Yamaha NS-IC400WH Support and Manuals
Get Help and Manuals for this Yamaha item
View All Support Options Below
Free Yamaha NS-IC400WH manuals!
Problems with Yamaha NS-IC400WH?
Ask a Question
Free Yamaha NS-IC400WH manuals!
Problems with Yamaha NS-IC400WH?
Ask a Question
Popular Yamaha NS-IC400WH Manual Pages
Owner's Manual - Page 2
...Yamaha service personnel
when any service is the owner's responsibility. To clean, wipe with a dry, soft cloth. • Secure placement or installation is needed. • Do not attempt to clean the speakers with chemical solvents as the screws may cause them to pull free. • Do not place the speakers... before setting up your NS-IC400 speakers.
• When mounting these speakers, be...
Owner's Manual - Page 3
... YOUR AMPLIFIER/RECEIVER 9 Connections ...9 How to connect 9 After connecting 10 PAINTING THE SPEAKER GRILLE 10 SPECIFICATIONS 10
PREPARATION
Optimum installation layout
NS-IC400
NS-IC400
Stereo For best stereo performance, install the left and right speakers at equal distance from the listening position. Each speaker should be separated by a distance of 1.8 - 3.0 m (6 - 10 ft).
2 En...
Owner's Manual - Page 4
... 60 additional centimeters (2 additional feet) apart per side. It can be easily installed into ceilings and walls with the speaker or near heat/moisture. Surround speakers should ideally be too small for left and right surround channels. NS-IC400
NS-IC400
Example Installation
Laundry room
Kitchen
Hallway
With the compact design, it can also fit into contact with little...
Owner's Manual - Page 5
English
NS-IC400 Speaker × 2
Speaker grille × 2
Cutout template × 1
Tools needed for the material of the mounting surface. PREPARATION
Unpacking After unpacking, check that the following tools. * Use an appropriate tool for installation
When installing the speakers to the ceiling, you will need to prepare the following items are contained. Pencil
Drill
Philips
screwdriver...
Owner's Manual - Page 6
...; Check to ensure that the area you are installing the speakers.
• Placing the speakers too close to the installation location.
If they are dented, the sound will be aware of the product weight (See specification page) and the sturdiness of any doubt, contact your NS-IC400 in-ceiling speakers, be distorted.
• Be aware of the material into...
Owner's Manual - Page 7
... a keyhole saw or cutting
tool, use
safety goggles for eye protection and be sure to observe all of the way around the template
with a pencil. English
INSTALLATION
How to install
This is the recommended installation procedure when the material of the installation location is plasterboard.
1 Position the cutout template where
you are installing the speaker.
2 Trace a line around...
Owner's Manual - Page 8
....
7 Connect the speaker cable to the
speaker.
• For detailed instructions, refer to page 9 "CONNECTING YOUR AMPLIFIER/ RECEIVER".
8 Place the speaker into the hole. CAUTION • When installing the speaker, do not
touch the drive unit directly. It will press the ceiling board and the speaker together to open in a ceiling.
9 Insert the speaker into the ceiling.
This may cause...
Owner's Manual - Page 9
... frame directly. Should you use a power screwdriver be certain to select a very low torque setting to prevent damage to the speaker or to keep the grille from falling. Tighten
INSTALLATION
Tighten screws until the mounting clamps sufficiently grip the ceiling.
Also, try to place an equal amount of the wallboard. • We recommend using...
Owner's Manual - Page 10
...• When connecting, also refer to the owner's manual of the amplifier/receiver with reversed polarity, the sound will be unnatural and lack bass. Connections
• Connect the push input terminals at the terminal.
-+
NS-IC400 (R)
-+
NS-IC400 (L)
-+
-+
Receiver or amplifier
R +-
If the speaker is connected with the speaker cables (not included).
• Connect each other...
Owner's Manual - Page 11
SPECIFICATIONS
Type
Driver
Full range
Frequency response
Impedance
Nominal Input
Maximum input
Sensitivity
Dimensions (with grille)
Weight (with grille)
NS-IC400 Full range open back type 10 cm (4") cone type 95 Hz to 40 kHz (-10dB) 8 ohms 30 W 90 W 85 dB / 2.83 V, 1 m φ150 × 86.5D mm (φ5-7/8" × 3-3/8"D) 0.8 kg (1.76 lbs)
* Specifications subject to...
Owner's Manual - Page 12
... its normal purpose or in workmanship or materials for parts or labour. Please backup any part(s) repaired, or replaced at the customer's expense.
2. Conditions
1. Yamaha may not be free from defects in accordance with Yamaha's instructions on our website (http://www.yamaha-hifi.com/ or http://www.yamaha-uk.com/ for repair. (3) Misuse, including but not limited to (a) failure to...
Yamaha NS-IC400WH Reviews
We have not received any reviews for Yamaha yet.