Installation Instructions
Page 1
... Wire Channel • Slide the wire through the wire channel and wire access in the back housing. • Mount the back housing flat against a wall or in the housing latch at the bottom of the sensor, and gently pull apart the housings. ❸ Mount the unit. IS-215T ... Low [Normal] Sensitivity: 3-5 Steps (Pulse Count 2) • Connect wires as shown using 0.64 - 1.63 mm2 (14 to the application. SENSITIVITY SWITCH SW2 POSITION High (pulse count 1) ON Low [Normal] (pulse count 2) OFF Observe proper polarity. • Configure the IS-215T for the sensitivity best suited to 22 AWG...
... Wire Channel • Slide the wire through the wire channel and wire access in the back housing. • Mount the back housing flat against a wall or in the housing latch at the bottom of the sensor, and gently pull apart the housings. ❸ Mount the unit. IS-215T ... Low [Normal] Sensitivity: 3-5 Steps (Pulse Count 2) • Connect wires as shown using 0.64 - 1.63 mm2 (14 to the application. SENSITIVITY SWITCH SW2 POSITION High (pulse count 1) ON Low [Normal] (pulse count 2) OFF Observe proper polarity. • Configure the IS-215T for the sensitivity best suited to 22 AWG...