Maytag MED5630M Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag MED5630M manuals!
Problems with Maytag MED5630M?
Ask a Question
Free Maytag MED5630M manuals!
Problems with Maytag MED5630M?
Ask a Question
Popular Maytag MED5630M Manual Pages
Installation Instructions - Page 3
... must be listed. I Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gas fitter qualified or licensed by a qualified installer, service agency, or the gas supplier.
In the State of Massachusetts, the following installation instructions apply: I A flexible gas connector, when used, must conform with local codes, or in serious injury, death...
Installation Instructions - Page 4
...■■ Vent clamps ■■ Vent elbows and vent work
Parts needed (steam models):
"Y" connector
2' (0.6 m) inlet hose
Caulking gun and compound (new vent installations)
Adjustable wrench that all models):
Tape measure
Pliers
Utility knife
Tin snips (new vent installations)
Leveling legs (4) Parts needed (not supplied with a pedestal or a stack kit. Tools needed for...
Installation Instructions - Page 5
... than 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. Check local codes. See "Electrical Requirements."
■■ Floor must not be required, depending on your local building inspector. Check existing electrical supply and venting. The wires that connect to bottom of dryer.
■■ The dryer must support dryer weight of 20...
Installation Instructions - Page 6
... Part Number 346764 is allowed for exhaust vent with a door, minimum ventilation openings in mobile homes to order. For further information, see "Assistance or Service" in your dealer. For mobile home installation of the dryer to fully open.
For further information, see "Assistance or Service" in garages, closets, mobile homes, or sleeping quarters. Some codes...
Installation Instructions - Page 9
...codes and gas supplier permit.
■■ If you are using natural gas, do so can be installed within six (6) ft. (1.8 m) of the dryer in the "Assistance or Service... manual shut-off valve. GAS SUPPLY LINE Option 1 (Recommended Method) Flexible stainless steel gas connector:
■■ If local codes ... service personnel. GAS TYPE Natural Gas: This dryer is located on the model/...
Installation Instructions - Page 10
...Screw in elevation. Stand the dryer up.
Slide the dryer on the pedestal model.
For a garage installation, the gas pipe height must be an additional 18" (460 mm) from ...into leg holes by hand - BURNER INPUT REQUIREMENTS Elevations above 2,000 ft. (610 m):
■■ When installed above 2,000 ft. (610 m) a 4% reduction of the burner Btu rating shown on cardboard.
2.
To ...
Installation Instructions - Page 17
Install a shut-off valve
1.
Failure to dryer
A. Connect gas supply to do so can result in supply line; A. Then, test all connections by brushing on threads of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service...Open shut-off valve.
MAKE GAS CONNECTION
(Gas models only)
WARNING
2. Examples of all gas connections....
Installation Instructions - Page 19
..." provide venting requirements that will help achieve best drying performance.
Plan Vent System
Recommended exhaust installation:
G
Special provisions for best drying performance: ■■ Use the following "Vent System...
H. Failure to follow these instructions can be securely fastened to exhaust out the right side, left side (all models except long vent), or through the bottom.
Installation Instructions - Page 20
A gas model would be DJAV - Connect vent to exhaust hood with 4" (102 mm) clamp. Avoid 90° turns.
ELE - Install Vent System
1. Secure vent to exhaust hood
Vent must fit over the exhaust hood. Install exhaust hood
Install exhaust hood and use caulking compound to the type code located on the serial number plate in the...
Installation Instructions - Page 21
...and replace with additional 2/3 turn .
NOTE: Replace inlet hoses after 5 years of use old hoses.
Attach washer cold inlet hose to the coupling can result.
Record hose installation or replacement dates... on connector.
21 CONNECT INLET HOSE (STEAM MODEL ONLY)
For non-steam models, skip to cold water faucet. Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or...
Installation Instructions - Page 23
...adjust legs up or down, and check again for certain part replacement or repair.
If dryer will not start, check the following:
• Controls are now installed. Be sure vent is not crushed or
kinked.
‰... the dryer does not rock. All Models:
‰‰Select a Timed Dry heated cycle and start of /recycle all parts are set in your Use and Care Guide. ‰‰If you have all...
Installation Instructions - Page 24
...before proceeding. Disconnect wiring. DOOR REVERSAL (OPTIONAL)
The following instructions are registered trademarks of Acument Intellectual Properties, LLC.
24 Using ... into opening.
†®TORX, T20, and T25 are for models with the two screws removed earlier, as shown. Replace all parts and panels before servicing.
Move the door strike
1.
Tools needed:
ALL DOORS:
2. Electrical...
Installation Instructions - Page 28
...
from dryer
3. Remove the four screws above and below the door strike and set aside. Lift off the inner door and set aside for later use. Rotate the strike 180° and attach to the outer... door. Place the door on each side of the dryer. Retain or set aside the four screws.
2. Move the door strike
Position the door with the inside of dryer door ...
Dimension Guide - Page 2
...
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in (maximum) mm (maximum)
A
Height (With feet)
381∕8
968
39
989
B
...only
A B
D E C
F 90º
Product Dimensions
in (minimum) mm (minimum) in your appliance's Owner's Manual, before installing and operating this appliance.
Dimension Guide - Page 4
...on all sides of the dryer is recommended to reduce noise transfer. Ƀ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are ...for the recommended spacing allowed.
Ƀ Additional spacing should also be required for ease of installation and servicing. Ƀ Additional clearances might be considered.
14" maximum (356 mm)
18" (460 mm...
Maytag MED5630M Reviews
We have not received any reviews for Maytag yet.