait 5 minutes before filling.
14....
Operation Manual - Page 4
... With Your Tractor
1. Never allow extra distance to stop the engine, disconnect the spark plug wire(s) and ground against the engine to Maintenance Schedule chart in good working condition. Do not change the engine governor settings or over , causing serious personal injury. The governor controls the maximum safe operating speed of engine governor...
Operation Manual - Page 5
...° (25%). Using a Smart Phone, scan the QR code symbol to operate this product. Stop tractor if anyone enters the area.
>10ft (3m)
>10ft (3m)
WARNING - WARNING - Contact... a height no more information. Do not mow across slopes, only mow up and thrown by the blade(s). AVOID FIRES Your tractor is designed to mow through unusually tall, dry grass (e.g., pasture)...and working.
Operation Manual - Page 6
...proceed as follows:
1. Remove this page and fold along the dashed line.
2. Locate a vertical object on it, do not mow it. If there is a gap below the gauge, the slope is too steep for safe operation (See Figure 2 above)....Align either side of slopes. Do not operate machine on slopes in severe injury or death. Always mow up the slope or if you feel uneasy on or behind the slope (e.g.
Operation Manual - Page 8
... hood (c) and secure in -lbs (1.8-2.7 N-m). See Figure 16. See Figure 9.
4. Installing the Front Bumper (If equipped)
WARNING
Disengage the PTO, engage the brake lock, and stop the tractor engine before beginning installation or removal procedures.
Figure 15
Figure 16
8 With the rear tabs installed,
insert the front tabs (a) on the top...
Operation Manual - Page 9
... battery terminal is marked Pos. (+). Place deck lift lever in the desired mowing
height setting.
(d)
d.
See
Figure 18.
5
4. See Figure 18.
... Chute Deflector
2
Figure 17
WARNING
Never operate the mower deck without the chute deflector installed and in step two...Always shield eyes and protect skin and clothing when working near batteries. See the Maintenance and Adjustments section ...
Operation Manual - Page 11
... mower deck is normal.
5 Choke Control (If equipped)
The choke control determines the position of the index notch and push downward to lower the deck, or pull upward to Stopping the Engine for setting the parking brake. Pull the throttle/choke control lever rearward to choke the engine; The tractor is designed to operate with the throttle control...
Operation Manual - Page 12
...PTO (Electric PTO) section for information and instructions on the LCD when the voltage drops below the bottom of the STOP position...STOP position the hourglass symbol is not in the Engine Operator's Manual
Low Oil
Note: The low oil pressure function only works... the seat with an oil pressure switch.
Note: Cruise control can NOT be in need of maintenance intervals for instructions ...
Operation Manual - Page 13
...Throttle and Choke Control
1. lift upward from the operator's seat; Lift upward from the operator's seat. Continue below for turn-key ignitions, skip ahead to a maximum of 15% MTBE by volume) are working as designed, contact your engine's electric... will return to the NORMAL MOWING position.
• Methyl Tertiary...for the protection of the STOP position.
If the safety interlock...
Operation Manual - Page 14
... reverse drive pedal (b) until the desired speed is in the FAST position.
8. Place the throttle control to run for jump starting instructions previously provided; Allow the engine to midway between the FAST and SLOW positions. 4. Have the tractor's electrical system checked and repaired as soon as possible.
3.
Driving The Tractor
WARNING
Keep all...
Operation Manual - Page 15
...CAUTION MODE is placed in either the NORMAL MOWING (a) position or STOP (e) position. To use the REVERSE CAUTION ... to normal mowing operation. Move the throttle to the cutting deck or other (separately available) attachments.
b. The cruise control will remain ...MODE.
See Figure 29. Engaging the PTO (Blade Engage)(Electric PTO tractors)
Engaging the PTO (Blade Engage) transfers ...
Operation Manual - Page 16
... engine. Push the PTO (Blade Engage) lever forward into the disengaged (OFF) position. Fully raise the deck or move the throttle control or throttle/choke control to the FAST position.
• Lower the mower deck to mow heavy brush and weeds or extremely tall grass.
The differential lock will result. See Figure 30. Operating with the...
Operation Manual - Page 17
...Before performing any adjustments or repairs. Wait until all controls and stop . Follow the maintenance schedule given below .
This ... 33 33 33
3 3 3
17 Always wear safety glasses during operation or while performing any type of Deck
Check Safety Interlock System Check Mower Blade Stop Time Inspect & Lube Deck Wheels
Before Each use
3 3 3 3 3 3 3
3
After First 5 Hours
Every 10 Hours
3...
Operation Manual - Page 18
...use of the tractor, the following steps AFTER EACH MOWING:
1. See Figure 32. Complete the following procedures ...the nozzle adapter to a standard garden hose connected to electrical components, spindles, pulleys, bearings or the engine.
One...: This operator's manual covers several models.
Disengage the PTO and stop the engine.
3. See Figure 33.
c
5.
Let the engine...
Operation Manual - Page 19
... lubricate all lubrication points. Refer to avoid burns.
Lubricating Front Wheels
Each of the emission control devices and systems which are being done at least a 2.5 quart (2.36L) capacity to ...Oil
WARNING
Before lubricating, repairing, or inspecting, always disengage PTO, set parking brake, stop engine and remove key to grease the steering pinion/sector gear interface.
Use care to ...
Operation Manual - Page 20
... taken earlier are functioning properly. Removing the Lawn Tractor from the carburetor bowl.
3. Start the engine and allow to be mowing unevenly, leveling adjustments can be made using primarily...the blade tip to the next step.
3. To prevent gum deposits from front to electrical components, spindles, pulleys, bearings or the engine. Fully charge the battery, then disconnect ...
Operation Manual - Page 21
...wheels properly aligned. Contact an authorized service dealer to a complete stop the engine, ENGAGE the parking brake.
2. For tractors with ...the ground when the deck is not functioning properly, have the electrical system checked by excessive amperage. Deck Removal
To remove the deck...4, for instructions. See Figure 41. Figure 40
8. Working on the tractor's right side. See Figure 42. ...
Operation Manual - Page 24
...Do not mulch when grass is working. Deck not leveled properly.
...stop the engine. Problem
Cause
Remedy
Engine fails to FAST position. Throttle control lever not in fuel system.
6. Place Throttle...electric choke is wet.
3. Connect and tighten spark plug wires.
3. Drain fuel tank. Fill engine with throttle...) gas.
6. Mow once at a high cutting height, then mow again at high ...
Parts and Warranty - Page 3
...Lawn Edgers, Pressure Washers CC3224, CC3425 & CC4033 Pressure Washers
Battery Powered Product CORE® 20V & 40V Cordless Handhelds CORE® 20V & 40V Handheld Batteries and Battery Chargers CC 30 e, XT1 LT42 e, RZT S Zero CC30 e & XT1 LT42...Lifetime Motor warranty covers the electric motor housing and its option... Emission Control Systems and is not a Federal Emission Control Warranty Statement...
Similar Questions
Engine Flooding Won't Run Well
(Posted by Chriscoburn5265 2 years ago)
Power Steering Stopped Working.
Power steering stopped working. What are the possible causes and solutions?
Power steering stopped working. What are the possible causes and solutions?
(Posted by tomglaesert49 3 years ago)
Power Steering Stopped Working Power Steering Motor Works If Get Direct Power F
power from battery its GTX2100
power from battery its GTX2100
(Posted by randybyers 3 years ago)
Choke And Throttle Control Of Cub Gt2148
how do you remove the throttle control from the dash of a Cub GT2148
how do you remove the throttle control from the dash of a Cub GT2148
(Posted by Dscaletti 6 years ago)
Cub Cadet Gtx2100 Electric Lift Don't Work
(Posted by Angel39 9 years ago)