Pyle PLMRC300X2 Support and Manuals
Get Help and Manuals for this Pyle item
View All Support Options Below
Free Pyle PLMRC300X2 manuals!
Problems with Pyle PLMRC300X2?
Ask a Question
Free Pyle PLMRC300X2 manuals!
Problems with Pyle PLMRC300X2?
Ask a Question
Popular Pyle PLMRC300X2 Manual Pages
Instruction Manual - Page 2
... and then longer speaker cables. If necessary, a service center should be followed precisely. According to your car's construction the set have to use power cables which is better to be consulted. All connections for mounting and connecting the set can be made very carefully in uences.
INSTALLATION INSTRUCTIONS
Please choose a mounting place without any direct...
Instruction Manual - Page 3
...2 or 4 Ohms (4 to 8 Ohm when used as
bridged ampli er)
• Avoid installing the unit where:
• It would be subject to high temperatures, such as its optimum ...replacement, there may cause serious damage. PROTECTION CIRCUIT This ampli er is provided with a protection circuit which operates in
temperature inside the car, allow the unit to cool o before operation.
• When installing...
Instruction Manual - Page 4
... and connect it between the ground terminal (GND) of the ampli er and a metal part of the vehicle close to the "Auto-Antenna" lead from the car stereo which the .... Connecting the battery terminal lead to provide an adequate voltage source and minimize noise.
WIRING INSTRUCTIONS
POWER CONNECTION The battery terminal (BATT) must be connected directly to the positive terminal of ...
Instruction Manual - Page 6
BRIDGED MODE
POWER CONNECTION LEADS
NOTES ON THE POWER SUPPLY
• Connect the + 12V power input lead only after all other leads have been
connected.
• Be sure to connect the ground wire of the unit securely to a metal part of the car. • A lose connection may cause a malfunction of the ampli er. 6 www.PyleUSA.com
Instruction Manual - Page 7
OPERATION
After the ampli er has been installed and all connections have been made correctly. Now... in the power supply lead as close as possible to work well within a wide range of trouble. Tri-mode or 4 Ohm
speakers in the way that the leads to be connected to "Min...respectively must be made for each set
separately. • REM: The unit is turned on by applying + 12 Volts to "Min"....
Instruction Manual - Page 8
...terminal by using a screw. Thereafter fasten the cable end with a plug-in auto fuse protecting the set against fault conditions. B.
GND (-) = GROUND CONNECTION Connect the GND terminal to select your crossover ...cient (min 4mm"). Route the ground cables from the radio and all other equipment parts, like equalizer, active crossover network or other substance from the battery. When the ...
Instruction Manual - Page 9
...mixed up, unit wired out of trouble.
No Sound/Red LED Protection is lit The plus and minus wires of a new fuse! No Stereo Sound and Weak Bass Speaker cables (+) and (-) are not connected correctly. TROUBLESHOOTING
No Function The connection cable is... a 2 Ohm speaker in stereo mode, a 4 Ohm speaker in bridge mode or tri-mode and the set is not connected correctly (=terminaI + I2V/GND/REM).
Instruction Manual - Page 10
... is often interference caused by the generator (piping), ignition (cracking) or other car electronic parts. the remote cables are the following guidelines:
• Use only a screened audio cable ...contact resistance and bad loose contact, please solder the cable
ends or use of these problems can lay the circuit and ground cable together with the ignition point for earth being switched...
Instruction Manual - Page 11
Features: • 2-channel Audio Amp System • Weather Resistant Class D Compact Ampli er • IPX4 E ect • Integrated Power Wiring Harness • Perfect for Custom Installations & Applications • Ability to Connect & Stream Audio from External Devices • Speaker Wiring Connectivity • Soft Turn On/O • Overload & Power Protection Circuitry
What's in ...
Instruction Manual - Page 12
Phone: (1) 718-535-1800 Email: support@pyleusa.com Questions? Issues?
We are here to help!
Pyle PLMRC300X2 Reviews
We have not received any reviews for Pyle yet.