2006 Chevrolet Uplander Support Question
2006 Chevrolet Uplander Support Question
Find answers below for this question about 2006 Chevrolet Uplander.Need a 2006 Chevrolet Uplander manual? We have 1 online manual for this item!
Question posted by darlenedollyclark on July 7th, 2014
2006 Chevy Uplander
Van turns over but will not start??
Current Answers
Related Manual Pages
Owner's Manual - Page 1
2006 Chevrolet Uplander Owner Manual
Seats and Restraint Systems ...1-1 Front Seats ...1-2 Rear Seats ...1-6 Safety Belts ...1-21 Child Restraints ...1-40 Airbag System ...1-74 Restraint System Check ...1-89 Features and Controls ...2-1 Keys ...2-3 Doors and Locks ...2-10 Windows ...2-24 Theft-Deterrent Systems ...2-26 Starting and Operating Your Vehicle ...2-30 Mirrors ...2-41 OnStar® System...
Owner's Manual - Page 68
... move the seat as far back as the instructions say. 1. When the passenger sensing system has turned off the right front passenger's airbag or airbags, the off . If your child restraint is positioned ...to .
1-62 Your vehicle has a right front passenger's airbags. Be sure to RUN or START. Secure the child in this seat. General Motors recommends that rear-facing child restraints be using...
Owner's Manual - Page 70
...tether is available and check with your vehicle has this feature, the built-in child restraint is turned to the top tether anchor, disconnect it. The safety belt will be lit and stay lit ...key is located in the passenger-side position in the vehicle if one is attached to RUN or START. Built-In Child Restraint
WARNING! DEATH or SERIOUS INJURY can occur:
• Follow all applicable ...
Owner's Manual - Page 88
... See Passenger Airbag Status Indicator on page 3-35.
• Airbags are designed to RUN or START. See Vehicle Data Collection and Event Data Recorders on page 7-10.
• Let only quali...will not work on and off, will be visible during the system check. A new system will turn your airbag system. When the system check is equipped with a crash sensing and
diagnostic module which...
Owner's Manual - Page 101
... vehicle. If your vehicle has this section for more details on page 3-69 for more details.
/ (Remote Vehicle Start):
2-5 See Power Door Locks on page 2-11 for a vehicle equipped with your vehicle, the turn signal lamps may flash to lock your vehicle. See "FOB LOCK FEEDBACK" under DIC Vehicle Personalization (Uplevel...
Owner's Manual - Page 102
... the remote keyless entry transmitter, the turn signal lamps will open.
If the power sliding door has been locked using the manual door lock lever, you will have a van symbol on them. Do not try to... on page 2-16. When you use your remote keyless entry transmitter to unlock your vehicle the turn signal lamps will flash and the horn will have two buttons that have a button with ...
Owner's Manual - Page 104
An increased range of vehicles. If your vehicle has the remote vehicle start feature, the remote keyless entry transmitter will start.
/ (Remote Vehicle Start):
2-8 Press and release the transmitter's lock button, then immediately press and hold the remote vehicle start button until the vehicle's turn signal lamps flash, or for at the vehicle. 2. Aim the...
Owner's Manual - Page 105
... DIC Vehicle Personalization (Uplevel Only) on page 3-69.
• The vehicle's key is running, insert the key into the ignition switch and
turn off the engine after a remote start, and the engine is in the ignition. • The vehicle's hood, liftgate or doors are not closed. • The hazard warning flashers...
Owner's Manual - Page 118
..., or passenger switch. Once slightly opened, the liftgate will have to the activation position. 4. Repeat the procedure starting with Step 1. If the power sliding door overhead console switch is clear before opening it.
2-22
To reset ...Always check to be reset. Lamps in the tracks. Turn the ignition to travel to the fully open the liftgate without checking for service.
Owner's Manual - Page 125
...Turn the ignition off and try another ignition key.
PASS-Key® III is for learning additional keys only. Anyone
2-29 If the engine does not start and the security message comes on page 5-94. If the engine still does not start... theft deterrent system. It is using a trial-and-error method to start with the PASS-Key® III (Personalized Automotive Security System) theft-...
Owner's Manual - Page 126
... key to brake, or slow, the vehicle.
• Avoid making hard stops for the first 500 miles (805 km). After the engine has started, turn it . 2. It may not be serviced by the PASS-Key® III system at any one constant speed, fast or
slow, for the first ...
Owner's Manual - Page 127
... system will continue to work for driving. This is opened . When the engine starts, release the ignition key. If a door is the position for driving. A (LOCK): This is all the way in. Use the correct key and turn the key only with your vehicle needs service.
2-31 Make sure the key is...
Owner's Manual - Page 128
... of the way down as you turn your ignition key to PARK (P) or NEUTRAL (N). The idle speed will not start in START for longer than 15 seconds at a time will not start in your vehicle. Notice: Holding your key in START for a maximum of the key.
3. When the engine starts, let go down while you hold...
Owner's Manual - Page 129
...hood and unwrap the electrical cord. Your vehicle may have , and some other things. Before starting the engine, be damaged. How long should be parking your vehicle. Plug it away from ... outlet. This will be plugged in ? If the cord will get easier starting and better fuel economy during engine warm-up. Turn off the engine. 2. Plug the cord into a normal, grounded 110-volt...
Owner's Manual - Page 142
... Home Remote buttons. Firmly press and release the "Learn" or "Smart" button. Return to start Step 8. 8. The Universal Home Remote should activate when the Universal Home Remote button is attached .... 3. Simultaneously press and hold the programmed Universal Home Remote button for two seconds and then turns to the motor-head unit. 7. Some entry gates and garage door openers may vary by ...
Owner's Manual - Page 158
...turn, move the lever all when you release it. When the turn is burned out. If you . Turn Signal On Chime
If either turn signal is burned out, replace it off the signal and then turn it there until the arrow starts... return automatically. If you need to low beam, pull the turn signal/multifunction lever toward you signal a turn or a lane change the headlamps from you have a trailer ...
Owner's Manual - Page 159
... windshield, blocking your wipers had selected earlier.
8(Mist):
For a single wiping cycle, turn the band to the second solid band past the delay settings. Otherwise the washer fl...Speed): For high-speed wiping, turn the band further, to operate for a long or short delay between wipes. The closer to wash your washer until the wipers start. Windshield Washer
LQ (Windshield Washer...
Owner's Manual - Page 166
... to dim them.
3-16 When it is bright enough outside , the exterior lamps will turn off after starting the vehicle. During that delay, your front turn on the regular headlamp system when you leave the garage, it is off.
Turn the knob clockwise to brighten the lights and counterclockwise to . When it will not...
Owner's Manual - Page 183
... Canada). The new one can display how far you have driven since you see DIC Operation and Displays on .
If the driver's belt is turned to RUN or START, a chime will come on for several seconds. Your vehicle has a tamper-resistant odometer. Tachometer
The tachometer displays the engine speed in both miles...
Owner's Manual - Page 184
... more.
If the passenger's safety belt is in motion. If the airbag readiness light stays on when you start your vehicle serviced right away.
3-34 This light will come on when you start the vehicle or comes on after the key is an electrical problem.
See Passenger Sensing System on if there...
Similar Questions
Where Is The Ac Low Pressure Port On A 2006 Chevy Uplander Located
(Posted by jdstreng 9 years ago)
What Is Wrong When You Turn The Key To On Position In A 2006 Chevy Uplander And
the instrument lights do not come on
the instrument lights do not come on
(Posted by arjusA 10 years ago)
How To Find The Freeze Plugs On A 2006 Chevy Uplander
(Posted by Dhglenn 10 years ago)
Can I Get A Pass 3 Key Code To Start My Car W/o Taking To Dealership
I cannot start my 2006 chevy uplander. when i put key in it says key in ignition,the dic isnt workin...
I cannot start my 2006 chevy uplander. when i put key in it says key in ignition,the dic isnt workin...
(Posted by harryandclevetta 11 years ago)
Starting Problem.
2006 Chevy uplander 3.5 It was starting fine After body shop fix the front end damage its not sta...
2006 Chevy uplander 3.5 It was starting fine After body shop fix the front end damage its not sta...
(Posted by Basmach222 11 years ago)