Cub Cadet BC 490 Support Question
Find answers below for this question about Cub Cadet BC 490.Need a Cub Cadet BC 490 manual? We have 1 online manual for this item!
Question posted by Rolltidee49 on August 4th, 2016
How To Replace Rewind Starter Rope?
Current Answers
Answer #1: Posted by khanjee on August 4th, 2016 10:32 AM
1
Disable the trimmer by pulling off the spark plug wire. Set it down on a level surface. If it's a split boom trimmer, disengage the lower part of the drive shaft by loosening the fastening nut and pulling it off. This makes the rest of the procedure easier.
2
Unscrew the four screws holding the drive shaft to the engine with a screwdriver and pull the drive shaft away. Turn the drive shaft around to access the starter mechanism -- it is just inside the drive shaft. If you have an older 4-cycle model, unscrew the starter assembly from the side of the engine. You don't need to remove the drive shaft.
3
Pull out the old cord, using needle-nose pliers, if necessary, to unhook the knot from inside the pulley. Clean out the inside of the starter assembly with a rag.
4
Prepare a new length of starter cord with the same diameter as the old one by melting the end with a lighter and rolling the tip in your fingers while it's still warm. This makes it easier to thread through the holes on the starter assembly.
5
Wind the starter pulley two full revolutions clockwise, and line up the holes on the housing cover and the pulley hub. Feed the cord through both holes and tie a knot in the end. Slide the starter grip onto the other end of the rope and tie a knot in that end to hold it.
6
Hold the rope vertically against the pulley, and use the rope to wind the pulley through five or six more clockwise revolutions. Keeping tension on the rope, allow the pulley to slowly unwind, wrapping the rope around itself, until the starter grip is held against the starter housing by the tension in the spring.
7
Replace the starter back onto the trimmer and reassemble the drive shaft, if you took it apart. Reconnect the spark plug wire before you use the trimmer.
Things You Will Need
Please Accept my answer by providing you with the best possible solution. Would be more glade.
THANK YOU
Related Cub Cadet BC 490 Manual Pages
Similar Questions
BC 490 Cub cadet rewinding both the springs so it will retract again
How do you fix the pool rope on a BC 490 Cub Cadet weedeater
ment thank you .