Acer Altos G710 Support Question
Acer Altos G710 Support Question
Find answers below for this question about Acer Altos G710.Need a Acer Altos G710 manual? We have 2 online manuals for this item!
Question posted by pappusuri419 on August 20th, 2015
Need Onboard Scsi Drivers
i installing the OS server 2003 but need scsidrivers .
Current Answers
Answer #1: Posted by BusterDoogen on August 20th, 2015 6:05 AM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,397
Member since:
October 30th, 2011 Points: 28,565,397
Go here.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Acer Altos G710 Manual Pages
Altos G710 Service Guide - Page 11
... T Serial port T Parallel/printer port T Two LAN ports (RJ-45) T Power Supply T 550-watts redundant power supply (optional)
4
Chapter 1 T RAID on motherboard) is enabled, the onboard SCSI will not be available. Three 64-bit/100 MHz PCI-X bus slots 3. One 32-bit/33 MHz PCI bus slot T Serial ATA port T Two SATA...
Altos G710 Service Guide - Page 55
...specify settings that are related to the onboard controllers.
Parameter Onboard LAN1 Device Onboard LAN2 Device Onboard SCSI Device Onboard VGA Device
Description
Enables or disables the onboard LAN1 controller
Enables or disables the onboard LAN2 controller
Enables or disables the onboard SCSI controller
Enables or disables the onboard VGA controller
Enabled Disabled
Enabled Disabled
Enabled...
Altos G710 Service Guide - Page 74
... 8. Remove the four screws to detach the CD-ROM bracket.
5. Pull the Hard disk cage a little out from the chassis.
66
Altos G710 Disconnect the CD-ROM power cable and IDE cable. 3. Press the latches to release the Hard disk cage. 2.
Pull the entire HDD ... FDD unit. 2. Press the both side tabs to release the CD-ROM unit
4. Separate the FDD carrier from the SCSI backplane board. 4.
Altos G710 Service Guide - Page 79
... Error
A parity error occurred in onboard memory at an unknown address
NVRAM/...onboard memory.This error is incorrect. This error is followed by an address
On Board Parity Error
A parity error occurred in CMOS are not the same as last boot. ATAPI Incompatible
Corresponding drive is correct
CMOS Checksum Battery Low
The battery may be powered down and the jumper removed
71
Altos G710...
Altos G710 Service Guide - Page 91
... BIOS POST to an automatic configuration and configures all remaining PnP and PCI devices.
83
Altos G710 Function 1 initializes all PnP and PCI boot devices. Initialize different buses and perform the following...(function 3). Function 0 disables all onboard peripherals that include manual configured onboard peripherals, memory and I/O decode windows in PCI-PCI bridges, and ...
Altos G710 Service Guide - Page 99
BT1: BATTERY (CR -2032) coin type J15
Pin
Signal Name
1 P3V3_VBAT
2 GND
3 P3V3_VBAT
WAKE ON LAN CONNECTOR J31
Illustration
Pin 1 POWER 2 GND 3 WOL
Signal Name
SCSI BACKPLANE SENSE CONNECTOR JP12
Pin
Signal Name
1 SMB_DAT
2 GND
3 SMB_CLK
4 SCSI HDD FAIL GND
SCSI RAID I-BUTTON JP23
Pin
Signal Name
1 RAIDMODE_N
2 KEY_DATA
3 GND
91
Altos G710
Altos G710 Service Guide - Page 114
... SCSI 68pin, black color w/ Acer logo 20/40GB, DDS4, 5.25", internal, half-height, interface Ultra-Wide SCSI 68pin, black color w/ Acer logo 50/130GB, AIT-2 SDX-500V, 5.25", internal, interface Ultra-Wide SCSI 68pin, black color w/ Acer logo
35/91GB, AIT-1 SDX-420V, 5.25", internal, interface IDE UDMA66, black color w/ Acer logo
106
Altos G710
Altos G710 User's Guide - Page 8
... system fan
75
Installing an ePanel module (optional)
76
4 BIOS setup
79
BIOS setup
81
Entering BIOS setup
82
Main
84
System Information
86
Product Information
89
Advanced
90
Peripheral Configuration
91
IDE Configuration
93
Floppy Configuration
97
PCI/PnP Configuration
98
Boot Settings Configuration
99
Onboard Devices Configuration
102
Server Management Configuration...
Altos G710 User's Guide - Page 9
... configuration
133
136 136 137 139 140
Appendix B: Acer Altos G710 rack installation guide
Setting up the system rack System rack installation Vertical mounting hole pattern
Installing the system into the rack
Appendix C: SCSI RAID configuration
Configuring the SCSI/SCSI RAID HBA Using the SCSI HBA setup utility Using the SCSI RAID HBA setup utility Using the MegaRAID configuration utility...
Altos G710 User's Guide - Page 12
The Acer Altos G710 server is a powerful dualprocessor system loaded with a host of new and innovative features. The system offers a new standard for flexible productivity ideal for multimedia processing, intensive graphics applications, general business applications, email, web service, file clustering and print services.
Altos G710 User's Guide - Page 15
...) is enabled, the onboard SCSI controller will provide full hardware RAID functionality. Graphics interface • ATI® Rage XL chipset with 8 MB VRAM
Networking • Dual onboard Broadcom BCM5721 10/100/...
backup)
Note: When the ROMB (RAID on motherboard (optional) • Dual channel Ultra 320 SCSI channels • Supports RAID 0, 1, 5, 10 and 50 • Requires RAID-enabler (iButton...
Altos G710 User's Guide - Page 16
... • Serial port • Parallel/printer port • Two LAN ports (RJ-45)
Operating system and software • Microsoft® Windows® 2000 Server (SP4) • Microsoft® Windows® Server 2003 • Red Hat Enterprise Linux 3.0 • Novell® NetWare® 6.5 • SCO OpenServer™ 5.0.7 • SCO UnixWare® 7.1.4 • ASM (Acer...
Altos G710 User's Guide - Page 42
...supports Windows 2000, Windows Server 2003 and Red Hat Linux...OS CD is needed when you to conveniently install your system turned on, gently press the CD-ROM drive Stop/
Eject button. 3 When the disc tray slides open, insert the EasyBUILD System CD
with the EasyBUILD System CD. 32
2 System setup
Configuring the system OS
The Altos G710 comes with Acer EasyBUILDTM that allows you install the OS...
Altos G710 User's Guide - Page 44
...from Windows
To turn off the server.
For more information refer to "Appendix D: ePanel" on OK. ePanel runs only on Microsoft Windows 2000 and Windows Server 2003 platform.
(1) Use the Navigation key...be turned off all peripherals connected to your server. Quickly pressing the button may put the server in Safe Mode. Note: You must install related ePanel software before you cannot shut ...
Altos G710 User's Guide - Page 112
Onboard SCSI Device
Enables or disables the onboard SCSI controller.
Onboard LAN2 Enables or disables the onboard LAN2
Device
controller. Onboard VGA Enables or disables the onboard VGA
Device
controller.
Parameter
Description
Onboard LAN1 Enables or disables the onboard LAN1
Device
controller.
Option
Enabled Disabled
Enabled Disabled
Enabled Disabled
Auto Disabled 102
4 ...
Altos G710 User's Guide - Page 145
... with a SCSI RAID configuration utility. This utility lets you change the RAID configuration of the Altos G710. For details go to page 137. • ePanel
This utility allows you to spot errors or potential trouble spots in the network servers through a single management station. For details go to page 140. 135
Your Altos G710 server supports the...
Altos G710 User's Guide - Page 175
... Device Driver
ePanel Device Driver is necessary to install this driver to allow the system to a request and query for building and running otherwise the configuration program built into the ePanel allows you see at a glance the Altos G710 configuration information. 165
Overview
ePanel lets you configure the network settings, view general data about the server and...
Altos G710 User's Guide - Page 176
..., make sure you have a Microsoft Windows 2000 Server (SP4) or Windows Server 2003 OS running on how to complete installation. Click ePanel Driver for Windows Server 2003 or ePanel Driver for instructions on your OS.
The installation wizard will be initialized.
(5) Follow all onscreen instructions to install the ePanel Agent.
2 Install the Microsoft .Net Framework: If you are using...
Altos G710 User's Guide - Page 178
... ePanel folder.
(3) Select an agent compatible with your OS. Before you install the ASM Agent, be initialized.
(5) Follow all onscreen instructions to Settings then select Control Panel.
(2) In the Control Panel Window, double-click the Add/Remove Programs icon. Click ePanel Agent for Windows Server 2003 or ePanel Agent for Windows 2000.
(4) Click Setup...
Altos G710 User's Guide - Page 197
... (ASM) system requirements ASM Agent 136
Acer Server Manager (ASM) system requirements ASM Console 136 system setup 137 install ASM Agent 137 install ASM Console 137
Altos RAID-enabling key 67 installing 67
B
BIOS setup 81 Advanced 90 Boot Settings 99 Floppy 97 IDE 93 Onboard Devices 102 PCI/PnP 98 Peripheral 91 Remote Access 106...
Similar Questions
Not Powering On.
Dear sir,My Acer Alsto G710 server System has powering ON issue. Checked both Redundanat POwer Suppl...
Dear sir,My Acer Alsto G710 server System has powering ON issue. Checked both Redundanat POwer Suppl...
(Posted by souzanaveen 6 years ago)
Pls Send The Link For Altos G710 Scsi Drivers Urgently
we need to install the server os 2003 but dont have the scsi drivers ..pls send the link.
we need to install the server os 2003 but dont have the scsi drivers ..pls send the link.
(Posted by pappusuri419 8 years ago)
Looking For Delta 550w Redundant Power Supply For Acer G710 Ps0078989954400001eh
looking for Delta 550W redundant power supply for Acer G710 PS0078989954400001EH00. Pl. let me know ...
looking for Delta 550W redundant power supply for Acer G710 PS0078989954400001EH00. Pl. let me know ...
(Posted by skmalam 10 years ago)
32 Bit Raid Drivers For Server 2003 Os
I was wondering if there were any 32 bit RAID drivers for Server 2003 to be installed onthe ACERAT31...
I was wondering if there were any 32 bit RAID drivers for Server 2003 to be installed onthe ACERAT31...
(Posted by brendan97834 11 years ago)
Altos R310 Server Booting Issues
My Altos R310 Server is having booting issues. It is not displaying anything in the screen but the o...
My Altos R310 Server is having booting issues. It is not displaying anything in the screen but the o...
(Posted by theombedzi 11 years ago)