Poulan PR20H42STD Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PR20H42STD manuals!
Problems with Poulan PR20H42STD?
Ask a Question
Free Poulan PR20H42STD manuals!
Problems with Poulan PR20H42STD?
Ask a Question
Popular Poulan PR20H42STD Manual Pages
User Manual - Page 1
ALWAYS WEAR EYE PROTECTION DURING OPERATION
180002 6.27.01 RD Printed in serious injury. IMPORTANT MANUAL
Do Not Throw Away
OWNER'S MANUAL
MODEL:
PR20H42STD
LAWN TRACTOR
WARNING:
Read this Owner's Manual and follow all Warnings and Safety Instructions.
Failure to do so can result in U.S.A.
User Manual - Page 7
... MUST BE REMOVED FROM THE MOWER (SEE FIG. 4).
TO SET UP YOUR MOWER FOR MULCHING
• Remove high performance blades and install mulcher blades, (see BLADE REMOVAL in neutral position.
• Turn ignition key to "OFF" position. Follow the appropriate instruction below to remove the tractor from the cardboard packing. TO ROLL TRACTOR OFF SKID (See Operation...
User Manual - Page 8
... with all belt keepers.
Check wiring. CHECK TIRE PRESSURE
The tires on your tractor, check to rest on back of this manual. PLEASE REVIEW THE FOLLOWING CHECKLIST:
All assembly instructions have been completed. No remaining loose parts in the Service and Adjustments section of this manual). • Store mulcher blades and mulcher plate in a safe place.
User Manual - Page 12
... lever to slowest setting. • Make all turns slowly.
the second to desired height. TO ADJUST GAUGE WHEELS (See Fig. 7)
Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the rear drawbar of tractor. • Raise attachment lift to highest position with attach- Install gauge wheel in...
User Manual - Page 14
...YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.
• Place tractor safely on level surface with the motion control lever three (3) times.
• Your tractor is running .
To ensure proper operation and performance, it is wet. Shutoff engine and set .
• Disengage transmission by selecting...
User Manual - Page 16
...8226; Check for Loose Fasteners
A Sharpen/Replace Mower Blades
C T
Lubrication Chart
0 Check ...Replace blades more often when operating in the Service and Adjustments section of this manual. maximum. Do not overtighten. Service more often when mowing in high ambient temperatures. 2 - To receive full value from the warranty, operator must maintain tractor as instructed in this manual...
User Manual - Page 17
... a cone balancer. (When using a cone balancer, follow the instructions supplied with trailing edge up towards deck as shown.
Lbs.
TIRES
• Maintain proper air pressure in all tires (See "PRODUCT SPECIFICATIONS" section of this manual).
• Keep tires free of this manual).
If your local parts dealer. TRAILING EDGE UP
BLADE
CENTER HOLE
MANDREL ASSEMBLY
LOCK...
User Manual - Page 19
... if the tractor is required. • With engine cool, remove filter and plug fuel line sec- MUFFLER
Inspect and replace corroded muffler and spark arrester (if equipped) as necessary.
of all times.
NOTE: Operating the engine with automotive type wax. Service air cleaner more often under extremely dusty, dirty conditions), remove the blower housing...
User Manual - Page 20
...
20 TO INSTALL MOWER (See Fig. 18)
• Raise attachment lift lever to its
lowest position. • Roll belt off engine pulley. • Remove small retainer spring, and lift clutch spring off
pulley bolt. • Remove large retainer spring, slide collar off and push
housing guide out of this manual).
TRACTOR
TO REMOVE MOWER (See Fig...
User Manual - Page 22
... belt is a belt installation guide decal on bottom side of left footrest. • Remove mower (See "TO REMOVE MOWER" in this
section of this section of the transaxle. IF FURTHER BRAKE ADJUSTMENT IS NECESSARY CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER/DEPARTMENT
FIG. 24
TO REPLACE MOTION DRIVE BELT (See Fig. 25)
Park the tractor on level surface...
User Manual - Page 26
... and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual). • Lubricate as shown in the Customer Responsibilities section of this manual). • After cleaning, leave cables disconnected and place cables where they cannot come in contact with gasoline in any enclosure. Inspect moving parts for storage...
User Manual - Page 28
...proper air pressure. 6. Worn/damaged mower drive belt. 3. Poor grass discharge
1. Blades improperly installed. 10.
Blown fuse.
1. Bulb(s) or lamp(s) burned out. 3. Travel speed too fast. 3. Wet grass. 4. Replace alternator. Obstruction in "disengaged" position. 2.
Remove obstruction. 2. TROUBLESHOOTING POINTS
PROBLEM
CAUSE
Engine continues to run...
User Manual - Page 43
...16 UNC x 1-3/4
- - 130794
Mandrel Assembly (Includes Key
Numbers 8-10,13-15, 31 and 33)
- - 172559
Replacement Mower, Complete
NOTE: All component dimensions given in U.S. NO. DESCRIPTION
1 165892X421 Mower Deck Assembly, 42"
2 72140506 Bolt
3 138017
Bracket Asm Fr. inches 1 inch = 25.4 mm
43
MODEL NUMBER PR20H42STD
MOWER DECK
KEY PART NO. REPAIR PARTS
TRACTOR - - NO.
User Manual - Page 45
... Arm Suspension Rear Retainer Spring Bearing Pvt Lift Nut Crownlock 3/8 - 24 Pointer Height Indicator Plug Hole Blk. 1.485/1.515 Dia. inches 1 inch = 25.4 mm
45 REPAIR PARTS
TRACTOR - - MODEL NUMBER PR20H42STD
MOWER LIFT
KEY PART NO. NO. Indicator Height STLT
NOTE: All component dimensions given in U.S.
User Manual - Page 48
... or under “lawn mowers” for the name of its authorized distributors and dealers; Description of your product differs from those described in this Manual, please contact your unit. If the operating characteristics or the appearance of part. FOR SERVICE OR REPLACEMENT PARTS:
1. Consult your dealer/place of your local local dealer for parts and service should be necessary...
Poulan PR20H42STD Reviews
We have not received any reviews for Poulan yet.