User Manual
Page 1
Check if your IDE drive has Jumpers, if so make sure they are set to Master. (Note: Please refer to the drive manufacturer's website for more information regarding your specific hard drive model.): 2. Remove the panel: Figure A: Remove the screws, on the side without the fan, using the included screwdriver. Device Setup 3.5 Inch IDE Drive: 1. Sabrent EC-UEIS7 USB 2.0/ESATA TO 3.5″ IDE/SATA/SATA II ALUMINUM HARD DRIVE ENCLOSURE WITH COOLING FAN 1.
Check if your IDE drive has Jumpers, if so make sure they are set to Master. (Note: Please refer to the drive manufacturer's website for more information regarding your specific hard drive model.): 2. Remove the panel: Figure A: Remove the screws, on the side without the fan, using the included screwdriver. Device Setup 3.5 Inch IDE Drive: 1. Sabrent EC-UEIS7 USB 2.0/ESATA TO 3.5″ IDE/SATA/SATA II ALUMINUM HARD DRIVE ENCLOSURE WITH COOLING FAN 1.
User Manual
Page 4
Figure B: Figure C: 5. Insert the hard into the enclosure, as shown below: Figure A:
Figure B: Figure C: 5. Insert the hard into the enclosure, as shown below: Figure A:
User Manual
Page 5
Place the cover back on the enclosure. Figure B: 6. Screw it back in place: Figure A:
Place the cover back on the enclosure. Figure B: 6. Screw it back in place: Figure A:
User Manual
Page 7
Plug the hard drive directly into the port. Locate the SATA port on the enclosure. Figure A: Figure B: Figure C: 1.
Plug the hard drive directly into the port. Locate the SATA port on the enclosure. Figure A: Figure B: Figure C: 1.
User Manual
Page 8
Connect the USB cable into the USB port on the enclosure. 2. Figure A: Figure B: Place the cover back on the enclosure. Computer Setup 1. Screw it back in place: Figure A: 2.
Connect the USB cable into the USB port on the enclosure. 2. Figure A: Figure B: Place the cover back on the enclosure. Computer Setup 1. Screw it back in place: Figure A: 2.
User Manual
Page 9
Figure A: Connect the power cable into the E-Sata port if you require it. (Note: E-Sata connector may be a bit difficult to plug in, and may require a bit of force to properly connect) Figure A: Figure B: 2. Alternatively, connect the E-Sata cable into the power port on the enclosure.
Figure A: Connect the power cable into the E-Sata port if you require it. (Note: E-Sata connector may be a bit difficult to plug in, and may require a bit of force to properly connect) Figure A: Figure B: 2. Alternatively, connect the E-Sata cable into the power port on the enclosure.
User Manual
Page 15
... the disk from Dynamic to Basic, then format NTFS, and give it /will only allow a maximum usable amount of 2TB. http://sabrent.com/support/knowledgebase.php?article=58 3. This enclosure is likely that it work when plugged directly into your drive before doing this adapter. 1. If these settings do not work using...
... the disk from Dynamic to Basic, then format NTFS, and give it /will only allow a maximum usable amount of 2TB. http://sabrent.com/support/knowledgebase.php?article=58 3. This enclosure is likely that it work when plugged directly into your drive before doing this adapter. 1. If these settings do not work using...