Husqvarna HU800H Support and Manuals
Get Help and Manuals for this Husqvarna item
View All Support Options Below
Free Husqvarna HU800H manuals!
Problems with Husqvarna HU800H?
Ask a Question
Free Husqvarna HU800H manuals!
Problems with Husqvarna HU800H?
Ask a Question
Most Recent Husqvarna HU800H Questions
Loud Rattle When The Mower Is Moving.
Could there be something loose in the drive system? It doesn't do it until I start moving.
Could there be something loose in the drive system? It doesn't do it until I start moving.
(Posted by cotyak 6 years ago)
Loud Rattle Or Vibration.
I have a loud rattle or vibration only when my mower is moving. Any idea what is loose or rattling a...
I have a loud rattle or vibration only when my mower is moving. Any idea what is loose or rattling a...
(Posted by cotyak 8 years ago)
Popular Husqvarna HU800H Manual Pages
Parts List - Page 3
... Baffle Keps Locknut 1/4-20 Rope Guide Rear Skirt Spring, Rear Door, LH,...Mower Housing Rod, Hinge Blade Adapter Blade, 22" Washer, Hardened Washer, Helical Screw, Machine, Hex Head 3/8-24 x 1-3/8 Grade 8 Front Baffle Decal, Warning Screw Screw, Hex Washer Head #13 x 3/4 Nut, Hex Lower Handle Handle Bolt Engine, Honda, Model Number GCV160-LAOS3A (For engine service and replacement parts...
Parts List - Page 5
HUSQVARNA ROTARY LAWN MOWER - NO.
33 532 40 91-48 34 532 19 74-80 35 532...Push Adapter, Quick-Connect Coupler Support Bracket, Front Axle Pulley, Idler Screw
5
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm. HU800H (96143009900) PRODUCT NO. 961 43 00-99
KEY PART NO. MODEL NO. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. NO.
1 583 43 ...
Operation Manual - Page 2
... (motor) is equipped with good ankle support while mowing.
• Do not pull mower backwards unless absolutely necessary.
Carefully read and follow all instructions on or near or under rotating parts. It means CAUTION!!! Tragic accidents can occur if the operator is available through your nearest authorized service center. Children are familiar with the controls...
Operation Manual - Page 4
... holding operator presence control bar to service or repair this manual in maintaining, caring for shipping purposes.
OPERATOR PRESENCE CONTROL BAR
MOWING POSITION
TO REMOVE LAWN MOWER FROM CARTON
1. Cut down two end corners of this manual. Remove all parts and hardware you the best possible dependability and performance.
PRODUCT SPECIFICATIONS
Gasoline Capacity and Type: Oil Type...
Operation Manual - Page 6
...lawn mower to start the blade. MULCHER DOOR
MUFFLER
SPARK PLUG
MEETS CPSC SAFETY REQUIREMENTS
Our rotary walk-behind power lawn mowers ...AIR FILTER
HOUSING
ENGINE OIL CAP WITH DIPSTICK
IMPORTANT: This lawn mower is running.
NOTE: Gasoline containing up to engage power- OPERATION
KNOW YOUR LAWN MOWER
READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR LAWN MOWER...
Operation Manual - Page 10
...
that an area be set in the fast position. • Pores in size so that the lawn mower cuts off with use ... early afternoon. Mow north to week. This will help engine air flow and extend engine life. It may be noticed.... nutrients for the lawn. SEE "CLEANING" IN THE MAINTENANCE SECTION OF THIS MANUAL. • The special mulching blade will biodegrade quickly to the first...
Operation Manual - Page 11
... Spark Plug Replace Air Filter Paper Cartridge Empty fuel system or add Stabilizer
* (if so equipped)
** Electric-Start mowers
*** Power-Propelled mowers
****
Use a scraper to see if you should make any of this manual. Check engine oil level. 2. GENERAL RECOMMENDATIONS
The warranty on this manual. To receive full value from the warranty, operator must maintain mower as instructed in...
Operation Manual - Page 13
... and may be damaged by gently tapping on a flat the factory. Replace the air filter every 100 hours of
engine. 5. TO CLEAN AIR FILTER 1. Carefully remove cartridge.
3. If very dirty, replace cartridge.
13
FIG. 16
7. Remove cover.
2. ENGINE
Maintenance, repair, or replacement of continuous use it will smoke on oil. Select the oil's SAE viscosity...
Operation Manual - Page 14
.... Install cartridge, then replace cover. To use pressurized air to keep water out. IMPORTANT: BE SURE THE GARDEN HOSE IS NOT ROUTED UNDER THE LAWN MOWER HOUSING...replace corroded muffler as described in shortened engine life.
14
FITTING
FIG. 18 Spark plug type and gap setting are present, start engine (as it cannot come in the "PRODUCT SPECIFICATIONS" section of this manual...
Operation Manual - Page 15
...'s mowing position. KNOB
BOLT
HANDLE BRACKET
HIGH
MEDIUM
7. LOW
8. Disconnect spark plug wire from opposite side, align hole in handle with air filter and carburetor up.
3. IDLER PULLEY
BELT RETAINER
DEBRIS SHIELD
TO REMOVE DRIVE BELT (See Fig. 19)
1. Disconnect return spring from mower.
TO REPLACE DRIVE BELT (See Fig. 19)
1. Reinstall blade...
Operation Manual - Page 16
...
Your engine speed has been factory set. CARBURETOR
Your carburetor is to the rear.
2.
SERVICE AND ADJUSTMENTS
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are securely fastened.
IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR NEAREST HUSQVARNA OR OTHER AUTHORIZED SERVICE CENTER, WHICH HAS PROPER EQUIPMENT...
Operation Manual - Page 17
... or broken blade adapter.
7. Depress control bar to engine.
17 Replace control bar.
10. Add stabilizer to a Husqvarna or other authorized repair center. Do not use engine or carburetor cleaner products in fuel tank or storage container. TROUBLESHOOTING POINTS
See appropriate section in manual unless directed to gasoline in the fuel tank or permanent damage...
Operation Manual - Page 18
... 1. Belt off .
(if so equipped) 3. Walking speed too fast.
1. Clean underside of lawn mower housing one (1)
setting higher. 3. Cutting height too low. Buildup of power
1. Raise cutting height. 3. Contact a Husqvarna or other authorized service center.
3. Engine flywheel brake is too low. 2. Blade adapter broken. 4. Replace blade adapter. 4.
Raise cutting height...
Operation Manual - Page 19
... 800-805-5523 (Canada) for an authorized Husqvarna service provider. Husqvarna is not authorized to the limitations and exclusions described below. The following are NOT considered defects in this Limited Warranty. All such claims must cease using original OEM Husqvarna replacement parts, subject to handle warranty adjustments or repairs on Exhibit A, all Engines and Attachments are only...
Operation Manual - Page 20
... with improperly installed/removed or modified cutting shields, guards, or safety devices; (m) Any removed/damaged air filter, excessive dirt, abrasives, salt water, moisture, corrosion, rust, varnish, stale fuel, or any adverse reaction due
to incorrect storage procedures; (n) Failures due to improper set up or return of your product online at www.usa.husqvarna.com (US...
Husqvarna HU800H Reviews
We have not received any reviews for Husqvarna yet.