Stihl HS 80 Support and Manuals
Get Help and Manuals for this Stihl item
Stihl HS 80 Videos
GoPro Hero3 Stihl HS 80 Hedge Trimmer
Duration: 4:05
Total Views: 87
Duration: 4:05
Total Views: 87
Motorcia teste do motor stihl hs 80
Duration: 2:18
Total Views: 136
Duration: 2:18
Total Views: 136
PALENJE MOTORKE SA BUSILICOM - STIHL HS 80
Duration: :47
Total Views: 811
Duration: :47
Total Views: 811
Free STIHL HS 80 24 in Hedge Trimmer
Duration: 3:42
Total Views: 5,252
Duration: 3:42
Total Views: 5,252
Popular Stihl HS 80 Manual Pages
Instruction Manual - Page 2
...22 Sharpening Instructions 22 Maintenance Chart 23 Parts and Controls 24 Specifications 26 Special Accessories 27 Maintenance and Repairs 27 STIHL Incorporated Federal and California Emission Control Warranty Statement 28
STIHl
HS 75, HS 80
English / USA
Allow only persons who understand this manual to Using this Manual 2 Safety Precautions 3 Using the Unit 10 Fuel 11 Fueling 12 Rear...
Instruction Manual - Page 4
Observe all STIHL hedge trimmers. If the cutting tool comes in this manual. Be sure that anyone using your hedge trimmer understands the information contained in contact with your body, it will cut you have different parts and controls. Different models may have any hedge trimmer may cause serious or fatal injury. the use of any condition that you are fatigued...
Instruction Manual - Page 6
... and help to the hedge trimmer.
366BA001 LÄ
HS 75, HS 80
5 If the carburetor setting is important in a vehicle, properly secure it to prevent turnover, fuel spillage and damage to protect your hedge trimmer in this respect.
The correct engine idle speed is correct, the cutter blades will be engaged when the cutter blades are recommended. The hedge trimmer may only be...
Instruction Manual - Page 7
... and in the tank to fuel a running . with the engine stopped! Service damaged cutter blades before starting work - Removal of your owner's manual).
!Warning! Always spray the cutter blades with STIHL resin solvent before starting, particularly the throttle trigger, throttle trigger interlock, stop switch, cutting tool and starting your hedge trimmer and check for fueling and move freely...
Instruction Manual - Page 9
... the cutter blades.
Follow the maintenance and repair instructions in a tree or any other than hedges and shrubs. Always work on for a short period after the throttle trigger is released (flywheel effect). Never use a hedge trimmer with one hand.
If you are working close to run on a ladder, in the appropriate section of this manual.
8
HS 75, HS 80
English...
Instruction Manual - Page 10
... has anticorrosive properties. This greatly reduces blade friction and the damaging effects of sap and dust particles.
!Warning
Do not operate your STIHL service shop only.
!Warning
Never repair damaged cutting attachments by STIHL. Remember that could ignite combustible fumes and cause a fire. Have such work performed at your hedge trimmer if the muffler is damaged, missing...
Instruction Manual - Page 11
... both sides of the cutting blade.
366BA024 KN
10
HS 75, HS 80 Keep cutting tool sharp. Keep spark plug and wire connection tight and clean.
Fit a new spark plug if the electrodes are badly pitted.
Cut both sides of the hedge first, then the top. Tighten all country-specific and local regulations and ordinances regarding...
Instruction Manual - Page 12
... reason STIHL recommends that state they can ) - The machine's fuel tank and the canister in air cooled two-cycle engines.
Do not use BIA or TCW rated (twostroke water cooled) mix oils or other mix oils that you swing the hedge trimmer horizontally.
HS 75, HS 80
11 Fuel with a lower octane rating may increase engine temperatures.
Swing the blade...
Instruction Manual - Page 17
Idling and part-load emissions are controlled by limiting the idle mixture.
: Check the cutting blades and clean if necessary (they must be clean, move freely and not be bent or warped).
: Check the air filter and clean it one turn counterclockwise (standard setting, L = 1).
16
HS 75, HS 80 English / USA
Motor Management
Adjusting the Carburetor
Exhaust emissions...
Instruction Manual - Page 19
Rectify problems which may result in trouble in the boot may create arcing that could ignite combustible fumes and cause a fire.
000BA002 KN 000BA036 TR
18
HS 75, HS 80 Fit a new spark plug... connector in operation. see "Specifications".
: Use only resistor type spark plugs of the spark plug. These factors cause deposits to start or runs poorly at part load. operating at idling speed...
Instruction Manual - Page 23
....
22
HS 75, HS 80 English / USA
Storing the Machine
Sharpening Instructions
For periods of children and other unauthorized persons. out of the reach of about 3 months or longer
: Drain and clean the fuel tank in a well ventilated area.
: Run engine until carburetor is also possible to have the cutting blades resharpened by your machine with grease. See "Specifications...
Instruction Manual - Page 24
... machine Control handle Air filter
Filter in fuel tank Fuel tank Carburetor Spark plug Cooling air intake
Spark arresting screen in muffler All accessible screws and nuts (not adjusting screws) Cutting blades
Gear lubrication
Visual inspection (conditon, leaks) Clean Check operation Clean Replace Check* Replace* Clean Check idle setting Readjust idle Readjust electrode gap Visual inspection...
Instruction Manual - Page 26
... for the right hand, located at front of the hedge trimmer.
6. Handle bar for starting by the cutting blades.
20. Muffler.
Front Handle. Spark Plug Boot. Connects the spark plug with the ignition wire.
3. Housing, which encloses the power unit.
9. Carburetor Adjustment Screws. Fuel Tank. Lever for the left hand at or toward the rear of...
Instruction Manual - Page 29
..., the part will be used in a reasonable amount of all applicable regulations. Also included may be completed in non-warranty maintenance or repairs, and shall not reduce the warranty obligations of two years.
28
HS 75, HS 80
Where a warrantable condition exists, STIHL Incorporated will be hoses, and connectors and other states, 1997 and later model year...
Instruction Manual - Page 30
... for the warranty period. HS 75, HS 80
29 Diagnosis
You, as the owner, shall not be charged for replacement as required maintenance will be performed either at STIHL Incorporated or at no cost to STIHL Incorporated specifications that part. Emission test may be warranted for required maintenance at any of the following:
: repair or replacement required because of misuse...
Stihl HS 80 Reviews
We have not received any reviews for Stihl yet.