RCA ANT800 - HDTV Antenna - Outdoor Support and Manuals
Get Help and Manuals for this RCA item
Most Recent RCA ANT800 Questions
What Is The Range Of Rca Ant800
(Posted by Goldijo 9 years ago)
My Rca Digital Antenna Isn't It Compatible With My Lg42cm565 Tv Isn't It ?
(Posted by harleydawg43 9 years ago)
How To Ground Rca Ant800
(Posted by deg1wojte 10 years ago)
I Do Not Receive Any Signal After Following Rca Installation Instructions
(Posted by rapids51 10 years ago)
Rca Ant 800
What is the difference between the RCAANT800 and the RCAANT800R antenna?
What is the difference between the RCAANT800 and the RCAANT800R antenna?
(Posted by Greg3962 10 years ago)
RCA ANT800 Videos
RCA ANT800 Flat Digital Amplified Indoor Outdoor Antenna
Duration: 6:22
Total Views: 12,774
Duration: 6:22
Total Views: 12,774
RCA flat omnidirectional HDTV antenna ANT1400 ANT450 ANT600 ANT650 ANT700 ANT750 ANT800
Duration: 1:26
Total Views: 693
Duration: 1:26
Total Views: 693
Popular RCA ANT800 Manual Pages
Owner/User Manual: ANT800 - Page 1
... broadcast towers (See illustration below) Visit www.antennaweb.org to see the locations of your local broadcast towers.
• The higher the elevation of the antenna, the better the reception performance will be. ENGLISH
ANT800 Outdoor Antenna
User's Guide
BEFORE YOU START!!!
Owner/User Manual: ANT800 - Page 2
... the best performance when mounted outdoors in a high location (such as a rooftop, eaves, siding, or rafters in mounting the antenna. The ANT800 can also be mounted:
• To a surface, such as on the roof or high up on a metal surface will seriously degrade reception quality. NOTES: Do not install the ANT800 on any metal surface...
Owner/User Manual: ANT800 - Page 3
... correctly for the direction you want to the surface. Mount the base to point the antenna. Using these screws, attach the
base to the surface as shown here.
4. Attach the...the illustration on next page...
3 Attach the antenna to the base. First, set the washer and nut in the antenna's mounting well.
Attach the arm to the arm. First, set the washer and nut in the mounting well...
Owner/User Manual: ANT800 - Page 4
... antenna's underside, next to complete installation.
4 Attach the screw covers.
7. Skip to the "Connecting to Your TV" section to the arm, there are two screws. Tighten all screws. You can rotate the antenna on the antenna itself. Loosen these screws.
6. Position and orient the antenna. Once you've found the orientation you can also adjust the antenna...
Owner/User Manual: ANT800 - Page 5
... page...
5 Position the ANT800 antenna as high as a guide. Attach the arm to the base.
continues on the mast.
Then tighten the clamps and wing nuts securely onto the mast.
4.
Slide the antenna clamp assembly over the other side of U-Bolt as shown
here. Insert each of the well. First, set the washer and nut...
Owner/User Manual: ANT800 - Page 6
... shown here.
6. Attach the screw covers.
8. Skip to the "Connecting to Your TV" section to the arm. 5. Attach the antenna to complete installation.
6 Loosen these screws.
7. Tighten all screws. First, set the washer and nut in the antenna's mounting well. Then position the arm over the other screw, washer, and nut. You can rotate the...
Owner/User Manual: ANT800 - Page 7
... to your television set. Important: This power adapter should seal the point where the cable enters your TV or converter box.... Plug it stays vertical or lays flat.
Run an RG6 coaxial cable from the antenna, connect the short coaxial cable built ...the RG6 coaxial cable to Your TV
ANT800
Coaxial Cable
Amplifier Insert
ANTENNA TV/STB
TV
1.
Note: If you should always be used ...
Owner/User Manual: ANT800 - Page 8
dated bill of sale), specification of defect(s), transportation prepaid, to the Company at the Company's option) without charge for parts and repair labor. The warranty does not extend to the elimination of nature, alteration, improper installation, mishandling, misuse, neglect, or accident. This Warranty does not apply to costs incurred for the Company any liability other...
RCA ANT800 Reviews
We have not received any reviews for RCA yet.