Bosch WTMC3521UC Support Question
Bosch WTMC3521UC Support Question
Find answers below for this question about Bosch WTMC3521UC - Nexxt 500 Series Gas Dryer.Need a Bosch WTMC3521UC manual? We have 3 online manuals for this item!
Question posted by Anonymous-32602 on July 3rd, 2011
How Do You Turn On The Pilot On A Bosch Gas Dryer
The person who posted this question about this Bosch product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Bosch WTMC3521UC Manual Pages
Pedestal Installation Instructions - Page 3
... the left of the bolts until
all four are installing the pedestal on a new washer or dryer, proceed to tightening. 3. i Do not thread any of the unit. NOTICE
Damage to the... This aligns the bolt assembly so the bolt will thread correctly into place.
Step 2 below . For dryers go directly to pedestal installation. 2.
Figure 2
q Remove the four transportation bolt hole covers on the ...
Pedestal Installation Instructions - Page 5
... lifting it to an upright position (use the feet that are
included with the pedestal. For dryers go directly to the appliance and adjacent surfaces, all screws (see Figure 13). q Loosen all... appliance once the pedestal is required) (see Figure 10). Figure 9 4. Use the wrench to 1/2 turn (see Figure 11). Install the four new feet that originally came with the pedestal. The front two ...
Pedestal Installation Instructions - Page 6
...). q Store the transport bolts with all 4 transport
bolt assemblies (bolt, washer and bushings) by turning it lays on the floor to prevent the appliance from the back (see Figure 15). To level ... using a 1/2" (13 mm) socket wrench. q After leveling the unit from side to side, then turn with it is leveled. d CAUTION
To avoid risk of injuries -Take care when using the closed end of...
Pedestal Installation Instructions - Page 7
...foot with or service on each corner of the appliance to prevent the height adjustable feet from turning while tightening the lock nut. Correct
Incorrect
Figure 19 7. d CAUTION
Do not use ....keep it locks tightly against the pedestal. Replace the drawer by placing a small load of laundry in place by freely opening and closing the drawer. Ensure drawer slides are aligned correctly ...
Operating, Care, Installation (all languages) - Page 2
...
Panel 12
Summary of instructions 13
Safety information 14
Before switching on the dryer 14
Using the dryer 14
Protecting the dryer 14
Protection of the environment 14
Before using the dryer for the first time 14
Temporary disconnection of the dryer 14
Laundry 14
Identification of fabrics 14
Drying tips 15
Program selection 15 Automatic...
Operating, Care, Installation (all languages) - Page 3
... leaves our factory has undergone a thorough performance test and is in this warning.
The Bosch dryer offers the following standard features:
-
This indicates that damage may occur as a result of nonĆobservance of this warning. WARNING: For your gas supplier from
20 to 17.6 lbs (8 kg) load
- q Immediately call the fire department...
Operating, Care, Installation (all languages) - Page 4
...burning appliances shall be a T" handĆ le gas cock.
3.
B Always contact your dryer.
Do not use an extension cord or an adapter to connect the dryer to the electrical power supply.
21. Keep area... fire, clothes, cleaning rags, mop heads and the like materials. Items contaminated with all laundry chemicals and aids in the
front can ignite when heated.
11. Always check pockets and...
Operating, Care, Installation (all languages) - Page 5
....
in an environment with lockable doors
or in cupboards with dripping
water, - in alcoves. -
Note: This gas dryer has been UL and C-UL listed for natural or propane gas. To prevent children from shipping carton and packaging components. d
The dryer is delivered as to these installation instructions completely and carefully. Do not operate the...
Operating, Care, Installation (all languages) - Page 6
...gasĆpiping and venting will find the rating plate on the dryer (rating plate). the grounding system is installed in a garage, the dryer must be installed on this application.
- Install the dryer...
d
19.7" (500 mm)/ 143 lbs
angle
170-180°
(64 kg)
If installing the dryer in this side for the electric current. The dryer door is acceptable for the dryer. In the event...
Operating, Care, Installation (all languages) - Page 7
... system. d WARNING d
Never use ductwork longer than 4 inches in . at least once a year.
10. The Bosch dryer must be vented outdoors. Gas connection
d WARNING d
Explosion hazard!
W.C.
It is vented outdoors. Note: The dryer must be checked for gas leaks. DO NOT use a flexible stainless steel connector (Design certified by a qualified technician. licensed heating personnel...
Operating, Care, Installation (all languages) - Page 8
...to avoid leaks.
To determine maximum exhaust length, add one 90° turn inside the dryer. Your dryer will serve as an accumulation point for both rigid and flexible metal duct.... (488 cm)
Note: Side and bottom exhaust installations have a 90° turn to accumulate and affect dryer performance and dryer life.
FourĆinch (approx. 100 mm) diameter ducting should be used. DO...
Operating, Care, Installation (all languages) - Page 9
... dealer. sweaters) and shoes.
no .
See page 9 Exhaust Air Connection" for visible damage.
4.
Unpack the dryer.
2. Remove all four feet firmly on the dryer (see page 7).
7. Position the dryer near the installation location.
5. If required, have a propane gas dryer and need to convert it does wobble, the feet must be adjusted. i If space is very...
Operating, Care, Installation (all languages) - Page 10
... fault. Pull out the power supply plug
or turn off valve. 2. Screw the heightĆadjustable feet of the dryer into the housing to the power supply.
3. q Switch the dryer to
understand how your dryer operates. 5. Disconnect gas supply 5. Check list before using the dryer
1. Check that the dryer is empty. Look in the drum. 7. Conduct an...
Operating, Care, Installation (all languages) - Page 14
... the inside of explosion!
14
Switch off the dryer at home. Laundry
Identification of oil on a clothesĆline or by projecting components. rubberized) - Do not dry anything that has ever had anything that the gas type corresponds with specifications on the dryer
Install the dryer in explosion or fire. Do not use solvent detergent...
Operating, Care, Installation (all languages) - Page 15
... shrink when dried for customer service! In the "Air fluff/No heat" stage the dryer runs on the textiles. turn off the circuit breaker and call for the first time.
Place the laundry in the laundry. Do not use the "Very dry/Extra dry" program. Select the required drying program from the program table...
Operating, Care, Installation (all languages) - Page 16
... page 16). button for temperatureĆsensitive textiles.
Regular/Cottons" Automatic program
For laundry,
Bed linen, table linen, towels Bed linen and table linen, towels, TĆ...which corresponds to the desired program. For all textile types inclusive foam rubber (e.g. The dryer light turns on inside the drum. backed rugs), sheer nylon, polypropylene. Check lint filter. ...
Operating, Care, Installation (all languages) - Page 19
...the door with a damp cloth only. q Turn off the circuit breaker q Pull out power supply plug q Close the shutĆoff the dryer. q Vacuum and reconnect the duct. Do... the sensors (the two bars next to be cleaned before moving the dryer to prevent clogging. Program
selector to destroy the gas connection when cleaning the duct. A partially clogged exhaust can be dried thoroughly...
Operating, Care, Installation (all languages) - Page 20
... maximum length as described on page 19. Switch off valve is required:
1.
Spin laundry at all or not inserted correctly.
Program has been interrupted. Display may be rectified or... filter dirty.
Clean exhaust air duct. Switch off ". Change the light bulb
The dryer light turns on inside the drum when you can rectify the fault yourself by authorized technicians only....
Operating, Care, Installation (all languages) - Page 21
...is blinking after lint filter has been cleaned
Fault in your area and explain to your Bosch dryer and are not pleased with the service you are not satisfied. Lint filter LED is ...problem with your satisfaction, please let us know by unauthorized personnel may void the warranty. The Bosch dryers require no special care other than the care and cleaning noted above. The display shows ...
Operating, Care, Installation (all languages) - Page 22
... FADDEN AVENUE HUNTINGTON BEACH CA 92649. Exclusions
This warranty does not cover service calls or repairs to correct the installation of the clothes dryer, to provide instructions on Motor
Bosch will repair or replace, free of charge, any component part that 's use was in a manner other acts of God, or installation not...
Similar Questions
Bosch 500 Series Gas Dryer Wrinkle Block Will Not Run
(Posted by okrm 9 years ago)
Bosch Nexxt 500 Series Dryer Humming Wont Run
(Posted by camb1mindyn 9 years ago)
Bosch Nexxt 500 Series Dryer Wtmc3321us/06 How To Clean The Lint
(Posted by Vadddcatbro 9 years ago)
How To Remove Rear Panel On Bosch Nexxt 500 Series Dryer
(Posted by blackendri 10 years ago)
Bosch Nexxt 500 Series Dryer Won't Start
(Posted by Carldelt 10 years ago)