Question posted by bmcampjr on November 16th, 2015
How Can I Get My Celestron Starsence Back To Factory Condition?
Used my SkySync GPS with my new StarSence AutoAlign and appeared to have changed the time and date settings to a point where the StarSence will not complete its alignment.I have tried to reset the handset back to factory condition through the menus but still shows bad dates and times and still locks up before completing alignment.How can I get my unit back to factory condition?
Current Answers
Answer #1: Posted by freginold on November 16th, 2015 12:16 PM
You can use the "Restore Defaults" option to get it back to factory default condition. See page 24 of the owner's manual for details.
Similar Questions
Adjusting The Ipd On 25x100 Binoculars
I sent a question to you yesterday but the reply details I picked up did not answer my question.I am...
I sent a question to you yesterday but the reply details I picked up did not answer my question.I am...
(Posted by ftickner 1 year ago)
Set Screws For Telescope
I am missing the thumb screws for the lens and for the 90 degree angle mirrors on our celestron omni...
I am missing the thumb screws for the lens and for the 90 degree angle mirrors on our celestron omni...
(Posted by jajostenik 1 year ago)
Does This Item Have A Mannual Or Instruction Sheet
Celestron sky sync gps module #93969 gps module cn16
Celestron sky sync gps module #93969 gps module cn16
(Posted by navee8or 7 years ago)
Battery Size
I have no manual and a brand new Anemometer Yellow. Today, I attempted to utilize my new Anemometer ...
I have no manual and a brand new Anemometer Yellow. Today, I attempted to utilize my new Anemometer ...
(Posted by valhurn 7 years ago)
Can You Use In Below O Degrees Tempeture
can you use the 127 e celestron telescope in below 0 degrees tempetures
can you use the 127 e celestron telescope in below 0 degrees tempetures
(Posted by rmyshy 8 years ago)