Whirlpool WET4024HW Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WET4024HW manuals!
Problems with Whirlpool WET4024HW?
Ask a Question
Free Whirlpool WET4024HW manuals!
Problems with Whirlpool WET4024HW?
Ask a Question
Whirlpool WET4024HW Videos
WET4024HW Whirlpool, Normal Cycle, No Clothes
Duration: 38:17
Total Views: 15,175
Duration: 38:17
Total Views: 15,175
WET4024HW Whirlpool, Heavy Duty Cycle, 8 Shirts
Duration: 52:21
Total Views: 9,642
Duration: 52:21
Total Views: 9,642
WET4024HW Whirlpool Heavy Duty Cycle 15 Shirts
Duration: 48:55
Total Views: 6,064
Duration: 48:55
Total Views: 6,064
Popular Whirlpool WET4024HW Manual Pages
Instrucciones de instalacion - Page 4
... Parts
Gather required tools and parts before starting installation. Front leveling feet with nuts (2) (27" models)
Front leveling legs (2) (24" models)
Rear leveling legs (2) (24" models)
Shipping strap (27" models) (Not in parts bag. Check that opens to 1" (25 mm) or hex-head socket wrench
1/4" nut driver (recommended)
Wire stripper
Flashlight
Bucket
Parts supplied:
NOTE: Remove parts...
Instrucciones de instalacion - Page 5
... beyond reach of the Washer/Dryer Use and Care Guide.
Mobile home installations require metal exhaust system hardware available for your Use and Care Guide. Parts needed: (Not supplied with washer/dryer) n Vent clamps n Vent elbows and ductwork
Inlet hoses with flat washers Check local codes, electrical supply and venting, and read "Electrical Requirements" and...
Instrucciones de instalacion - Page 6
... and Safety, Title 24, HUD Part 280) or the Canadian Manufactured Home Standard, CAN/CSA-Z240 MH. n A water heater set to deliver 120°F (49°C) water to improve performance and minimize noise and possible "washer walk." The washer/dryer must be installed or stored in low temperatures.
Additional Installation Requirements
This washer/dryer is...
Instrucciones de instalacion - Page 8
Dimensions/Clearances, 24" Models
Dimensions
Clearances
Front View
23 7/8" (606 mm)
Side Clearances (recommended/minimum)
70 3/4" (1797 mm)
Side View
1" (25 mm)
35 7/8" (911 mm)
20 1/2" (521 mm)
1"/0" (25 mm/0 ...
Instrucciones de instalacion - Page 11
... recommended that the electrical connection is equipped with Canadian Electrical Code, C22.1 - Electrical Requirements - Canada
It is your Use and Care Guide.
11 Connect to be sure that you use Power Supply Cord Replacement Part Number 9831317. latest edition and all local codes.
A copy of above codes standard may be obtained from: Canadian Standards Association, 178 Rexdale...
Instrucciones de instalacion - Page 12
... forward. Move each of the 2 rear legs in an up-down motion to the floor.
12 Remove Shipping Strap (27" models) 3. Cut shipping strap
CUT HERE
To avoid floor damage, set washer/dryer onto cardboard before moving across floor. Discard end with cotter pins. Move washer/dryer close to secure the drain...
Instrucciones de instalacion - Page 13
...wood block. Pull foam packing ring out of the washer. The latch under the dryer will support the weight of the washer/dryer about 4" (102 mm) with a wood block or similar...rear legs by hand into place. This packing material is level. Install Leveling Legs (27" models) Install Leveling Legs (24" models)
1. Prepare to install leveling feet
To protect the floor, use it when transporting your...
Instrucciones de instalacion - Page 26
...if accessible to clean) ■■Must be fully extended and supported in enclosed walls, ceilings, or floors. ■■The ...from entire length of a building.
Replace plastic or metal foil vents with rigid metal or flexible metal vents. Review "Vent System Chart" and, if... install in final dryer location.
■■Remove excess to seal all governing codes and ordinances. Do...
Instrucciones de instalacion - Page 27
... from whom you purchased your installation. Standard rear offset exhaust installation B. Dryer B. Elbow F. In Canada, call 1-866-698-2538, or visit us at www.whirlpool.com/accessories. white
W10186596 4-way vent kit - D A
Alternate installations for offset close clearances
Venting systems come in the kit to the manufacturer's instructions. Three close elbow
4396007RW Through...
Instrucciones de instalacion - Page 29
... keep the drain hose from damage due to the following instructions: IMPORTANT: To ensure proper installation, this procedure must be inside of the straight end of...installations only)
For floor drain installations, you will vary
Place hose into standpipe or lay on the side of the 24" model will need additional parts with separate directions. You may need to drain connector
(27" model...
Instrucciones de instalacion - Page 30
... under washer/dryer. Record hose installation or replacement dates for a few seconds through...models) or 3 (27" models) Phillips-head screws and one bumper (27" models only), located at the top of water hoses and vent. Complete hookup of the access panel. Repeat this step with cold water inlet valve (top valve). In most standard configurations, hoses will cross over each hose
3.
Set...
Instrucciones de instalacion - Page 31
.../dryer is the responsibility of the installer to install and secure the drain hose into the provided plumbing/drain in the parts package (24" models). If connecting to existing vent,...
Using a 4" (102 mm) clamp, connect vent to exhaust hood with shipping strap removed earlier (27" models) or plastic strap included in a manner that vent is clean. Move washer/dryer to nal location
44..545...
Instrucciones de instalacion - Page 32
... models)
Jam nut
Place level here
Place level here
With washer/dryer in its final location, place a level on feet until they are about 4" (102 mm) with a wood block or similar object that will support ...prong
outlet
If washer/dryer is not level, prop up or down as a guide to reduce excess noise and vibration.
1. On 27" models, use a 9/16" or 14 mm open -end or adjustable wrench to turn...
Instrucciones de instalacion - Page 33
... test the washer, measure 1/2 the normal recommended amount of /recycle all parts are set the dryer on the washer/dryer.
If there is still no heat, contact a qualified technician. See "Level Washer/Dryer." In Canada:
q Plug into a grounded outlet.
For direct wire installation, turn off the dryer and check the following :
• Controls are...
Specification Sheet - Page 1
... of Drying Cycles
Dimensions
Product Dimensions (H x W x D) Depth with product. For complete details, see Installation Instructions packed with Door Open 90° Maximum Vent Length Venting Direction
Reference Material
Install Guide Use & Care Guide Energy Guide Warranty
Washer Drum, Stainless Steel; Electric Stacked Laundry Center
WET4024H
White WET4024HW
Capacity
Washer Capacity...
Whirlpool WET4024HW Reviews
We have not received any reviews for Whirlpool yet.