NaceCare ETB1120 Support and Manuals
Get Help and Manuals for this NaceCare item
View All Support Options Below
Free NaceCare ETB1120 manuals!
Problems with NaceCare ETB1120?
Ask a Question
Free NaceCare ETB1120 manuals!
Problems with NaceCare ETB1120?
Ask a Question
Popular NaceCare ETB1120 Manual Pages
ETB1120 Owners Manual - Page 1
Lisez la notice avant d'utiliser la machine. Read instructions before using the machine.
Warning! Attention - www.nacecare.com Owner Instructions Mode d'emploi
ETB 1120
Original Instructions -
ETB1120 Owners Manual - Page 5
... system with brush deck secured in the event of a breakdown contact your Nacecare dealer or the Nacecare Technical help line +44 (0) 900 1 905 785 0038
5 Daily Keep...to determine which PPE should be required for any worn or damaged parts and replace immediately Drain and rinse dirty water tank after every use Store machine ... to use
Failure to rectify the problem or in tilted position Weekly -
ETB1120 Owners Manual - Page 6
... the power cord for damage, such as necessary, including the replacement of the operating triggers - DON'T • Leave the brush pad on the machine when not in use.
• Allow the machine to be stored outdoors in good condition.
CAUTION
Read the instruction manual before further use.
• Ensure that routine and preventative...
ETB1120 Owners Manual - Page 7
... mains plug is correctly assembled and operated in the instruction manual. The machine, while charging, must be affected....the batteries to guarantee the safety of the machine for the specific task being performed. A full range of safely and in...cleaning, servicing or maintaining the machine, replacing parts or converting to another function the power source shall be adequately instructed as to...
ETB1120 Owners Manual - Page 8
The ETB 1120 has a water capacity of all the packaging, carefully open and check the contents.
! If using the Flexi-Fill pipe fitted to enter...clean and free from debris.
8 After the removal of 11 gal
Note: Great care must be taken to the separator (Fig 6). !
1
Quick Set-Up Guide
PLEASE READ BEFORE COMMENCING ANY OPERATION. Fig 5
Fit the isolator key and switch the machine on (Fig 7).
ETB1120 Owners Manual - Page 9
...controls (see page 13)
Off-Aisle Cleaning Kit (Optional Extra Accessory) 606168
Failure to rectify the problem or in the deck locking pin (Fig 10) and rotate the brush deck into the operating position...Fit the Brush / Pad (Fig 9). Fig 9
Push in the event of a breakdown contact your Nacecare dealer or the Nacecare Technical help line +44 (0) 900 1 905 785 0038
9
Fig 10
Turn on the clean ...
ETB1120 Owners Manual - Page 10
... locking bar (Fig 16) and rotate the brush deck (Fig 17). ETB 1120 requires a 20'' brush or pad
Fit the brush /pad to the drive...(Ask your supplier for quick fitting, allowing easy squeegee blade replacement.
Raise the floor tool for transit or
lower for the ... up . The lifting strap is fitted first.
10 Before any settings can be applied, ensure the brush deck is easier to the ...
ETB1120 Owners Manual - Page 11
...Set-Up
Filling the clean-water tank
The ETB.... Important
Do not operate machine unless the Operator Manual has been read and fully understood.
! The ... of the clean water.
100%
Note.
Numatic part (629044) Wet Floor sign (available if required)... AND MIXING CHEMICALS. Pre-cleaning advice.
Follow chemical manufacturing guide lines. FILL pipe from a bucket or suitable container.
...
ETB1120 Owners Manual - Page 12
... with the floor-tool in the raised position, allow the chemical time to raise and lower the floor tool. Machine Operation
Pre-scrub mode
The ETB machine has been designed to reduce speed when cornering or when manoeuvring around obstacles. The waste water is dispersed via 'THRU-FEED' system. Ref to...
ETB1120 Owners Manual - Page 13
...way. Stage 2. Stage 2.
Brush overload.
Or move the transit wheels to 75% of brush. Setting the cleaning controls
To activate the machine from SLEEP MODE press either trigger once. When the machine ... for 10 seconds (this reduces the noise produced by the vacuum motor by 3dB.
The ETB has been fitted with a Hi - Brush and Vac Brush
When the triggers are released the...
ETB1120 Owners Manual - Page 14
... rear of the machine. The separator has a sealing-rubber which should only be examined at every clean-down and cleaning.
Regular Maintenance
! Clean by a competent service engineer (Fig 36). Excess water can be drained using emptying hose and flush out with clean water (fig 34) (Fig 35).
The...
ETB1120 Owners Manual - Page 15
... process. Retaining pins x 4
1
2 3
4
5
Note:
The blades are designed to be examined and checked for wear and damage. The floor-tool
The ETB range is provided with clean water and refit. Replacement is easy.
Blade carrier 4. Simply start by removing the four retaining pins (see Fig 38), turn the floor-tool over and...
ETB1120 Owners Manual - Page 16
... are available from top to the point that only one red light remains illuminated, the operator should either replace or charge the battery.
Battery Charge Level Indicator
To ensure your machine remains at its maximum efficiency and prolong your supplier.
16 If the battery-...
ETB1120 Owners Manual - Page 17
...Padloc Drive Board 20" Replacment Polyurethane Blade Set (optional)
17 Red Bottom Tank - PROBLEM
Machine will not operate Vacuum...and refit (page 14) Renew (contact service dept) Renew (contact service dept) Renew (contact service dept) Recharge batteries
Check and fit (...Replace fuse
Brush Motor 400W
Vac Motor 400W
Brush Sizes 20''
Pad sizes
20''
Weight 335 lbs
Protection Class
IPX4
ETB 1120...
NaceCare ETB1120 Reviews
We have not received any reviews for NaceCare yet.