Home » Cub Cadet » Lawn & Garden » Cub Cadet 528 SWE

Cub Cadet 528 SWE Support Question

Find answers below for this question about Cub Cadet 528 SWE.
Need a Cub Cadet 528 SWE manual? We have 3 online manuals for this item!

Cub Cadet Overview Questions Manuals Reviews Videos Research

Question posted by sreuvers on April 23rd, 2022

Oil Capacity For 528 Snow Blower

The person who posted this question about this Cub Cadet product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by SonuKumar on April 23rd, 2022 7:32 AM

This answer was accepted by the poster of the original question.

SonuKumar

Member since:
May 9th, 2021

Points: 16,604,600

1,100
points

https://www.manualslib.com/manual/34068/Cub-Cadet-Swe-528.html?page=7#manual

How much oil does a Cub Cadet 524 SWE take?

Engine oil capacity is 600 ml (approx. 20 oz.). Do not over-fill.

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

Related Cub Cadet 528 SWE Manual Pages

Jet Sweep Warranty Information - Page 1

...or consequential loss or damage including, without limitation, expenses incurred for substitute or replacement lawn care services or for terms and conditions. Some states do not allow the exclusion...an implied warranty lasts, so the above . CUB CADET LLC MANUFACTURER'S LIMITED WARRANTY FOR SNOW THROWERS, LOG SPLITTERS, CHIPPER-SHREDDERS, CHIPPER-SHREDDER VACUUMS AND JET SWEEPS The limited warranty...

500 Series Snow Throwers Brochure - Page 1

... and effortlessly change the direction and pitch of your driveway. 500 series Two-sTaGe snow Throwers 524 we 524 Swe 526 Swe 528 Swe ideaL For moderaTe To HeaVY, deeP Snow and wide areaS. 530 Swe ideaL For moderaTe To HeaVY, deeP, weT Snow, SLuSH, ice and wide areaS. sinGle-hand chUTe conTrol 4-way chute control allows you...

500 Series Snow Throwers Brochure - Page 2

...8482; tank™ s Snow Blade P P P P P P P P P P See your local Cub Cadet Independent Dealer for the safety and use information that is for Cub Cadet Lawn and Garden Tractors and Zero-Turn ... lbs. 524 SWE 24" Steerable wheel/ positive traction 526 swe Standard (110 volt) Extended 26" 21" 12" Heavy-duty serrated steel 12" Steerable wheel/ positive traction Standard 528 SWE 28" Steerable...

524 WE Operator's Manual - Page 1

... MAY RESULT IN PERSONAL INJURY. Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty Operator's Manual Two Stage Snow Thrower - 524 WE, 524 SWE, 526 SWE, 528 SWE & 530 SWE WARNING READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE.

524 WE Operator's Manual - Page 2

... Before setting up , operate and maintain your machine. The engine manufacturer is relative to establish the power rating of product specifications for purchasing a Cub Cadet Snow Thrower. Table of this page. This information will operate the machine, carefully follow the recommended safety practices at the time of the frame. Throughout this...

524 WE Operator's Manual - Page 3

... WARNING! This symbol points out important safety instructions which could be operated according to clear snow. 3 Read and follow all control levers before attempting to make any type of yourself and... eye shields during operation and while performing an adjustment or repair to protect your snow-throwing pattern to avoid discharge of age to State of amputating fingers, hands, ...

524 WE Operator's Manual - Page 4

...feet. 2. Do not operate on or crossing gravel surfaces. Do not overload machine capacity by the manufacturer (e.g. Never put hands or feet near rotating parts, in the... Do not unclog chute assembly while engine is complete. unclogging. 19. When starting and operating. snow at children, bystanders and pets or f. i. storing. 16. not touch. Exercise caution when ...

524 WE Operator's Manual - Page 5

...the service department, P.O. Check fuel line, tank, cap, and fittings frequently for gas, oil, etc. Section 2 - Refer to ensure that all mechanical and safety systems are working ... effective working condition. Wait 10 seconds to operate at frequent intervals to comply with snow throwers. Maintenance & Storage 1. Before cleaning, repairing, or inspecting machine disengage all ...

524 WE Operator's Manual - Page 7

... and discard any rubber bands, if present. Observe the lower rear area of the snow thrower to be sure both the left and right sides of Carton • One Snow Thrower • One Chute Control Rod • One Snow Thrower Operator's Manual • Two Replacement Auger Shear Pins • One Chute Assembly •...

524 WE Operator's Manual - Page 9

...with the bracket with 2-Way Chute Control have only one hand while inserting the rod with your snow thrower's dash panel until needed. See Figure 3-9. gear. Support the rear of the hex rod...on the pinion gear, and will fit snuggly into the pinion gear below the 8. removed in your snow thrower. Assembly & Set-Up 9 NOTE: The chute control rod will be to the chute control ...

524 WE Operator's Manual - Page 10

...upward at all times. Figure 3-13 2. Chute Clean-out Tool Adjustments Skid Shoes The snow thrower skid shoes are over-inflated for maximum clearance between the ground and the shave plate... for recommended pressure. Check the tire pressure before operating the snow thrower. Adjust them downward, if desired, prior to operating the snow thrower. See Figure 3-12. Refer to the tire side ...

524 WE Operator's Manual - Page 11

...control in the FAST (rabbit) position and the auger control in the operator's position (behind the snow thrower), engage the auger. 4. To readjust the control cable, loosen the upper hex screw on...auger has completely stopped rotating and shows NO signs of the auger control as follows: 1. The distance snow is thrown can be tight. 2. Remove the key from the engine and loosen the plastic knob found...

524 WE Operator's Manual - Page 12

... skid shoes based on gravel or crushed rock surfaces. Adjust upward for hard-packed snow. Controls and Features Drive Control Chute Assembly Clean Out Tool Headlight † 4 ...Grips † Steering Trigger Control † Augers Skid Shoe † If Equipped Figure 4-1 Snow thrower controls and features are described below and illustrated in the right side of travel. Augers ...

524 WE Operator's Manual - Page 13

... Release both controls to do so will remain engaged. Failure to stop . CAUTION: Operate the snow thrower in increased wear on the rear of the dash panel to stop. Release to the OFF...with the drive control, the operator can operate the chute directional control without interrupting the snow throwing process. Drive Control / Auger Clutch Lock To activate the heated grips, move ...

524 WE Operator's Manual - Page 14

...control is located on the left side of the dash panel. • To change the direction in which snow is thrown, squeeze the button on the joy-stick and pivot the joy-stick to the right or to...the auger housing. 4. Shut off engine and remain behind the snow thrower), engage the auger control for a few seconds to clear any snow and ice which snow is thrown, squeeze the button on the joy-stick and ...

524 WE Operator's Manual - Page 17

... shift lever in the cable. 4. Figure 6-5 Figure 6-3 3. Apply a light coating of the snow thrower by removing the self-tapping screws which secure it rests on the shift cable index bracket. ... friction wheel. Doing so will hinder the snow thrower's drive Auger Control Refer to the hex 4. See Figure 6-5. Wipe off any oil on adjusting the skid shoes. Adjustments Shift Cable...

524 WE Operator's Manual - Page 18

... information on storing your engine. 18 Section 6 - See Figure 6-6. Off-Season Storage If the snow thrower will not be tight. Pull out the chute control rod until the hole in this hole...the drive cable or if the snow thrower's drive is released and in the disengaged "up with the second hole in an unventilated area, rustproof the machine using a light oil or silicone to the chute ...

524 WE Operator's Manual - Page 21

...and between the friction wheel disc and friction wheel. Friction Wheel Inspection (524 SWE, 526 SWE, 528 SWE & 530 SWE) If the snow thrower fails to drive with the drive control engaged, and performing the drive control... disc. 6. See your authorized service dealer to run until it is out of the snow thrower by removing the screw and bell washer which secure it rests on ordering a Service...

524 WE Operator's Manual - Page 24

... 954-04195 954-04201A Auger Drive Belt (524 WE & 524 SWE) Wheel Drive Belt (524 WE & 524 SWE) Auger Drive Belt (526 SWE, 528 SWE & 530 SWE) Wheel Drive Belt (526 SWE, 528 SWE & 530 SWE) 684-04159 684-04153 935-04054 925-1629 Friction Wheel Assembly (524 SWE, 526 SWE, 528 SWE, 530 SWE) Friction Wheel Assembly (524 WE) Friction Wheel Rubber (all models...

524 WE Operator's Manual - Page 28

...for rental expenses to obtain warranty coverage. CUB CADET LLC MANUFACTURER'S LIMITED WARRANTY FOR SNOW THROWERS The limited warranty set forth below is given by Cub Cadet LLC with respect ... or consequential loss or damage including, without limitation, expenses incurred for substitute or replacement lawn care services or for products sold or exported outside of the United States and/or ...