Samsung DV350AGR Support and Manuals
Get Help and Manuals for this Samsung item
View All Support Options Below
Free Samsung DV350AGR manuals!
Problems with Samsung DV350AGR?
Ask a Question
Free Samsung DV350AGR manuals!
Problems with Samsung DV350AGR?
Ask a Question
Popular Samsung DV350AGR Manual Pages
(English) - Page 1
To receive more complete service, please register your product at
www.samsung.com/register
DV350-02821A_EN.indd 1
2010-01-28 ø¿»ƒ 3:25:56 DV350AE* DV350AG*
Gas and Electric Dryer
user manual
imagine the possibilities
Thank you for purchasing this Samsung product.
(English) - Page 2
... Jog Dial to be changed with heat. Stacking (MODEL NO: SK-5A/XAA)
Samsung's Washers and Dryers can dry extra-large loads. You can purchase an optional stacking kit from clothing that can be removed to 3.06 pounds of dampness and automatically set the drying time. capacity dryer circulates more important things in the following four (4) positions...
(English) - Page 3
...is your new Samsung Dryer.
Follow the information in this manual do not understand. This manual contains valuable information on your responsibility to the manufacturer's instructions and local codes. • Do not install a clothes dryer with clothes dryers. WHAT YOU NEED TO KNOW ABOUT SAFETY INSTRUCTIONS
Warnings and Important Safety Instructions in this manual to minimize the...
(English) - Page 4
... turn on the appliance. • Do not touch any electrical switch. • Do not use any part of the appliance unless specifically recommended in the user-repair instructions and you cannot reach your gas supplier, call your dryer from service, remove the door to the drying compartment to prevent children or animals from becoming trapped inside. They emit...
(English) - Page 7
...responsibility of poor setup, adjustment, and connection, it is required. EXHAUST SYSTEM - A POWER CORD for proper installation. 1. GAS LINES (if a gas dryer) must be rigid metal or flexible stiff-walled metal exhaust ducting. If there is a service call performed as a result of the installer.
Make sure you are responsible. 01 Installing your dryer
installing your dryer _7
2010-01...
(English) - Page 9
...dryer, and enough space behind for the exhaust system. These instructions should be less than 0.
Instructions are :
2" in the back. • The closet front must be maintained to the dryer. THE DRYER MUST NOT BE INSTALLED...the lint filter clean. LOCATION CONSIDERATIONS
The dryer should be located where there is no -heat setting should be installed in the same closet as noted on ...
(English) - Page 12
... connected to provide adequate electrical services for your dryer. Do not modify the plug provided with all local codes and ordinances. The plug must be run with the National Electrical Code, ANSI/NFPA No. 70-Latest Revision (for the electrical current. Latest Revisions and local codes and ordinances. B149 Installation Codes - Gas models
Your dryer has a cord with all wiring...
(English) - Page 13
... a new power supply cord kit, marked for 4 wire receptacle, NEMA type 14-30R.)
Electric models - electric model dryers.
Gas models - and Canada
A 120 volt, 60 Hz AC approved electrical service, with the power cord attached. Electric models - IMPORTANT:
When local codes allow, the dryer electrical supply may be retained at a minimum of120/240 volts, 30-ampere with three No...
(English) - Page 15
...side- Set your dryer or the SAMSUNG customer care center at 1-800-SAMSUNG (726-7864). INSTALLATION
Gather the required tools and parts before starting the installation. 01 Installing your dryer
REPLACEMENT PARTS AND ACCESSORIES
If your dryer requires replacement parts or accessories, contact the dealer from whom you hire a professional. Tools and Parts
Pliers
Cutting knife
Pipe wrench (gas...
(English) - Page 16
... at the back of the unit in place. Review Electrical Requirements section. U.S. MODELS:
IMPORTANT - models are tight. Use a 3/8" (1cm) deep well socket.
16_ Installing your dryer to the following instructions for tight installations: install a section of the duct sections must be used , the dryer frame cannot be taped. Remove the terminal block cover plate. Be sure they...
(English) - Page 18
...stiff-walled flexible metal vent material. Dryer is leveled and is sitting firmly on the floor. Gas models - Remove the center terminal block screw. 2. Insert ... 6. DV350AG*) The burner may not ignite initially due to the external ground conductor screw. 3. Neutral wire (white or center wire) 7. installing your dryer off .
18_ Installing your dryer's rear panel slot. ...
(English) - Page 20
...-28 ø¿»ƒ 3:26:18 Reinsert the black screw in the remaining holes.
20_ Installing your dryer
DOOR REVERSAL
1. Reinsert the screw (Step 4) on the opposite side of the door hinge.
6. Reattach the holder lever.
7. Remove the two screws on the Frame Front.
5. Place the door on the Frame Front.
9. Reattach...
(English) - Page 31
... your Dryer.
If the problem continues call 1-800-726-7864 (1-800-SAMSUNG)
DV350-02821A_EN.indd 31
Troubleshooting _31
2010-01-28 ø¿»ƒ 3:26:23
dF
Door is not closing properly
Call for service. ERROR DISPLAY
MEANING
SOLUTION
tS
Clogged Lint Screen
Vent is not communicating
Try restarting the cycle. For any codes not listed...
(English) - Page 35
... product or result in service problems; applications and uses for instructions, or fixing installation errors. product removal and reinstallation;
delivery and installation; incorrect electrical line voltage, fluctuations and surges; This limited warranty does not cover problems resulting from an authorized service center. SAMSUNG will repair, replace, or refund this product...
(English) - Page 36
...specific rights, and you . NOR SHALL RECOVERY OF ANY KIND AGAINST SAMSUNG BE GREATER IN AMOUNT THAN THE PURCHASE PRICE OF THE PRODUCT SOLD BY SAMSUNG AND CAUSING THE ALLEGED DAMAGE. warranty
EXCEPT AS SET...800-SAMSUNG(726-7864) www.samsung.com/us
36_ Warranty
DV350-02821A_EN.indd 36
2010-01-28 ø¿»ƒ 3:26:35
To obtain warranty service, please contact SAMSUNG at: SAMSUNG ...
Samsung DV350AGR Reviews
We have not received any reviews for Samsung yet.