Brother International Simplicity SB700T Support Question
Brother International Simplicity SB700T Support Question
Find answers below for this question about Brother International Simplicity SB700T.Need a Brother International Simplicity SB700T manual? We have 1 online manual for this item!
Question posted by bb62 on May 14th, 2013
Usa Sewing Machine Usable In Europe
Can i use my brother sb700t in europe also, because of the different voltage ineurope? They have 230 Volt over there
Current Answers
Related Brother International Simplicity SB700T Manual Pages
Users Manual - English - Page 1
KNOWING YOUR SEWING MACHINE SEWING BASICS UTILITY STITCHES APPENDIX
Computerized Sewing Machine
Operation Manual
Please visit us at http://solutions.brother.com where you can get product support and answers to frequently asked questions (FAQs).
Users Manual - English - Page 2
.... To reduce the risk of burns, fire, electric shock, or injury to persons.
2 Always unplug the machine from the electrical outlet immediately after using the machine immediately and unplug the power cord. • When transporting the sewing machine, be careful not to carry it by its handle.
WARNING - IMPORTANT SAFETY INSTRUCTIONS
Please read these safety...
Users Manual - English - Page 3
... play with any air openings blocked. Special care is not a toy:
• Your close attention to the needle. Do not use outdoors.
7 For a longer service life:
• When storing this sewing machine was supplied in should never be kept out of the reach of
children or disposed of. 4 Always keep your work area...
Users Manual - English - Page 4
... safety. If the problem persists, please consult your authorized dealer to obtain the correct lead.
2 For additional product information, visit our web site at www.brother.com
SAVE THESE INSTRUCTIONS
This machine is intended for its intended use as marked on plug.
• Always replace the fuse cover.
Users Manual - English - Page 5
...5
The main parts ...5 Needle and presser foot section ...6 Operation buttons ...6 Operation panel ...7 Flat bed attachment ...7
ACCESSORIES ...8
Optional accessories ...8
USING YOUR SEWING MACHINE 9
Power supply precautions ...9 Power supply ...9 Foot controller ...10 Sewing speed controller (for models equipped with the start/stop button 10 Changing the needle stop position ...10
THREADING THE...
Users Manual - English - Page 7
... accessory compartment (pages 7 and 33)
i Operation buttons (page 6) The operation buttons differ depending on and off.
l Main power and sewing light switch (page 9) You can use as the lower thread.
r Handle Carry the sewing machine by its handle when transporting the machine.
5
h Flat bed attachment with two needles. m Jack/socket connector (page 9) Insert the plug on...
Users Manual - English - Page 8
... buttons differ depending on the fabric as the sewing takes place. For details, refer to "Sewing reinforcement...SEWING MACHINE
Needle and presser foot section
a Buttonhole lever Lower the buttonhole lever when sewing buttonholes and bar tacks.
Operation buttons
The operation buttons help you to sew reverse stitches.
Pressing the button twice sews one stitch. k Needle clamp screw Use...
Users Manual - English - Page 9
... are displayed here. press the "+" side to select a stitch and specify how the stitch will be used (2), the stitch length (mm) (3), and the stitch width (mm) (4) are not in a compartment... attachment. For details, refer to use. Slide the flat bed attachment to the left to be sewn. a LCD (liquid crystal display)
The number of the sewing machine, allows you wish to "Selecting stitching...
Users Manual - English - Page 10
... as optional accessories to carry out most sewing tasks.
No. Note
(For U.S.A. Part Name
9
Bobbin (4) (One is on this machine model HS-2000/SB700T.
● The screw of the presser foot holder is available through your machine.
1.
2.
3.
4.
5. only) ● Foot controller: Model T
This foot controller can be used on machine.)
10 Needle set
11 Twin needle...
Users Manual - English - Page 11
... in the following precautions concerning the power supply. USING YOUR SEWING MACHINE
Power supply precautions
1
Be sure to correctly operate the machine.
(For U.S.A. If the cord or plug is damaged, take the machine to your
authorized dealer for the power source. X The sewing lamp goes off when the
machine is in poor condition. ● Turn off the...
Users Manual - English - Page 12
...increase.
a Foot controller jack/socket
CAUTION
● When connecting the foot controller, be used to prevent the machine from accidentally being started.
Sewing speed controller (for models equipped with the start /stop position
Normally, the sewing machine is set using the sewing speed controller is stopped.
Changing the needle stop button cannot be sure to select the...
Users Manual - English - Page 13
... on c the bobbin from other bobbins may tangle on the sewing machine.
If you use bobbins (part code: SA156, SFB: XA5539-151) that comes with this pin.
Using other models, the machine will not work properly. Only use the bobbin that have been designed for this machine or bobbins of the bobbin. Pass the thread around the...
Users Manual - English - Page 14
... controller
12 Press the foot controller or press (start/ i stop button) (for models equipped with
the sewing speed controller).
Note
● If the sewing machine is to be used to start. If you do not cut the thread completely, and the bobbin is not a malfunction.
● The needle bar does not move when you...
Users Manual - English - Page 15
... controller back to wind the free end of the procedure in the bobbin winder seat.
Note
● If the sewing machine is to be used to start /stop button).
c
While holding the thread that wraps around the pre-tension disk (page 11).
1
Place the bobbin on the bobbin winder shaft b ...
Users Manual - English - Page 16
....
1
2
a Wound evenly b Wound poorly
● The bobbin was designed specifically for models equipped with this sewing machine.
Actual size
11.5 mm (7/16 inch)
This model
Other models
• Only use bobbins that were designed to be used , the machine will make a clicking sound; CAUTION
● Winding the bobbin improperly may cause the thread tension to...
Users Manual - English - Page 22
... smaller the thread number, the thicker the thread;
CAUTION
● Only use bent needles. Needle types and their uses
The sewing machine needle that you wish to sew. and the larger the needle number, the thicker the needle.
● Use the ball point needle when sewing on the fabric and thread thickness. Needle precautions
Be sure to...
Users Manual - English - Page 23
...the flat surface is even.
1 2
a Mark
b Needle position button
Turn off the sewing machine, otherwise injuries may be straight according to the instructions in the table on the wheel ...the machine is accidentally pressed and the machine starts sewing.
c
1
a Flat surface
a Presser foot lever
21 In addition, the stitching may be sure to turn off the sewing machine. Do not use a ...
Users Manual - English - Page 24
... of the needle toward the e rear of the sewing machine may fall off. a Needle stopper
22
KNOWING YOUR SEWING MACHINE
Hold the needle with your left hand, and then d use the screwdriver to tighten the needle
clamp screw by simply... when loosening or tightening the needle clamp screw, otherwise certain parts of the machine, insert the needle until it
touches the needle stopper.
Users Manual - English - Page 34
... encounter a seam that the needle passes through the hook-andloop fastener, replace the needle with a feature that keeps the presser foot level. Sewing hook-and-loop fastener
CAUTION
● Use only the ungummed hook-and-loop fastener which is too thick a to its normal position. If the needle does not pass through...
Users Manual - English - Page 58
...32)
0.2-5.0 (1/64-3/16)
No
Ye*s** Rev. *
Attaching zippers, basic
J 01 01 01 01 stitching, and sewing
- G
06
06
06
06
Overcasting on thin or medium weight fabrics
3.5 (1/8)
2.5-5.0 (3/32-3/16)
2.0 (1/16... break or the machine may be damaged.
● When using the twin needle, be sure to attach zigzag foot "J", otherwise the needle may break or the machine may be used are listed for...
Similar Questions
How To Use Brother Sewing Machine Xm3700
(Posted by gagebreth 10 years ago)
How To Use Brother Sewing Machine Model Sc9500
(Posted by rec2sta 10 years ago)
How To Use Brother Cs6000i Sewing Machine
(Posted by rejerem 10 years ago)
Where Should The Machine Be Set For Regular Stitching? Brothers Xl-5130
Where should the machine be set for regular stitches? Brothers XL-5130
Where should the machine be set for regular stitches? Brothers XL-5130
(Posted by cengle640 10 years ago)