Jenn-Air JDRP536H Support and Manuals
Get Help and Manuals for this Jenn-Air item
This item is in your list!
View All Support Options Below
Free Jenn-Air JDRP536H manuals!
Problems with Jenn-Air JDRP536H?
Ask a Question
Free Jenn-Air JDRP536H manuals!
Problems with Jenn-Air JDRP536H?
Ask a Question
Popular Jenn-Air JDRP536H Manual Pages
Warranty - Page 1
..., acts of God or use inconsistent with original model/serial numbers removed, altered or not easily determined. Service or parts for service or repair of this major appliance other damage to the appliance finishes unless such damage results from state to state or province to review the Troubleshooting or Problem Solver section of the product.
15. Before...
Owners Manual - Page 4
.... • Slide range back so rear range foot is under anti-tip bracket. • See installation instructions for range-top service without anti-tip bracket installed and engaged. Do not use . I Never Leave Surface Units Unattended at High Heat Settings - Surface units may be left alone or unattended in an oven or near surface units...
Owners Manual - Page 27
...ports.
SEALED SURFACE BURNERS
1. Remove burner cap.
5. Turn on burner. Contact a trained repair specialist.
2. Clean gas opening with damp cloth.
27
If the burner does not light, ...If the burner needs to be adjusted, contact a trained repair specialist.
4. Replace burner cap. If the burner still does not light, do not service the sealed burner yourself. Do not use a wooden ...
Owners Manual - Page 35
... https://jennair.custhelp.com. A Delay Start has been set . The updated cooking mode selected is wet.
If sparking continues, discontinue use of the material that cooks food the way you want . See the Installation Instructions for valid knob combinations. Push in knob before turning to a setting and verify that a valid mode and temperature selection has...
Installation Instructions - Page 6
... (68.9 cm) depth with local codes.
Additional Installation Requirements
The installation of securing
B
the range is to be installed must be secured to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes. Model/serial/rating plate location/SAID label...
Installation Instructions - Page 9
...kPa). The parts for this range... pipe thread is factory set for use TEFLON®...model/serial/rating plate. Propane Gas conversion: Conversion must be used .
A smaller size pipe on or shutting off gas to turn or move when tightening fittings.
■ Must include a shut-off valve: Install a manual...■ If local codes permit, a new CSA... by a qualified service technician. IMPORTANT: All...
Installation Instructions - Page 10
...up about 3" (8.0 cm) and move and install range.
Remove grates from packaging on top of the
unit.
Set range on cardboard to avoid scratching.
10
...models only, rotate center support counterclockwise off the pallet until it back until range is not needed for shipping and is off shipping pallet. Remove oven racks, and parts package from range. INSTALLATION INSTRUCTIONS...
Installation Instructions - Page 13
...Use pipe-joint compound. Adapter
B
A.
Assemble flexible connector from parts package. Check that the range is factory installed. 1. Do not make sure gas pressure does not exceed ...connected to the user instructions located in the middle rear of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Attach one full...
Installation Instructions - Page 17
... be as follows for operation and checking the regulator setting:
Propane Gas:
Minimum pressure: 10" (25.4 ...14" [35.6 cm] WCP)
The range and its individual manual shut-off of the range.
NOTE: Do not remove the spring...Locate the "LP" and "NAT" position on the model/serial/rating plate. Gently lay kick plate aside to ... pressures in order to remove or replace kick plate. Remove the gas pressure...
Installation Instructions - Page 21
... Spring retainer in LP position
E.
Burner base
4. Replace with package containing literature.
7. See the "Natural ...set pressure.
Line pressure testing above 1/2 psi (3.5 kPa) gauge (14" [35.6 cm] WCP)
The range and its individual manual...installed, remove them. 2. Place Propane gas orifice spuds in the nut driver while changing it. Locate the "LP" and "NAT" position on the model...
Internet Connectivity Guide - Page 1
... have a live internet connection.
■■ The 10-character SAID code for use when your product is your responsibility. The app will make sure to read and follow the Installation Instructions that came with your energy company. NOTE: For 48" models, only one set up a user account. Be sure to get the necessary personal and...
Owners Manual 1 - Page 4
... ARE INSTALLED PROPERLY, SLIDE RANGE FORWARD, LOOK FOR ANTI-TIP BRACKET SECURELY ATTACHED TO FLOOR OR WALL, AND SLIDE RANGE BACK SO REAR RANGE FOOT IS UNDER ANTI-TIP BRACKET.
I Never Leave Surface Units Unattended at High Heat Settings - Do not repair or replace any part of glass, glass/ceramic, ceramic, earthenware, or other servicing should...
Owners Manual 1 - Page 18
...through all of the part code mentioned herein will lower its temperature setting by an amount ... The Sabbath Mode must be scanned or manually added. App Features
The JennAir®...
Models are provided with a Wi-Fi module that certain features and modes are set ...guide and walk you forget to turn the oven off .
■■ When a button is pressed, no longer be automatically replaced...
Owners Manual 1 - Page 27
... ports.
If the burner needs to be auto2m7atically
replaced by the number "4000" (e.g. If the burner still does not light, do not service the sealed burner yourself. SEALED SURFACE BURNERS
1. ...RELEASED
In some European factories the letter "W" of the part code mentioned herein will be adjusted, contact a trained repair specialist.
4. Replace burner cap. Do not use oven cleaners, bleach, ...
Owners Manual 1 - Page 35
...Installation Instructions for the function you want to release air from the gas lines. Surface burners will not operate. Excessive heat around cookware on any one of cooking you avoid a service call an electrician.
The range is open. Make sure cap is not set .
The range must be auto3m5atically
replaced...of the part code mentioned herein will cause the oven to a setting. Cooktop ...
Jenn-Air JDRP536H Reviews
Do you have an experience with the Jenn-Air JDRP536H that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Jenn-Air yet.
Earn 750 points for your review!