American Standard Champion-4 Support Question
American Standard Champion-4 Support Question
Find answers below for this question about American Standard Champion-4 - 3180.016.165 Townsend Right Height.Need a American Standard Champion-4 manual? We have 2 online manuals for this item!
Question posted by oboyred on January 14th, 2012
The Water In My Champion 4 Is Running
How do I stop the water from running constantly in the toilet? If I push down on the valve, it stops. Apparently it isn't sealing completely.
Current Answers
Related American Standard Champion-4 Manual Pages
Installation Instructions - Page 1
... venting conditions, the flow from the Champion in a back-to local codes.
!
Close toilet supply valve and flush tank completely. Remove old mounting hardware, remove toilet and plug floor waste opening to -back...use of fine quality for over is installed! Towel or sponge remaining water from the other toilet. Remove closet bolts from base area. from flange and clean away ...
Installation Instructions - Page 2
... REPRESENTATIONS.
DO NOT REMOVE
INSTALL WAX SEAL Invert toilet on closet flange so bolts project through...TOILET ON FLANGE a. V b. ROUGHING-IN DIMENSIONS: Right Height™ Elongated Two Piece Toilet
FINISHED WALL
Right Height™ Round Front Two Piece Toilet
ROUGHING-IN DIMENSIONS: Normal Height Elongated Two Piece Toilet
FINISHED WALL
Normal Height Round Front Two Piece Toilet...
Installation Instructions - Page 3
...If necessary, cut bolt height to flanged tubing). SCREWDRIVER
DO NOT SPIN BOLTS INSIDE TANK WITH A SCREWDRIVER
8 INSTALL TOILET SEAT Install toilet seat in water leakage. Water supply tube or pipe must...seated on the water supply connection.
- 3 -
730529-100 Rev. Captive cone washers already included. Smooth off the bead of existing coupling nut may not seal completely on wax ring ...
Installation Instructions - Page 4
... off water supply and flush toilet to level indicated in tank by turning counter-clockwise. 5. NOTE: DO NOT ADD ANY FOREIGN MATERIALS TO THE SEALING SURFACE.
- 4 -
730529-100 Rev.
Remove thumbscrew by adjusting float cup. Remove piston top and gasket. 6. 9b
10
TOP
CRITICAL LEVEL MARK ("C.L.") MUST BE 1" ABOVE
OVERFLOW PIPE
FILL VALVE
ARM...
Installation Instructions - Page 5
... or sluggish flush
Toilet leaks Toilet does not shut off water supply. b. Flush valve chain too loose or disconnected. d. Review Step 9 of installation procedure. IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL OF TANK WATER IS SLOW after valve has been in tank. e.
Always use for some time, Fluidmaster Model 242 Replacement Seal may also...
Valve Replacement - Page 1
... tighten the tank mounting fasteners in a alternating manner.
Properly configured Champion4 Flushing System. Reconnect the water supply. Replace the tank lid. Place the tank on it's side, remove the coupling gasket ...re-fit the tank assembly to back edge of tank. AMERICAN STANDARD
COMPANIES
Champion4 Valve Replacement Instructions
r
Turn off and disconnect the supply line. Remove 2 inches ...
Similar Questions
My Champion 4 Flush Valve Is Leaking The Tank Fills And You Can Hear A Slite Lea
(Posted by richardplacette 9 years ago)
My Champion Toilet Doesn't Get Enough Water In Bowl To Flush Solids ?
What can I do to get more water into the bowl of my Champion toilet to cover the solids and flush th...
What can I do to get more water into the bowl of my Champion toilet to cover the solids and flush th...
(Posted by mike39911 9 years ago)
American Standard Champion 4 Toilet Valve Won't Stop Running
(Posted by langmom3 9 years ago)
Why Has Does This Toilet Not Flush Properly?
I purchased THREE of the same toilets and replaced one while it was still in warranty. All three toi...
I purchased THREE of the same toilets and replaced one while it was still in warranty. All three toi...
(Posted by throon2003 12 years ago)
My Champion Toilet Tank Runs. Can I Get Replacement Parts From You?
I think a need a valve for the white column.
I think a need a valve for the white column.
(Posted by christieeast 13 years ago)