Parts List
Page 1
Illustrated Parts Manual Model Number: TCP-210 PORTABLE WATER PUMP P/N 31629 Rev 000 Date 9-23-05 tanaka-usa.com Supplier To The Outdoor Power Equipment Industry ISM, Inc. • 1028 4th Street SW, Ste "B" • Auburn, WA 98001 • Phone: (253) 333-1200 • Fax: (253) 333-1212 custsvc@tanaka-ism.com
Illustrated Parts Manual Model Number: TCP-210 PORTABLE WATER PUMP P/N 31629 Rev 000 Date 9-23-05 tanaka-usa.com Supplier To The Outdoor Power Equipment Industry ISM, Inc. • 1028 4th Street SW, Ste "B" • Auburn, WA 98001 • Phone: (253) 333-1200 • Fax: (253) 333-1212 custsvc@tanaka-ism.com
Owner's Manual
Page 4
...touch tank cap or fill the fuel tank while the engine is cold. • Never start the machine without priming water. • Do not pump oil etc. CAUTION! TCP-25/210/381 Owner's Manual 2. The fuel should be used in the fuel mix. • Failure to mix oil with... in the pump. www.tanakapowerequipment.com 3 custsvc@tanaka-ism.com Indicates a strong possibility of severe personal injury or loss of them have become caught in well ventilated area. • Never carry the unit with fresh water. It will greatly reduce the pump efficiency, or no water is pumped at either...
...touch tank cap or fill the fuel tank while the engine is cold. • Never start the machine without priming water. • Do not pump oil etc. CAUTION! TCP-25/210/381 Owner's Manual 2. The fuel should be used in the fuel mix. • Failure to mix oil with... in the pump. www.tanakapowerequipment.com 3 custsvc@tanaka-ism.com Indicates a strong possibility of severe personal injury or loss of them have become caught in well ventilated area. • Never carry the unit with fresh water. It will greatly reduce the pump efficiency, or no water is pumped at either...
Owner's Manual
Page 5
.... • Mix (shake) the fuel-mix thoroughly before starting. www.tanakapowerequipment.com 4 custsvc@tanaka-ism.com An air leak at 50:1. • Never use branded 89 octane unleaded gasoline. • Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 25-50:1 (Gasoline...with fuel, so that tight connection is pumped at least 3 m (10 ft.) from entering the pump body, and causing possible damage to ensure that no water is made between the female unions, and the male pump stubs. Assembly Procedure TCP-25/210/381 Hose to pump connection. (Fig. 1-1) Care must be...
.... • Mix (shake) the fuel-mix thoroughly before starting. www.tanakapowerequipment.com 4 custsvc@tanaka-ism.com An air leak at 50:1. • Never use branded 89 octane unleaded gasoline. • Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 25-50:1 (Gasoline...with fuel, so that tight connection is pumped at least 3 m (10 ft.) from entering the pump body, and causing possible damage to ensure that no water is made between the female unions, and the male pump stubs. Assembly Procedure TCP-25/210/381 Hose to pump connection. (Fig. 1-1) Care must be...
Owner's Manual
Page 6
.... CAUTION! Set choke lever to approximately 1/2 throttle opening (2). 3. Running If water does not come out smoothly while using, stop the engine. This is flammable NOTE! www.tanakapowerequipment.com 5 custsvc@tanaka-ism.com TCP-25/210/381 Priming (Fig. 2-2) It is necessary to prime the pump before subjecting it to snap back. (Fig. 2-4) 4. Never start , return...
.... CAUTION! Set choke lever to approximately 1/2 throttle opening (2). 3. Running If water does not come out smoothly while using, stop the engine. This is flammable NOTE! www.tanakapowerequipment.com 5 custsvc@tanaka-ism.com TCP-25/210/381 Priming (Fig. 2-2) It is necessary to prime the pump before subjecting it to snap back. (Fig. 2-4) 4. Never start , return...
Owner's Manual
Page 7
... which may contain any type of contaminant, the pump should always be replaced after about 100 operation hours or earlier if the electrodes are badly eroded. TCP-25/210/381 Owner's Manual 5. Clean the air filter daily... parts. • Abnormal fuel consumption. If this machine was originally equipped with clean water prior to suppress ignition signals. Maintenance. Water pump (Fig. 3-1) All water in malfunction and starting difficulties. there is used for some areas, local law requires... NOTE! In some time cannot be replaced. www.tanakapowerequipment.com 6 custsvc@tanaka-ism.com
... which may contain any type of contaminant, the pump should always be replaced after about 100 operation hours or earlier if the electrodes are badly eroded. TCP-25/210/381 Owner's Manual 5. Clean the air filter daily... parts. • Abnormal fuel consumption. If this machine was originally equipped with clean water prior to suppress ignition signals. Maintenance. Water pump (Fig. 3-1) All water in malfunction and starting difficulties. there is used for some areas, local law requires... NOTE! In some time cannot be replaced. www.tanakapowerequipment.com 6 custsvc@tanaka-ism.com