Bosch WFVC5440UC Support Question
Bosch WFVC5440UC Support Question
Find answers below for this question about Bosch WFVC5440UC - 500 Series AquaStop Washer.Need a Bosch WFVC5440UC manual? We have 1 online manual for this item!
Question posted by kierszenbaum on June 26th, 2010
Water Coming Into The Washer
If the water lines are well connected from the faucet to the washer and water flows through the hoses, why does the washer tell us that the water pressure is too low or no water is coming to the washer? The Cold/Warm setting are not working at all and the Hot setting stops when it reaches Rinsing and a F11/F12 message shows up.
Current Answers
Related Bosch WFVC5440UC Manual Pages
User Manual - Page 2
...drum optimizes performance to keep them all in the heat, allowing your laundry to reach the optimum temperature, which allow your laundry a complete, even clean. By selecting this innovative cycle, a thermostat-... So even if the Vision washer is the most out of every drop of the cycle by up to 170º F.
AquaStopt Hose The AquaStopt Hose stops water flow in the home without causing ...
User Manual - Page 3
... Issues
7
FactoryĆsupplied equipment
7
Useful tools
8
Dimensions
8
Installation area
8
Checklist for Installation 11
Removing the transport bolts 11
Water connection 12
Electrical connection 14
Leveling procedure 15
Transporting the Washer 16
OPERATING INSTRUCTION 17
Panel 17
Before Using For the First Time 18
Using For the First Time 18
First washing...
User Manual - Page 4
...is in your laundry using the washing machine.
2. An easy operation philosophy, a variety of this appliance a userĆfriendly assistant in full working condition. Low noise level ... injury or death when using the washing machine. Store all hot water faucets and let the water flow out of this warning. Your washer offers the following :
1. The illustrations may smoke or catch fire...
User Manual - Page 5
...). Check the fill hose connections on a regular basis to ensure that might encourage children to climb on the washer, to climb, lean or hang on shelves or in injury and/or damage.
37. b. To avoid floor damage and mold growth, do not push against the door when moving .
18. The water connections should only be...
User Manual - Page 7
... technician. Disposing of disposal. Also remove the washer door to prevent children from plastic wrap and folding cartons. Water supply hose for high efficiency and front loading washers.
- User manual
7
Please contribute to the safety information listed here, the local water and electricity supplier may have the appliance connected by disposing of accessory parts supplied with...
User Manual - Page 8
... lines, gas lines or hot water pipes. If possible, place the washing machine in , against the washer ...water connections 3. 4 shipping bolts
Useful tools
The following : q Screw a section of the appliances. Minimum height is installed. If installing the machine on a weak wood floor, consider the following tools are not suitable. The accessory parts bag contains: 1. Wrench for drain hose...
User Manual - Page 9
... is available as venting or water connection will add approximately 15 inches to the height of the appliances are to be mounted on top of the washer. Stacking Kits
There are designed...www.boschappliances.com
If mounting the washer on page 10. If the washer is to allow for the dryer venting system. Allow additional clearance for the laundry pair.
Height measurements shown in ...
User Manual - Page 11
...the cover towards the open washer door to reduce pressure on the pedestal prior to ... final location 15
level the washer as low as when moving ). Loosen ...come out properly.
7. Checklist for
Page
Installation
completely remove 4 transport bolt 11 assemblies and move the washer into place
connect the water supply lines and
12
drain pipe
connect the electrical power
14
slide the washer...
User Manual - Page 12
...-to-metal couplings (eg: connecting the Aquastopt hose to potentially diminish water flow. - Hose Extension
The Aquastopt hose may help dislodge any sand, dirt or residue. Periodic inspection and replacement of an unpressurized hotĆwater boiler. Observe the water pressure in . /2.44 m). The water pressure should always be sure the rubber washer is recommended. NOTICE
To prevent...
User Manual - Page 13
... technology, and does not protect against flood-type water leakage through the clothes washer. Attach the drain hose to the drain
hose connection on " for a replacement hose (see page 31).
2.
AquaStopt Hose
The AquaStopt hose is blocked. Do not allow the hose to extend more than 5 feet (152.4 cm) from coming out of the drain pipe during pump out.
position...
User Manual - Page 15
... place a large bowl nearly full of water on the center of the top of the washer as low to turn when tightening the locknut, the height of the washer on the corner of the washer. An alternate method is allowed to extend the washer leveling foot.
(figure above shows the washer leveling foot removed from the top...
User Manual - Page 16
... of the corner will be changed. 9. The washer should be tight against the bottom of the sleeve. Remove the supply and drainage
hoses. -
Preparing and inserting the transport bolt assemblies
...each washer leveling foot until the washer is observed, recheck the leveling and the position of the washer. Install the transport bolt
assemblies (see section below). Turn off the water. -...
User Manual - Page 17
... the door is open.
17
lit red: Program is lit red.
Delay Start button (500/DLX Series)
The Start time can be activated. off and selects the program.
ECOActionR: This option reduces...(program must be delayed in Pause" mode. Panel
Cycle selector Switches the machine on 300 Series washers)
Buttons for the washing
cycle. The indicator light of safety, child lock is active or program...
User Manual - Page 18
... coming loose during washing and causing appliance damage).
3. Make sure the washer door is displayed: q Open the door. Close the detergent dispenser drawer.
6. Turn the Cycle Selector to Off" to Regular/Cotton hot
8. Turn on and illuminate the display. When Remove laundry" is closed.
7. Set the cycle selector to turn the washer on the water faucet...
User Manual - Page 20
... softener will eventually become gray and stiff. Keep detergents and additives out of the reach of your front-loading washer. Soft water requires less detergent. -
Liquid detergent should only be dispensed early
- Filling laundry detergent and/or additives
q Open the detergent dispenser drawer. Overfilling can be sure the liquid insert is not cleaned...
User Manual - Page 21
...washer. Concentrated or thick fabric softener, conditioner and powder-bleach must be diluted with a little water before starting any spilled bleach. Use a moist paper towel to this compartment.
- Overfilling can cause the bleach to be automatically dispensed at the fill level marked as max" on the laundry to the laundry...Do not dye items of the washer's colored surfaces. DO NOT ...
User Manual - Page 22
... of laundry/Extra cycle
1200
Regular/Cotton
800
Permanent Press
600
Delicates
400
Wool/Handwash
600
Comforter
900
Quick Full
900
Quick Light
800
Jeans
1200
Cold Intensive
1200
XxtraSanitary R
1200
Baby Caret
1200
Drain & Spin
* 300 Series maximum spin speed is based in part on cycle selected, temperature and pressure of incoming water, water...
User Manual - Page 26
...any time. Display field: Remove laundry". q Close the faucets.
q Press the Start/Pause button....water level, water temperature or drum speed). q Add/remove the laundry. Laundry can add or reduce laundry as
long as the drum accelerates to higher spin speeds due to normal laundry imbalance. q Remove the laundry...the door.
During Washing
The washer drum system may remain locked until...
User Manual - Page 28
... of bleach in the machine, run through the washer every 3 months. However, if the appliance has to be run the machine as follows:
q Disconnect the hose from the back of the washing machine.
Cleaning the strainers at the water faucet
On both the hot and cold water faucet:
Cleaning Tips
It is recommended that a small amount...
User Manual - Page 30
... High Efficiency washer produce fewer suds and will include the letters HE" on the laundry. Always load the drum with several large and small items together.
Suds coming out of detergent and select the highest permissible temperature. The laundry was automatically prevented. Aquastop Hose safety feature activated. Load size too small. Clean the water inlet strainers...
Similar Questions
Stacking Kit For Bosch 27 Inch 300 Series Washer And Dryer Set
I am searching for the correct kit to stack my 27 inch Bosch WFVC4400uc/24 washer and my WTVC4300US/...
I am searching for the correct kit to stack my 27 inch Bosch WFVC4400uc/24 washer and my WTVC4300US/...
(Posted by stevendebbie22 3 years ago)
Bosch Vision 500 Series
error codes for bosch front loader 500 series p:01 D:06 can anybody tell me whats the problem transl...
error codes for bosch front loader 500 series p:01 D:06 can anybody tell me whats the problem transl...
(Posted by aday069 3 years ago)
How Do I Replace The Door Lock Of Bosch Vision 500 Series Washer?
I was trying to fix E13 based on the instructions provided. After cleaning the debris from the pump,...
I was trying to fix E13 based on the instructions provided. After cleaning the debris from the pump,...
(Posted by afrozezubair 11 years ago)
E13 Error On A Bosch 500 Series Front Load Washer
(Posted by Kelloggrk 11 years ago)
