Hoover SH40055 Support and Manuals
Get Help and Manuals for this Hoover item
View All Support Options Below
Free Hoover SH40055 manuals!
Problems with Hoover SH40055?
Ask a Question
Free Hoover SH40055 manuals!
Problems with Hoover SH40055?
Ask a Question
Most Recent Hoover SH40055 Questions
How Do You Reconnect The Power Nozzle Connector. Model Sh40055?
connector come loose and is held by four wires.
connector come loose and is held by four wires.
(Posted by clog 12 years ago)
Popular Hoover SH40055 Manual Pages
Manual - Page 1
... THE STORE. All rights reserved. #960009660 ID101391-R2 THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY. Questions or concerns?
página E1
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. Owner's Manual
Operating and Servicing Instructions
Español - IF USED COMMERCIALLY WARRANTY IS VOID.
©2010 Techtronic Floor Care Technology Limited.
Manual - Page 2
only) or to speak with a customer service representative;
Fri 8am- 7pm EST. Be sure to register your product online at hoover.com. Mon- CODE
Hint: Attach your HOOVER® product.
Please do not return this owner's manual. Manufacturing code
(Label located on bottom of cleaner)
Contents
Important Safety Instructions 3 Cleaner Assembly...5
Carton Contents...5 How To Use...6
...
Manual - Page 3
...cleaner or be
followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE. Avoid picking up sharp objects. • Always turn off all parts...on cord.
Unplug from openings and
moving parts. • Turn off this manual. Do not use with wet hands.... appliance when plugged in this appliance before cleaning or servicing.
• Do not use outdoors or on stairs...
Manual - Page 4
...protector automatically resets and cleaning may need servicing (see "Service" section). Do not change the plug...install the proper outlet. If the plug does not fit fully in a dry place. • An internal thermal protector has been designed into your cleaner may continue. If the thermal protector continues to activate after following the above steps, your cleaner to "Troubleshooting...
Manual - Page 5
Cleaner ASSEMBLY
Carton contents
A. Make sure all parts from Hose, press on front of Wand and pull apart. D
E F
Connect ...The flexible hose contains electrical wires for connection to disconnect
from nozzle.
5 Actual model may vary from cleaner, press release buttons (C) on Wand
end of cleaner.
To disconnect hose from images shown. To remove Wand from carton and identify...
Manual - Page 6
...RED mark. This will prevent the cord from images shown. 6
Actual model may vary from whipping which could cause damage or injury. Press the on/off pedal on ....
2.3
Carry Handle
2.4 Use the carry handle located on the top of the vacuum cleaner, and guide the Power Cord with one hand. HOW TO USE
Cleaner Description
Canister 1 Hose Inlet (Front Of
Canister)
2.1
2 Dirt Cup
2
3...
Manual - Page 7
...Do not store canister in vertical position.
7 Actual model may vary from bottom to the proper setting for carpet settings of the cleaner. Reference the "Vacuum Controls" section under "How to lower hand grip into...Valve.
Vacuum Controls
IMPORTANT
Operate cleaner only at voltage specified on the data plate on and off and begin hard floor cleaning.
2.8
Edge Cleaning
2.9 Guide side ...
Manual - Page 8
... registers. Twist tool slightly to the wand. Dusting Brush with swivel neck may be used for instructions)
2.11
A
Attaching Tools
2.12 Tools may vary from images shown. 8 Firmly push tool ..., upholstered furniture, stairs and baseboards. (Tool stored under Hand Grip)
C. B C
2.12
Actual model may be used for carpets, rugs and hard floor surfaces. (See "Hard Floor Cleaning" section for...
Manual - Page 9
... be done by an authorized service representative.
!
When all the dirt has fallen, close the Dirt Cup Door and replace. Always unplug the vacuum cleaner from images shown.
How to Clean
Disconnect cleaner from electrical outlet.
3.1 Press button on the handle located on a monthly basis and clean when it is wrapped with debris.
CAUTION ! It...
Manual - Page 10
... dirty, follow cleaning instructions. Remove the Filter by the trademark-
IMPORTANT
Allow Filter to be identified by pulling the tab towards you use and volume of use only genuine HOOVER® parts to assure your cleaner operates at the same time Primary Filter is intended to dry completely before restarting the vacuum cleaner.
3.8
3.9
IMPORTANT
Be careful...
Manual - Page 11
... not designed for use only Hoover® Brushroll part #59143012.
To maintain cleaning effectiveness, replace Brushroll if brushes do not operate the agitator correctly and may create stress which could damage your power nozzle.
unplug before cleaning or servicing. To order Filters please visit www.hoover.com.
3.11 3.13 3.15
Actual model may suddenly restart - How...
Manual - Page 12
... and in the upright storage position. 3. No Voltage in manual. 3. See "Vacuum Controls" section.
12 Dirt Cup not installed properly.
3. Handle is found by an authorized service representative.
! Review Dirt Cup replacement section in wall plug.
4. See "Low suction" section above . 4.
TROUBLESHOOTING
If a minor problem occurs, it usually can be done by using the...
Manual - Page 13
... by :
• Checking the Yellow Pages under "Vacuum Cleaners" or "Household". • Visit our website at hoover.com (U.S. Service
To obtain approved Hoover® service and genuine Hoover® parts, locate the nearest Authorized Hoover® Warranty Service Dealer (Depot) by the complete model number when requesting information or ordering parts. (The model number appears on the bottom of...
Manual - Page 14
...800-944-9200 OR visit Hoover® online at no cost to you specific rights; THIS WARRANTY IS THE EXCLUSIVE WARRANTY AND REMEDY PROVIDED BY HOOVER®. For an automated ...replacement or repair performed under the laws of the state of the product, damage due to either a Hoover® Sales and Service Center or Hoover® Authorized Warranty Service Dealer along with the Owner's Manual...
Hoover SH40055 Reviews
We have not received any reviews for Hoover yet.