SanDisk SDSDB-32-201-80 - Industrial Grade Flash Memory Card Support and Manuals
Get Help and Manuals for this SanDisk item
This item is in your list!
View All Support Options Below
Free SanDisk SDSDB-32-201-80 manuals!
Problems with SanDisk SDSDB-32-201-80?
Ask a Question
Free SanDisk SDSDB-32-201-80 manuals!
Problems with SanDisk SDSDB-32-201-80?
Ask a Question
Popular SanDisk SDSDB-32-201-80 Manual Pages
Product Manual - Page 8
...field errors. • Copyrights Protection Mechanism-Complies with up to a host system.
1.2.
Product Models
The SD Card is available in the capacities shown in write protection features (permanent and temporary). • Card Detection (Insertion/Removal). • Application specific commands.
1-2
SanDisk Secure Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK CORPORATION...
Product Manual - Page 10
... found to the data in the SD Card Security Specification document from the card. The SD Card's soft error rate specification is much more complex in the card is written correctly because of its secured mode.
1-4
SanDisk Secure Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK CORPORATION This is similar to using retries on the...
Product Manual - Page 14
...59,776 28,800
Protected Area-The part of the ...
SanDisk Secure Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK ...Part Number
Block Size (Byte)
Data Area + Protected size Protected Area size
(Blocks)
(Blocks)
SDSDJ-1024
512
2,004,224
20,480
SDSDJ-512
512
1,001,104
10,240
SDSDJ-256
512
499,456
5,376
SDSDJ-128
512
248,640
2,624
SDSDJ-64
512
123,232
1,376
SDSDB-32...
Product Manual - Page 40
... Card command set is supported. The card command class register CCC defines which command classes are interpreted as a typical delay for the clock dependent part of TAAC and NSAC. Table 3-14 lists the supported card command classes; If not explicitly defined otherwise, all bit strings are supported by the host for SD Card Physical Specification Version...
Product Manual - Page 41
...set to be spread over more than one byte)
WRITE_BLK_MISALIGN-Defines if the data block to READ_BL_LEN. DSR Implementation Code Table
DSR_IMP
DSR Type
0
no DSR implemented
3-16
SanDisk Secure Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK...if the configurable driver stage is computed as well.
Supported Card Command Classes
CCC Bit 0 1
Supported Card Command ...
Product Manual - Page 44
...Support
SD_SECURITY
3
R [54:52]
Prot 2, Spec V1.01
2
DAT Bus widths supported
SD_BUS_WIDTHS
4
R [51:48]
1 & 4
5
Reserved
-
16
R [47:32]
0
0
Reserved for manufacturer usage -
32... Code...SanDisk Secure Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK CORPORATION
3-19
This register shall be set in the SD Card Physical Layer Specification. This bit can be set...
Product Manual - Page 45
... (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK CORPORATION
Table 3-26. SD Card Supported Bus Widths
SD_BUS_WIDTHS Supported Bus Widths
Bit 0
1 bit (DAT0)
Bit 1
Reserved
Bit 2
4 bit (DAT0-3)
Bit 3 [MSB]
Reserved
Since SD Card shall support at least the two bus modes 1bit or 4bit width then any SD Card shall set at least bits 0 and...
Product Manual - Page 46
... no error '1' = error
Set when a sequence or password error has
C
been detected in order to program a write-protected block.
E R X '0'= not protected '1'= Attempt to read . E R X '0'= no error '1'= error Internal card controller error
C
E R X '0'= no error '1'= error An error in Table 3-28. The SD Card status registers' structures are coded as follows:
Type: • E-Error bit...
Product Manual - Page 60
...means that while the card is busy servicing any one of the other cards), the...data stream contains the net payload data (and error correction bits if an off-card ECC is... the data contents on the card.
Parameter set commands are: set commands are not allowed while the card is...+x5+1
4-10
SanDisk Secure Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK CORPORATION The generator ...
Product Manual - Page 63
...supported in the SD Card as they were defined in the MultiMediaCard Specification...progress by setting the ...Manual, Rev. 1.9 © 2003 SANDISK CORPORATION
4-13 It is not write protected. The SD Card system is defined to be quite long, and the host may be protocol forward compatible to interpret the following command as an application specific command (ACMD). Application Specific...
Product Manual - Page 68
... bit of commands defined to the command code word.
4.8.2.
Command Format
(Command length ...SanDisk Secure Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK CORPORATION The supported Card Command Classes (CCC) are separated. Command Classes
The command set of the SD Card. Secure Digital (SD) Card Protocol Description
4.8.1. If they are listed in the card specific...
Product Manual - Page 83
... Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK CORPORATION
5-1 SPI Protocol Definition
5.1. The host starts every bus transaction by default. A data block may be used . • When the card encounters a data retrieval problem, it will not respond to the command. • An eight or 16-bit response structure is sent using the...
Product Manual - Page 87
... in the CSD. SanDisk Secure Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK CORPORATION
5-5 At this value is allowed to refrain from accessing cards that do not support its voltage range.
... CMD1) until the 'in-idle-state' bit in the card response indicates (by being set to 0) that the card has completed its initialization processes and is the responsibility of the...
Product Manual - Page 103
...support this wide range of the product. This is not set below the maximum specification... rise, fall, setup, hold, and other...SanDisk Secure Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK CORPORATION
A-1 Design considerations include how the end product handles timeout delays, bus type selection, block mode selection, and other SD Card and MultiMediaCard bus timing specifications...
Product Manual - Page 108
Ordering Information
To order SanDisk products directly from SanDisk, call 408-542-0595. Secure Digital Card
SDSDB-16 SDSDB-32 SDSDJ-64 SDSDJ-128 SDSDJ-256 SDSDJ-512 SDSDJ-1024
16 MB 32 MB 64 MB 128 MB 256 MB 512 MB 1024 MB
SanDisk Secure Digital (SD) Card Product Manual, Rev. 1.9 © 2003 SANDISK CORPORATION
B-1 Appendix B.
SanDisk SDSDB-32-201-80 Reviews
Do you have an experience with the SanDisk SDSDB-32-201-80 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for SanDisk yet.
Earn 750 points for your review!