Jenn-Air JXW9048H Support and Manuals
Get Help and Manuals for this Jenn-Air item
This item is in your list!
View All Support Options Below
Free Jenn-Air JXW9048H manuals!
Problems with Jenn-Air JXW9048H?
Ask a Question
Free Jenn-Air JXW9048H manuals!
Problems with Jenn-Air JXW9048H?
Ask a Question
Popular Jenn-Air JXW9048H Manual Pages
Owners Manual and Install - Page 3
... of others .
WARNING
You can be killed or seriously injured if you don't follow instructions. These words mean:
DANGER
You can be killed or seriously injured if you don't ...messages in this manual and on your appliance.
All safety messages will tell you what the potential hazard is the safety alert symbol. All safety messages will follow instructions. RANGE HOOD SAFETY...
Owners Manual and Install - Page 4
... so, unless such persons are supervised or are trained to the outdoors. READ AND SAVE THESE INSTRUCTIONS
4
Do Not Use
To Exhaust Hazardous Or Explosive Materials And Vapors. For General Ventilating Use Only. IMPORTANT SAFETY INSTRUCTIONS
Ducted fans must always be vented to operate the appliance by a person who accepts responsibility for...
Owners Manual and Install - Page 5
... model/serial/ rating plate is not applicable, the standard for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local codes. The canopy range hood is the installer's responsibility to 10" (25.4 cm) round duct
transition. ■■ 2 - 175 W infrared heat lamps ■■ Wood support...
Owners Manual and Install - Page 6
...) minimum for 30" (76.2 cm) Hood
A. Bottom of hood B. B. 96" (243.8 cm) minimum for installations with canopy only. Optional full-width duct cover B. Top of hood D. cabinet opening width (If installed between cabinets)
18" (45.7 cm) min. Wood support
C. Back view
8³⁄₈" (21.3 cm)
9⁷⁄₈"
(25.0 cm)
A
D CL B
18...
Owners Manual and Install - Page 7
...installed to minimize conduction of outside temperatures as possible to where the vent system enters the heated portion of the house.
90 elbow
2 ft (0.6 m)
6 ft (1.8 m)
Wall cap
Makeup air
Local building codes...air movement.
NOTE: Flexible vent is needed for specific requirements in an attic or other enclosed area.
...break should be as close as part of the thermal break. The ...
Owners Manual and Install - Page 8
... procedure. The model/serial/rating plate is attached to the requirements of the hood. 1. Determine which venting method to the wall. Range Hood Mounting Screws Installation
The hood is attached to the wall with the wood support that is located behind the left filter on the vertical centerline. Wood support B. If codes permit and a separate...
Owners Manual and Install - Page 9
...Install Range Hood Blower Motor
1. Slide the left . Spring tab
9 Install the vent system before tightening the mounting screws. A
A. Push the right end of the range hood following the instructions...(3.2 cm) hole at this location.
4. Install 2 - 6 x 80 mm screws into the wood support and tighten.
5.
Remove terminal box cover and set aside.
7. Blower motor 2. Remove knockout ...
Owners Manual and Install - Page 10
... A
Electrical Shock Hazard Disconnect power before operating. Locate junction box inside of the range hood. B C
A. Green, bare or yellow/green wires E. Replace all parts and panels before servicing. A
Make Electrical Connection
WARNING
B
A. Screw B.Mounting hole 5. Wire box connector C. Knockout in death or electrical shock.
1.
Disconnect power. 2. Black wires C. White...
Owners Manual and Install - Page 11
...ground wire to see whether a circuit breaker has tripped or a household fuse has blown. Install grease filters. Halogen lights G. NOTE: To get the most efficient use from home power...section. 2.
Use UL listed wire connectors and connect black wires (B) together.
4.
Install heat lamps into heat lamp sockets. 3. Infrared lamp B. Grease filter handles C. Failure to the green/...
Owners Manual and Install - Page 13
...not operate, make sure the lamps are inserted correctly before calling service. 1. Remove the bulb and replace it counterclockwise.
4. Replacing the Infrared Heat Lamps
Turn off the range hood and allow ...on the back handle and set rear of the grain line to remove. A
3. Repeat steps 2 and 3 for the other bulb if needed . 5. Reconnect power. Replace lamp, using tissue or...
Owners Manual and Install - Page 14
... GY
BK BU
2nd Motor in 48" (121.9 cm)
BK
YL/GN
WH
WH BK
IR Lamp Switch
b
2
1
a
BK
WH
WH
BK
BU BK
MOTOR SPECIFICATIONS
Power Supply
120 VAC
Frequency
60 Hz
Power Absorption 240 Watts
Current
3.7 A
MOTOR RESISTANCE (Ohms)
Blue - Black
9.8
Blue -
Owners Manual and Install - Page 15
...15
ASSISTANCE OR SERVICE
If you need to order replacement parts, we recommend that you use only factory specified parts.
To locate factory specified replacement parts in the United States.
■■ Features and specifications on our full line of appliances.
■■ Referrals to local JennAir® appliance dealers.
■■ Installation information.
■■...
Jenn-Air JXW9048H Reviews
Do you have an experience with the Jenn-Air JXW9048H that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Jenn-Air yet.
Earn 750 points for your review!