Panasonic EY7450 Support and Manuals
Get Help and Manuals for this Panasonic item
View All Support Options Below
Free Panasonic EY7450 manuals!
Problems with Panasonic EY7450?
Ask a Question
Free Panasonic EY7450 manuals!
Problems with Panasonic EY7450?
Ask a Question
Panasonic EY7450 Videos
[EN] Panasonic EY7450 Drill&Driver
Duration: :33
Total Views: 36
Duration: :33
Total Views: 36
[DE] Panasonic EY7450 AkkuBohrschrauber
Duration: :33
Total Views: 222
Duration: :33
Total Views: 222
[FR] Panasonic EY7450 Perceuse visseuse sans fil
Duration: :33
Total Views: 47
Duration: :33
Total Views: 47
[EN] Panasonic EY7450 Drill&Driver
Duration: :33
Total Views: 359
Duration: :33
Total Views: 359
Popular Panasonic EY7450 Manual Pages
EY7450 User Guide - Page 2
...(C)
(K) (L)
(N)
(O)
(M)
(D)
(H)
(J)
(I)
(G)
(F)
(E)
V
(E)
(P)
(A) Keyless drill chuck (B) Clutch handle (C) Speed selector switch
(D) Forward/Reverse lever
Mandrin porte-foret sans fil
Mandril ...de commande de vitesse
Disparador del control de velocided variable
(N) Support handle (O) Battery charger
Manche de support Chargeur de batterie
Mango de soporte Cargador de batería...
EY7450 User Guide - Page 3
...instructions Failure to follow all of normal temperature water is injected to drill...Definition of IP code
IP5X: Ingress ...parts. Damaged or entangled cords increase the risk of dust is earthed or grounded.
3) Do not expose power tools to drill... holes in soft concrete and similar materials in such conditions. LIMITED WARRANTY
The rating of IP56 qualifies this tool for the minimum impact...
EY7450 User Guide - Page 4
...the power tool before turning the power tool on invites accidents.
2) Recharge only with specifically designated battery packs. Any power tool that have the switch on .
If damaged, ...is in . Carrying power tools with these instructions to be repaired.
3) Disconnect the plug from the power source and/or the battery pack from moving parts. The correct power tool will reduce personal ...
EY7450 User Guide - Page 5
... When storing or carrying the tool, set the Forward/Reverse lever to the center... contact hidd en wiring. SPECIFIC SAFETY RULES
1) Wear ear protectors...instruction manual.
- 5 - If contact accidentally occurs, flush with the tool. Service
1) Have your power tool serviced by a qualified repair...
avoid contact. Stop using only identical replacement parts. 4) When battery pack is not in...
EY7450 User Guide - Page 6
...service or repair is properly wired and in the summer), which can lead to cause cancer, birth defects or other reproductive harm.
take it will not be stepped on (1) battery charger, (2) battery pack. take it has received a sharp blow, been dropped,
Important Safety Instructions
1) SAVE THESE INSTRUCTIONS This manual..., drilling, ... Panasonic...plug replace ...are
specifically ...
EY7450 User Guide - Page 7
....
• Panasonic is damaged, it on standard household electrical power only. WARNING:
• Do not use other than the dedicated charger to install the proper outlet... not incinerate the battery pack. Otherwise, the battery contacts could be replaced by a repair shop appointed by the manufacturer, because special purpose tools are designed for...Replace It with a keyless drill chuck.
1.
EY7450 User Guide - Page 8
... counterclockwise (viewed from the motor brush may be visible through the body vent holes on the back of the trigger. To remove the battery pack: Pull the button from the front), then remove the bit. The speed increases with the tool.
This does not indicate a problem with the amount of depression of...
EY7450 User Guide - Page 9
... operation of the 18 clutch settings or " " position (EY7450). After use, set the lever to one of the motor.
* See specifications for "MAXIMUM RECOMMENDED CAPACITIES".
Clutch Torque Setting
Adjust the torque to its... Rotation Switch Operation
LOW HIGH
1. Check the direction of screws and drilling. ing mode by rotating clutch handle.
- 9 - Speed Selection
Choose a low or high ...
EY7450 User Guide - Page 10
...motor). Use of controls or adjustments or performance of procedures other than the maximum torque of the driver (position on the sides of the body during use of LED light, always pull the power ... or its battery capacity.
The tool needs cool-off when the tool has not been used as a manual screwdriver (up vent holes on the clutch), for 5 minutes. This may cause damage to the unit....
EY7450 User Guide - Page 11
... (complete) discharging of lithium ion batteries shortens their service life dramatically.
The overheat warning lamp on the control...the operation time becomes extremely short after recharging, replace the battery pack with a new one hour ...warning lamp flashing, charge the battery pack immediately. The driver includes a battery protection feature designed to prevent excessive discharging...
EY7450 User Guide - Page 13
... a repair shop. Do not use a damp cloth, thinner, benzine, or other volatile solvents for wiping the unit. If you experience any dust or iron filings that the inside the tool.
VII. IX. APPENDIX
MAXIMUM RECOMMENDED CAPACITIES
Screw driving Drilling
Model Machine screw Wood screw Self-drilling screw For Wood For Metal For Masonry
EY7450
M8...
EY7450 User Guide - Page 14
...the interference by the party responsible for help. This device complies with part 15 of the FCC Rules.
If this equipment does cause harmful interference ...BATTERY CHARGER
Model Electrical rating
Charging time
EY0L81 See the rating plate on a circuit different from that to which can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may...
EY7450 User Guide - Page 48
PANASONIC CONSUMER ELECTRONICS COMPANY
One Panasonic Way, Secaucus, New Jersey 07094
EN, FR, ES EY981074501 2011.03
Printed in China
Panasonic EY7450 Reviews
We have not received any reviews for Panasonic yet.