Poulan PR5524ESLCT Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PR5524ESLCT manuals!
Problems with Poulan PR5524ESLCT?
Ask a Question
Free Poulan PR5524ESLCT manuals!
Problems with Poulan PR5524ESLCT?
Ask a Question
Most Recent Poulan PR5524ESLCT Questions
Gas Filler Cap
My gas filler cap is broken. Is there a dealer in Mississauga/Toronto who stocks them
My gas filler cap is broken. Is there a dealer in Mississauga/Toronto who stocks them
(Posted by davecairns 7 years ago)
Popular Poulan PR5524ESLCT Manual Pages
User Manual - Page 1
Failure to do so can result in U.S.A. IMPORTANT MANUAL
Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PR5524ESLCT
SNOW THROWER
WARNING:
Read the Owner's Manual and follow all Warnings and Safety Instructions. Always Wear Eye Protection During Operation
424704 10.28.08 TH Printed in serious injury.
User Manual - Page 2
...specifically recommended by the manufacturer for any repairs, adjustments or inspections. Disengage all units with electric drive motors or electric starting motors.
6. Do not operate the equipment without proper instruction...setting up spilled fuel.
(h) If fuel is for this unit. Do not put hands or feet near or under rotating parts...safety instructions could result in the manual(s) ...
User Manual - Page 3
...or cabs).
15.
To clear the chute:
1. TABLE OF CONTENTS
SAFETY RULES 2-3
MAINTENANCE 13-14
PRODUCT SPECIFICATIONS 3
SERVICE AND ADJUSTMENTS 15-17
CUSTOMER RESPONSIBILITIES 3
STORAGE 17
ASSEMBLY / PRE-OPERATION 4-7
TROUBLESHOOTING 18
OPERATION 8-12
REPAIR PARTS 20-37
MAINTENANCE SCHEDULE 13 3 WARRANTY BACK COVER Do not run .
16. Never operate the snow thrower...
User Manual - Page 4
...your new snow thrower.
HOW TO SET UP YOUR SNOW THROWER
TOOL BOX (See Fig. 8)
REMOVE SNOW THROWER FROM CARTON
A toolbox is
1. Remove all parts and hardware you attempt to lower handle...
(2) SPACERS (198638)
(2) LOCKNUTS 1/4-20
(73800400)
ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you assemble must be tightened securely. Reading the entire...
User Manual - Page 11
... can be reversed, providing additional service before storage of the housing, it...Instructions for additional information. ACTUAL LOCATION MAY VARY WITH ENGINE ON YOUR UNIT. Use fresh, clean, regular unleaded gasoline with gasoline. To avoid engine problems, the fuel system should be emptied before requiring replacement...parts to desired position. Do not mix oil with
a minimum of this manual...
User Manual - Page 13
... Manufacturer (OEM) parts to slow leaks, tire sealant may be purchased from the warranty, operator must maintain snow thrower as instructed in this manual. NOTE: To seal tire punctures and prevent flat tires due to service this unit.
Failure... CHART"). Check controls to be made periodically to see if you should replace the spark plug and check belts for loose fasteners.
3.
User Manual - Page 14
... the Service and Adjustments section of this manual.
9. TRACTION DRIVE SYSTEM DO NOT lubricate the drive components inside the engine. (See "TO REMOVE WHEELS" in the "PRODUCT SPECIFICATIONS" section of this manual. NOTE: The left side wheel may be replaced by original equipment manufacturer (OEM) belts available from snow thrower and engine.
6. Be sure to install...
User Manual - Page 15
...throttle control to see if one or both of this manual. Remove safety ignition key and disconnect spark plug wire from...turn when auger control lever is engaged, check to any service or adjustments:
1. Remove safety ignition key.
3. Disconnect ...Wait for all moving parts have sheared. Replace belt cover by installing cover and screws and
tighten securely. Replace safety
IMPELLER SHEAR ...
User Manual - Page 16
...manual.
4. See "INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD" in pulley groove and slide pulley on idler, install new traction drive belt around pulley.
16
FIG. 20 REMOVE DISCHARGE CHUTE - WARNING: As the last bolt is recommended that both the auger and traction drive belt be replaced... around and inside belt keeper.
16. SERVICE AND ADJUSTMENTS
TO REPLACE BELTS (See Fig. 20)
The auger...
User Manual - Page 17
... days or more.
Inspect moving parts for a period of this manual).
• Empty the fuel tank by starting the engine and letting it to form and will cause problems.
FUEL SYSTEM
• If possible, store your snow thrower to another. Remove spark plug. 2. Pour one season to a qualified service center. store it in the...
User Manual - Page 18
...4. PROBLEM
CAUSE...manual unless directed to an authorized service centre/department.
Loose parts or damaged augers or impeller.
1. Replace damaged parts...instructed in FULL position. 2. Choke is off of
adjustment or overhaul.
1. Tighten all fasteners. Check / replace drive belt. Drive belt is in the Operation section of pulley.
2. Check / reinstall auger belt. 2. Check / replace...
User Manual - Page 23
...NUT 5/16−18
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL NUMBER PR5524ESLCT (96192002501) AUGER HOUSING / IMPELLER ASSEMBLY
2
3
1
1 2
3 01.07.024-B
KEY NO.
1 2 3
PART NO.
420478 411939 179582
DESCRIPTION
PALIER, TARIÈRE BOUCHON VIS 5/16−18 X 1.00
3
4 2
4
KEY...
User Manual - Page 25
...damage your snow thrower and void your warranty.
25 MODEL NUMBER PR5524ESLCT (96192002501) CONTROL PANEL / CHUTE
2 2
*3
1 *6
KEY NO.
1 2 *3 *4 *5 *6
PART NO.
420337 17501010 420678 420677 420675 420674
*6
DESCRIPTION... FOR SERVICE PARTS ONLY.
inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. REPAIR PARTS SNOW THROWER - -
User Manual - Page 26
... and void your warranty.
26 MODEL NUMBER PR5524ESLCT (96192002501) HANDLES
5
1
6
8
5 8
6
2 39
7
8 49
7
KEY PART NO. NO.
DESCRIPTION
1
419800X479...PART NO.
419797X479 418313X479 150078 17000616
DESCRIPTION
LOWER HANDLE PIVOT SUPPORT WELDMENT SCREW 5/16−18 X .750 SCREW 3/8−16 X 1.00
3
4
4
01.05.004-B
4
NOTE: All component dimensions given in U.S. REPAIR PARTS...
User Manual - Page 37
..., INSTRUCTION DECAL, AUGER LEVER DECAL, TRACT/CLUTCH LEVER LH DECAL, SPEED CONTROL OWNER'S MANUAL, ENGLISH OWNER'S MANUAL, FRENCH
NOTE: All component dimensions given in U.S. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
37 inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL NUMBER PR5524ESLCT...
Poulan PR5524ESLCT Reviews
We have not received any reviews for Poulan yet.