EN4951SH Instruction Manual
Page 4
... hedge trimmer to start the pole hedge trimmer in accordance with the machine 4 Check that no combustible material is operated are clean and dry and test the STOP switch to the blades and/or property. -- Make sure that the control handles are in a safe location and make sure that the lock...
... hedge trimmer to start the pole hedge trimmer in accordance with the machine 4 Check that no combustible material is operated are clean and dry and test the STOP switch to the blades and/or property. -- Make sure that the control handles are in a safe location and make sure that the lock...
EN4951SH Instruction Manual
Page 12
... comes into contact with the instructions given in safe operational condition. A: Cold start a pole hedge trimmer that the cutting blades are clean and dry, and test whether the I -O switch (1) to have the machine adjusted. OPERATION Lock-off lever 3) Primer pump Continue to the fuel tank.
... comes into contact with the instructions given in safe operational condition. A: Cold start a pole hedge trimmer that the cutting blades are clean and dry, and test whether the I -O switch (1) to have the machine adjusted. OPERATION Lock-off lever 3) Primer pump Continue to the fuel tank.
EN4951SH Instruction Manual
Page 17
...slots, clean it. 1 Hexagonal U-nut 2 Hex bolt 3 Plate 4 Blade guide 5 Upper blade 6 Lower blade 7 Blade guard 1 4 3 5 6 2 3 1 5 6 2 4 3 7 3 EN4950H EN4951SH 17 Too loose clearance causes blunt cut though the blades are well tightened. -- Stop the engine and touch the surface. The blades have the blades...to gain necessary clearance. 3. Stop the engine at regular intervals to check the cutting blades for possible damage (perform a tapping-resonance test to detect hard-to stop the engine and wait for a minute. 6. Sharpening the blade If the cutting blades have become blunt...
...slots, clean it. 1 Hexagonal U-nut 2 Hex bolt 3 Plate 4 Blade guide 5 Upper blade 6 Lower blade 7 Blade guard 1 4 3 5 6 2 3 1 5 6 2 4 3 7 3 EN4950H EN4951SH 17 Too loose clearance causes blunt cut though the blades are well tightened. -- Stop the engine and touch the surface. The blades have the blades...to gain necessary clearance. 3. Stop the engine at regular intervals to check the cutting blades for possible damage (perform a tapping-resonance test to detect hard-to stop the engine and wait for a minute. 6. Sharpening the blade If the cutting blades have become blunt...