Stihl FC 110 Support and Manuals
Get Help and Manuals for this Stihl item
View All Support Options Below
Free Stihl FC 110 manuals!
Problems with Stihl FC 110?
Ask a Question
Free Stihl FC 110 manuals!
Problems with Stihl FC 110?
Ask a Question
Popular Stihl FC 110 Manual Pages
Product Instruction Manual - Page 2
... this Manual 2 Safety Precautions 3 Working techniques 12 Mounting the Loop Handle 15 Adjusting the Throttle Cable 15 Fitting the Cutting Blade 16 4-MIX Engine 17 Fuel 17 Fueling 18 Starting / Stopping the Engine ........ 19 Operating Instructions 22 Cleaning the Air Filter 22 Motor Management 23 Adjusting the Carburetor 23 Spark Arresting Screen in USA
STIHl
FC 110
1
Careless...
Product Instruction Manual - Page 3
English / USA
Guide to Using this Manual
Pictograms
All the pictograms attached to the machine are shown and explained in this manual.
2
FC 110
As a result, engineering changes and improvements are supported by illustrations. Symbols in text
The individual steps or procedures described in this manual may contain item numbers that require your STIHL dealer. Note or hint on all...
Product Instruction Manual - Page 4
... all applicable local safety regulations, standards and ordinances.
!Warning!
THE OPERATOR! if you have different parts and controls. FC 110
3
See the appropriate section of your model edger. Do not operate an edger when you read the safety instructions periodically. Tiredness may result in use of control. It is in serious or fatal injury to stop the unit...
Product Instruction Manual - Page 6
... of injury to protect your hands with the specific STIHL edger models are authorized. Always turn off the engine and make sure the cutting attachment has stopped before putting an edger down.
THE USE OF THE EDGER
Transporting the edger
!Warning!
THE EDGER
For illustrations and definitions of head injuries.
Edger noise may , in a vehicle, properly secure it to...
Product Instruction Manual - Page 7
...to the idle position.
Always check your edger for proper condition and operation before starting your edger and check for leakage.
6
FC 110 Inspect for loose parts (nuts, screws, etc.) and for the... Instructions
Fuel your edger in the tank to reduce the risk of your owner's manual for tightness. In order to release slowly. Use extreme caution when handling gasoline or fuel mix. Replace...
Product Instruction Manual - Page 11
... adjustments or repairs.
10
FC 110
Grass, weeds, etc. If the edger vibrates abnormally, immediateley stop the engine, disconnect spark plug lead, inspect for the cause. A loose blade may shatter at regular intervals.
!Warning! Never use an edger with incorrect idle speed adjustment. Do not attach any part of trouble. The tool continues to a unit without proper installation of...
Product Instruction Manual - Page 12
... and repair instructions in the important safety precaution section of your STIHL service shop only.
Replace damaged or dull cutting tools immediately, even if they have only superficial cracks. In order to the cutting tool. Always stop the engine, disconnect the spark plug lead and make sure it immediately for leaks at your owner's manual. Use the specified spark plug...
Product Instruction Manual - Page 13
... and operate your edger at least every 50 operating hours and reset if necessary.
Tighten all types of children. Fit a new spark plug if the electrodes are easier to see that the risk of your STIHL Owner's Manual should be operated if the muffler is greater in your body.
245BA003 KN
12
FC 110 Remember that the...
Product Instruction Manual - Page 24
... Cable".
: Check the spark arresting screen (not installed in all countries) and clean or replace if necessary.
: Carefully screw both adjusting screws clockwise down onto their seats.
: Open high speed screw (H) 3/4 turn.
: Open low speed screw (L) 3/4 turn.
: Start and warm up the engine
: Adjust idle speed with a standard setting. FC 110
23
This setting provides an optimum...
Product Instruction Manual - Page 31
...and Replacing the Wear Guard".
* STIHL recommends a STIHL servicing dealer
* STIHL recommends a STIHL servicing dealer
30
FC 110 In such a case have the screw and wingnut replaced by your dealer
Gearbox wheel
Have a worn wheel replaced by your dealer*. : The end of children and other unauthorized persons.
1 2
Depth wheel
Have a worn wheel replaced by your dealer*. If the parts are...
Product Instruction Manual - Page 35
...
X
Air filter Pick up body in muffler
Clean or replace
All accessible screws and nuts (not adjusting screws)
Retighten
* see "Guide to Using this Manual" 1) STIHL recommends a STIHL servicing dealer
34
Before starting work After finishing work or daily After each refueling stop Weekly Monthly Yearly If faulty If damaged As required
X
X
X
X
X
X
X
X
X X
X X
X
X
X
X
X
FC 110
Product Instruction Manual - Page 40
... be accepted only if the repair has been performed by an authorized STIHL servicing dealer using original STIHL replacement parts. FC 110
English / USA 39
This symbol may be identified by the STlHL part number, the STIHl logo and, in this manual. Other repair work may appear alone on small parts. Maintenance and Repairs
Users of this unit should carry out only the maintenance...
Product Instruction Manual - Page 41
... of sale, to STIHL.
40
FC 110
Manufacturer's Warranty Coverage:
In the U.S., 1997 and later model year small off -road equipment engine owner, you have any emissionrelated part on the date the utility equipment engine is equivalent in non-warranty maintenance or repairs, and shall not reduce the warranty obligations of sale to a STIHL service center as soon as the carburetor...
Product Instruction Manual - Page 42
... cover any of the following list specifically defines the emission-related warranted parts:
Carburetor Choke (Cold start enrichment system) Intake manifold Air filter Spark plug Magneto or electronic ignition system (ignition module) Catalytic converter (if applicable) Fasteners
Where to make a claim for Warranty Service
Bring the product to the first scheduled replacement point for damages to...
Product Instruction Manual - Page 44
... that are not exempted by the Emission Warranty Parts List (see below) must be warranted for disallowing a warranty claim. If any warranty maintenance or repairs on emissions-related parts will be liable to service the subject engines.
6. FC 110
43 Any warranted part that is scheduled for damages to the owner.
STIHL Incorporated will not be interpreted as necessary...
Stihl FC 110 Reviews
We have not received any reviews for Stihl yet.