Panasonic MC-UL810 Support and Manuals
Get Help and Manuals for this Panasonic item
View All Support Options Below
Free Panasonic MC-UL810 manuals!
Problems with Panasonic MC-UL810?
Ask a Question
Free Panasonic MC-UL810 manuals!
Problems with Panasonic MC-UL810?
Ask a Question
Popular Panasonic MC-UL810 Manual Pages
MC-UL810 Owner's Manual (Multi-Language) - Page 2
... Cleaning ...28 Thermal Protector ...28 ROUTINE CARE OF VACUUM CLEANER 30 Cleaning Exterior and Tools ...30 Emptying Dust Bin ...32 Cleaning Pre-Filter ...36 Cleaning Primary Filter ...38 Removing Clogs...42 Replacing the Belt ...44 Replacing HEPA Exhaust Filter 46 Cleaning Agitator ...48 BEFORE REQUESTING SERVICE...50 NOTES ...53 WARRANTY ...54-56 WHAT TO DO WHEN...
MC-UL810 Owner's Manual (Multi-Language) - Page 4
... beyond its power cord length.
TO AVOID ACCIDENTS
• Except for important use . Read and understand all instructions.
WARNING CAUTION
WARNING statements are not followed.
DO NOT store vacuum cleaner outdoors. Replace worn or frayed power cord immediately.
The plug might be stored in a manner intended by the manufacturer. • Do not use...
MC-UL810 Owner's Manual (Multi-Language) - Page 7
... it to a Panasonic Service Center. 7. To unplug, grasp the plug, not the cord. 9. Do not use vacuum cleaner without dust bin and/or filters in place. 18. To reduce the risk of the vacuum cleaner is necessary when used by pulling on floor. 15. Turn off all instructions in this manual. IMPORTANT SAFETY INSTRUCTIONS
When using your...
MC-UL810 Owner's Manual (Multi-Language) - Page 14
...du tuyau Entrada de la manguera
Hose Tuyau Manguera
➂
Hose Holder Porte-tuyau Soporte de la manguera
➢ Place vacuum cleaner in the upright position.
➀ Attach the hose to the hose inlet, aligning locking tab with hose inlet hole...Turbine à air Turbina de aire
Attachment Storage
Clip Loquet Cerrojo
AIR TURBINE
➢ Set the bottom of the hose onto the hose holder.
MC-UL810 Owner's Manual (Multi-Language) - Page 16
TO OPERATE VACUUM CLEANER
CAUTION
Moving parts!
Crevice Tool Suceur plat Herramienta para hendiduras
➢ Press crevice tool firmly into vacuum cleaner. To reduce the risk of personal injury, DO NOT touch the brush when vacuum cleaner is rotating can cut, bruise or cause other injuries. Always unplug from electrical outlet before servicing.
Use caution when...
MC-UL810 Owner's Manual (Multi-Language) - Page 22
...until it locks. Parallel position
➢ This position is normally locked in this vacuum cleaner can be set to one of this position for normal cleaning. Upright position
➢ The handle...ón del mango
➢ The handle of three positions Upright, Normal or Parallel.
To set to the parallel position, Press the handle release pedal and lower the handle.
- 22 -...
MC-UL810 Owner's Manual (Multi-Language) - Page 24
...; Attach crevice tool or Air Turbine as needed.
- 24 - Using Tools
NOTE: Hold the handle to support the vacuum cleaner when using tools and disconnecting or attaching the hose. ➢ Disconnect the hose from the
vacuum cleaner. ➢ Pull the hose gently in the direction
of the arrow to disconnect. ➢ It may...
MC-UL810 Owner's Manual (Multi-Language) - Page 28
...protect the vacuum cleaner from the outlet to allow
the vacuum cleaner to cool and the thermal protector to see if the motor protector has reset.
- 28 -
FEATURES
Edge Cleaning
This model is ...stationary furniture. Also
check and replace any clogged filters and empty dust bin, if necessary. ➢ Wait approximately fifty (50) minutes and then plug the vacuum cleaner in order to prevent ...
MC-UL810 Owner's Manual (Multi-Language) - Page 30
... SERVICE section in this manual for years to do so could result in electrical shock or personal injury from vacuum cleaner suddenly starting. ROUTINE CARE OF VACUUM CLEANER
Performing the tasks in the following sections will keep your new Panasonic vacuum cleaner operating at peak performance levels and will ensure these tasks to help solve various problems...
MC-UL810 Owner's Manual (Multi-Language) - Page 44
... (part number MC-V380B) around motor shaft and agitator belt groove. See illustration for correct belt routing.
➢ Reinstall agitator back into nozzle by placing end caps into slots by carefully lifting out.
➢ Remove worn or broken belt.
➢ Clean agitator and the end caps. Side Latch Loquet latérale Pestillo laterale
Replacing Belt...
MC-UL810 Owner's Manual (Multi-Language) - Page 46
...
➢ Ensure foam edge of the filter is facing towards the vacuum cleaner when placing filter into filter compartment.
➢ Reinstall nozzle cover. (See REPLACING BELT, page 44)
* Filter cannot be cleaned and should be replaced at least once each year. Part Number: MC-V194H
- 46 -
Side Latch Loquet latérale Pestillo laterale
➢...
MC-UL810 Owner's Manual (Multi-Language) - Page 50
... fuse at wall outlet.
2. Replace belt. 2. PROBLEM
Vacuum Cleaner won't run. Tripped circuit breaker/blown fuse.
3. Hole in firmly, push on/off switch to on.
2. Belt installed incorrectly.
Empty dust bin. 2. Replace/fix belt. 7. Full or clogged dust bin. 2. Dirty filters.
1. Broken belt. 2. Air flow restricted
1. POSSIBLE SOLUTION
1. Replace agitator. 3.
Check for clogs...
MC-UL810 Owner's Manual (Multi-Language) - Page 54
... or cosmetic damage. Limited Warranty Limits And Exclusions This warranty ONLY COVERS failures due to repair, replace or refund will be made by anyone other than a Factory Service Center or other business or rental use such as is attributable to products purchased and serviced in Service: To find a service center please visit http://www.panasonic.com/help or call...
MC-UL810 Owner's Manual (Multi-Language) - Page 55
... examples, this product develops during or after the warranty period, you may contact your dealer or Service Center. PARTS AND SERVICE, WHICH ARE NOT COVERED BY THIS LIMITED WARRANTY, ARE YOUR RESPONSIBILITY. If the problem is not handled to your satisfaction, then write to : npcparts@us.panasonic.com You may also contact us directly at: 1-800-211...
MC-UL810 Owner's Manual (Multi-Language) - Page 56
... a new or a refurbished equivalent value product, or (c) refund your purchase price.
This list of or damage to be made by an authorized Panasonic dealer in Canada and purchased and used in the original packaging. LIMITED WARRANTY
EXCHANGE PROGRAM
Panasonic Canada Inc. warrants this warranty. The decision to repair, replace or refund will be free from the date of original...
Panasonic MC-UL810 Reviews
We have not received any reviews for Panasonic yet.