Poulan PP10527ESA Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PP10527ESA manuals!
Problems with Poulan PP10527ESA?
Ask a Question
Free Poulan PP10527ESA manuals!
Problems with Poulan PP10527ESA?
Ask a Question
Popular Poulan PP10527ESA Manual Pages
User Manual - Page 1
Always Wear Eye Protection During Operation
188047 Rev. 1 04.08.04 BY Printed in serious injury.
Failure to do so can result in U.S.A. IMPORTANT MANUAL
Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PP10527ESA
SNOW THROWER
WARNING:
Read the Owner's Manual and follow all Warnings and Safety Instructions.
User Manual - Page 2
... parts. instruction....repair to operate the equipment. Keep the area of operation clear of the fuel tankopening at all clutches before starting when setting...instructions could result in contact with local inspection authorities.
• Read the operating and service instruction manual... been installed in ...Replace fuel cap securely and wipe up , transporting, adjusting or making repairs...
User Manual - Page 3
... repair this manual. WARNING: Exhaust fumes are present such as roofs of the building. Allow the engine (motor) to be sure of your purchase of the snow discharge angle. CONGRATULATIONS on slopes. Disengage the auger/impeller, stop the engine (motor) and check immediately for an extended period.
• Maintain or replace safety and instruction...
User Manual - Page 4
SAFETY RULES 2-3 PRODUCT SPECIFICATIONS 3 CUSTOMER RESPONSIBILITIES 3 WARRANTY 32 ASSEMBLY / PRE-OPERATION 5-7 OPERATION 8-13
MAINTENANCE 14-15 MAINTENANCE SCHEDULE 14 SERVICE AND ADJUSTMENTS 16-18 STORAGE 18 TROUBLESHOOTING 19 REPAIR PARTS 20-31
PARTS PACKED SEPARATELY IN CARTON
4
User Manual - Page 5
... to the operating position and tighten handle knobs securely. ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you assemble must be used for additional loose parts. UPPER HANDLE
SPEED CONTROL ROD
PLASTIC TIE
HOW TO SET UP YOUR SNOW THROWER
TOOL BOX (See Fig. 10)
A toolbox is located on...
User Manual - Page 8
... FUTURE REFERENCE.
IGNITION KEY. Save this manual for future reference. These symbols may appear on your snow thrower to familiarize yourself with the product. DANGER OR WARNING
PRIMER
FORWARD
REVERSE
READ AND FOLLOW ALL SAFETY INFORMATION AND INSTRUCTIONS BEFORE USE OF THIS PRODUCT.
INSERT TO START
AND RUN, PULL OUT TO STOP...
User Manual - Page 12
... can be reversed, providing additional service before storage of tank fi...mark on each side of this manual. NOTE: It is uneven. ...problems, the fuel system should be emptied before requiring replacement.
OPERATION
TO ADJUST SKID PLATES (See Fig. 18)
NOTE: The wrench provided in your parts...Instructions for a few seconds, remove and read oil level. three-wire grounded system....
User Manual - Page 13
... snowstorm can blind you try to start . Use the drive speed control, NOT the throttle, to adjust speed.
• It is not necessary. At this manual.
• For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly.
• Keep engine clean and clear of...
User Manual - Page 14
... replace the spark plug and check belts for loose fasteners.
3.
BEFORE EACH USE
1. Check engine oil level.
2.
All adjustments in
Maintenance section
➀ Pivot points
➁ Engine oil
LUBRICATION
Keep your local parts dealer. TIRES
• Maintain proper air pressure in both tires (See "PRODUCT SPECIFICATIONS" section in this manual). Check controls to service...
User Manual - Page 15
... friction wheel and damage to the snow thrower. Install left side wheel may be replaced by original equipment manufacturer (OEM) belts available from snow thrower for checking level. Clean the outside of your nearest dealer.Using other than OEM belts can result in the Service and Adjustments section of your expected operating temperature.
Do...
User Manual - Page 16
... both of this manual. AUGER HUB
1/4-20 LOCKNUT
AUGER HUB AUGER SHAFT
FIG. 20
TO REMOVE BELT COVER (See Fig. 21) 1. Remove belt cover. • Replace belt cover by installing cover and screws...Should a foreign object or ice become lodged in STOP position.
2. Wait for all moving parts to any service or adjustments:
1. Connect spark plug wire to the auger shaft with plug. IMPELLER SHEAR...
User Manual - Page 17
...INSTALL ENGINE PULLEY - Install flat the same time. lbs.
Wipe up on your snow thrower are of this manual.
4. SEPARATE SNOW THROWER - With your assistant slowly raises handles to the unit could occur if the snow thrower should be replaced.
NOTE: It is removed, have your nearest dealer... the pulley (by a qualified service center. REMOVE BELT COVER - Place belt in...
User Manual - Page 18
...set for storage at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Replace if necessary.
Remove spark plug.
2.
Acidic gas can attract moisture which is still warm. IMPORTANT: When installing wheel, be dangerous and will cause problems... manual).
3. SNOW THROWER
When snow thrower is not adjustable. Inspect moving parts for your model ...
User Manual - Page 19
TROUBLESHOOTING
See appropriate section in manual unless directed to FAST position. 5.
Engine is worn. 3. Stale fuel. 11. Water in OFF position. 6. Replace spark plug. 10. Loss of
adjustment or overhaul.
1. Dirty or clogged muffler.
1. Carburetor is off valve to spark plug.
9.
Excessive vibration
1. Replace damaged parts. Check / replace drive belt. ...
User Manual - Page 20
...accordance with the instructions furnished.
This warranty... only to an authorized service dealer. Please refer to materials...replacing parts, any products used for rental or commercial purposes is limited to the original consumer purchaser that term as manufactured is requested by the original consumer purchaser, we will repair or replace, at our option, without charge for replacement...
Poulan PP10527ESA Reviews
We have not received any reviews for Poulan yet.