Yamaha TX-680RDS Support and Manuals
Get Help and Manuals for this Yamaha item
This item is in your list!
View All Support Options Below
Free Yamaha TX-680RDS manuals!
Problems with Yamaha TX-680RDS?
Ask a Question
Free Yamaha TX-680RDS manuals!
Problems with Yamaha TX-680RDS?
Ask a Question
Popular Yamaha TX-680RDS Manual Pages
Owner's Manual - Page 3
... the terminals in a safe place for advice on the plug; Choose the installation location for U.K. Special Instructions for the unit carefully. English
Thank you for selecting this manual carefully.
2. To assure proper
operation and the best possible performance, please read the "TROUBLESHOOTING" section of this unit for long periods of time
(ie., vacation, etc...
Owner's Manual - Page 4
...ANT
75Ω UNBAL.
75-ohm coaxial cable
75-ohm/300-ohm antenna adapter
EUROPE MODEL
Outdoor FM antenna
Indoor FM antenna (included)
AM loop antenna (included)
Ground Outdoor ...UNBAL.
75-ohm
75-ohm/300-ohm
coaxial cable antenna adapter
4
Ground Nevertheless, a properly installed outdoor antenna will probably provide sufficient signal
strength. q Both AM and FM indoor antennas are ...
Owner's Manual - Page 5
... cable is selected, make sure the antenna is nearly as good a signal conductor as feeder cable, particularly for FM antenna installation q To minimize automobile ignition noise, locate the antenna
as possible. model)
(Europe model)
2
1 3
Orient so that type of selecting and erecting an outdoor FM antenna.
Connecting the AM loop antenna
1
2 (U.K.
The antenna...
Owner's Manual - Page 6
TUNER
L R
Amplifier
Connection cord (included)
FM ANT
GND AM ANT
75Ω UNBAL.
Remote control sensor
...has a remote control sensor.
q Be sure that the connections from the left ("L") and right ("R") OUTPUT terminals are connected to install an outside long wire antenna.
CONNECTIONS TO THE AMPLIFIER
q Before making any connections, switch OFF the power to a good earth ...
Owner's Manual - Page 7
...Select the reception band (FM or AM) while watching the display. TUNING
4 For FM reception, set the MODE, BLEND and IF MODE
buttons as described on the following page.
Display information
...an FM stereo broadcast is then replaced by the station name. (However, if the PS data cannot be received within 5 seconds, "NO PS" flashes, and then it manually (MANUAL TUNING). FM/AM
FM
or
AM...
Owner's Manual - Page 8
...to a desired station manually. MANUAL TUNING
3
2
1 Follow steps 1 and 2 on the previous page.
2 TUNING MODE AUTO/MAN'L
STEREO
WIDE
0
50
100
"AUTO TUNING" goes off.
4
3 For FM reception, set to the monaural mode... (to improve FM reception signal quality
MODE button
Normally, press this mode, it is set the MODE, BLEND and IF
MODE buttons as desired.
4 Tune to reduce the noise...
Owner's Manual - Page 9
... preset station buttons. For using the preset station buttons.
Notes q A new setting can be stored.
3 2, 1 4, 2 (Preset station buttons)
To store stations
1 Tune to a desired station. (Refer to turn the power off from the display.
English
PRESET TUNING
MANUAL PRESET TUNING
This unit can store station frequencies (selected by tuning operation) by only...
Owner's Manual - Page 11
...* There may be a case that order.
11 English
AUTOMATIC PRESET TUNING
You can replace a preset station by another FM or AM station manually by simply following the procedure of the section "To store stations" on page 9. MEMORY... through all frequencies. By this function, this function, the settings of the MODE, BLEND and IF MODE buttons are stored along with strong signals sequentially.
Owner's Manual - Page 13
...stations. VARIED
Varied: Used for the same program station), PI (Program Identification), PS (Program Service station name), PTY (Program Type name), etc.
MOR M
M.O.R.: (Middle of light-entertainment ...including meteorological reports and forecasts, consumer affairs, medical help, etc. PS (Program Service station name) mode:
Displays the name of the RDS station now being received instead...
Owner's Manual - Page 14
... such a case, use the BLEND, IF MODE and/or MODE buttons to the PS mode.
If the RDS station does not employ the PTY data service, "NO PTY" flashes on the display. Do not press the FREQ/PS/PTY button
until the display is displayed. PS/PTY SEEK FREQ/PS PTY...
Owner's Manual - Page 17
..., "NO AF" flashes.
3 If desired, you are called .
17 AF
Whenever the AF button is no other than the AF button. All of RDS data service. The search is for the same program station) and PI (Program Identification) of the stored stations will be also cleared. When pressed after the last...
Owner's Manual - Page 18
It receives signals from a remote control transmitter provided with a YAMAHA amplifier. q If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.), it might cause the remote ...
Owner's Manual - Page 19
...is noisy.
Not tuned correctly.
The tuner has been unplugged for best reception. These... .
Set the TUNING MODE button to eliminate multipath interference. Adjust antenna placement to the manual tuning mode. Use the manual tuning mode. Set the... in your authorized YAMAHA dealer or service center for help somewhat but it for a long period. English
TROUBLESHOOTING
If the unit fails...
Owner's Manual - Page 20
... Suppression Ratio 55 dB Capture Ratio 1.5 dB Alternate Channel Selectivity (NARROW) [U.K. model 40 dB [Europe model 75 dB IF Response Ratio [U.K. model 1 kHz 52 dB [Europe model (40 kHz Dev 1 kHz 45 dB
Frequency Response [U.K. SPECIFICATIONS
FM SECTION
Tuning Range 87.5 to -Noise Ratio [U.K. model] 30 Hz to 13 kHz 0±0.5 dB 20 Hz to 15...
Yamaha TX-680RDS Reviews
Do you have an experience with the Yamaha TX-680RDS that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Yamaha yet.
Earn 750 points for your review!