Poulan PR8527ESA Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PR8527ESA manuals!
Problems with Poulan PR8527ESA?
Ask a Question
Free Poulan PR8527ESA manuals!
Problems with Poulan PR8527ESA?
Ask a Question
Popular Poulan PR8527ESA Manual Pages
User Manual - Page 1
Failure to do so can result in U.S.A. Always Wear Eye Protection During Operation
189645 Rev. 1 04.08.04 MH/BY Printed in serious injury.
IMPORTANT MANUAL
Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PR8527ESA
SNOW THROWER
WARNING:
Read the Owner's Manual and follow all Warnings and Safety Instructions.
User Manual - Page 2
...installed...Replace fuel cap securely and wipe up , transporting, adjusting or making repairs. Check fuel supply before starting when setting... local inspection authorities.
• Read the operating and service instruction manual
• If snow thrower must be thrown
PREPARATION
&#...when operating in rotating parts. WARNING: Snow throwers have exposed rotating parts, which can cause severe...
User Manual - Page 3
...problem you to clear snow at too fast a rate.
• Never operate the machine at all moving parts have competent, well-trained technicians and the proper tools to give best possible dependability and performance.
PRODUCT SPECIFICATIONS...; Follow the instructions under rotating parts. age" sections of the snow discharge angle. Vibration is in any damage, and repair the damage before...
User Manual - Page 4
SAFETY RULES 2-3 PRODUCT SPECIFICATIONS 3 CUSTOMER RESPONSIBILITIES 3 WARRANTY 32 ASSEMBLY / PRE-OPERATION 5-7 OPERATION 8-13
MAINTENANCE 14-15 MAINTENANCE SCHEDULE 14 SERVICE AND ADJUSTMENTS 16-18 STORAGE 18 TROUBLESHOOTING 19 REPAIR PARTS 20-31
PARTS PACKED SEPARATELY IN CARTON
4
User Manual - Page 5
...parts left unassembled for assembly of your snow thrower, all accessible loose parts and parts boxes from carton and check carton thoroughly for additional loose parts. UPPER HANDLE
SPEED CONTROL ROD
PLASTIC TIE
HOW TO SET... to the skid plates.
INSTALL SPEED CONTROL ROD (See Figs. 1 and 2)
1. ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you...
User Manual - Page 10
...discharge chute position, press down- Keep the area of operation clear of any adjustments or repairs.
set the deflector higher to desired position and tighten knob securely. We recommend standard ...
TO CONTROL SNOW DISCHARGE (See Figs. 12 & 13)
WARNING: Snow throwers have exposed rotating parts, which snow is to be thrown is controlled by the position of the snow thrower. ward...
User Manual - Page 12
...Instructions for a few seconds, remove and read oil level.
Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw tight, wait for additional information. three-wire grounded system. To avoid engine problems, the fuel system should be reversed, providing additional service...then moving parts to bottom of 87 octane. For removal of this manual. After ...
User Manual - Page 13
... primer when starting . Disconnect the power cord from the receptacle first, then from the engine. If temperature is above steps or use .
At this manual.
• For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly.
• Keep engine clean and clear of...
User Manual - Page 14
... to malfunction and pose a risk of this manual.
NOTE: Use only Original Equipment Manufacturer (OEM) parts to service this snow thrower does not cover items that have been subjected to slow leaks, tire sealant may be purchased from the warranty, operator must maintain snow thrower as instructed in
Maintenance section
➀ Pivot points
➁...
User Manual - Page 15
... side wheel may be replaced by original equipment manufacturer (OEM) belts available from spark plug and place wire where it cannot come in the Service and Adjustments section of this manual). Remove drain plug and drain oil in a suitable container. Wipe off any dirt or trash. Be sure to install klick pin into proper...
User Manual - Page 16
...is engaged, check to see if one or both of this manual. Disengage all moving parts have completely stopped.
4. CAUTION: Do not substitute.
SHEAR BOLTS...replaced.
1. Remove the two (2) screws securing belt cover to spark plug.
To replace the capscrew/shear bolts:
16
FRAME
FIG. 19
SCREWS Remove safety ignition key.
3. Install 1/4-20 locknuts and tighten securely.
SERVICE...
User Manual - Page 17
... handles.
While your nearest dealer.Using other than OEM belts can cause personal injury or damage to relieve tension.
8. Belt must be replaced at the same time. ... assembly, it is inside belt keepers.
9. Install flat washer securing pulley to the ground.
6. INSTALL BELT COVER and two (2) screws. SERVICE AND ADJUSTMENTS
TO REPLACE BELTS (See Fig. 20)
The auger and...
User Manual - Page 18
STORAGE
Immediately prepare your local parts dealer.Tire sealant also prevents tire dry rot and corrosion.
SNOW THROWER
When snow thrower is still warm. ENGINE OIL
Drain oil (with engine warm) and replace with the engine governor, which allows condensation to a qualified service center. Be sure that does not retain moisture. Pull recoil...
User Manual - Page 19
... remains, contact a qualified service center. See "IF RECOIL STARTER HAS FROZEN" in OFF position.
2. Check / replace auger belt. 3. Fuel shut-off of swath. 3. Turn fuel shut-off of this manual. 7. Throwing too much snow. 3. TROUBLESHOOTING
See appropriate section in STOP position. 5. Check / replace drive belt. PROBLEM
CAUSE
CORRECTION
Does not start
1. Drain...
User Manual - Page 20
...dealer from date of purchase by the original consumer purchaser, we will repair or replace, at our option, without charge for parts or labor incurred in replacing parts, any product which has been subjected to alteration, misuse, abuse, improper assembly or installation... locale. Outdoor Products Customer Service Dept. 250 Bobby Jones ...in accordance with the instructions furnished. THIS WARRANTY ...
Poulan PR8527ESA Reviews
We have not received any reviews for Poulan yet.