Hitachi HDP725050GLA360 Support and Manuals
Get Help and Manuals for this Hitachi item
View All Support Options Below
Free Hitachi HDP725050GLA360 manuals!
Problems with Hitachi HDP725050GLA360?
Ask a Question
Free Hitachi HDP725050GLA360 manuals!
Problems with Hitachi HDP725050GLA360?
Ask a Question
Most Recent Hitachi HDP725050GLA360 Questions
Connect It To A Docking Station And It Cannot Be Detected. Why
The drive is running but nothing happen. Is there a switch to make it detectable?
The drive is running but nothing happen. Is there a switch to make it detectable?
(Posted by paulfan01 8 years ago)
Where Can I Find The Windows Driver For Hitachi Hdp725050gla360
(Posted by jevillamarino 9 years ago)
Popular Hitachi HDP725050GLA360 Manual Pages
Specifications - Page 13
... security feature
• Quiet Seek mode (AAM)
• 48 bit addressing feature
• ATA-8 compliant
• UDMA133 support
• Streaming feature set support
• World Wide Name
• Write Uncorrectable
• SATA 2.6 compliant
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 3 2.0 General features
• Data capacities of 160B - 500GB...
Specifications - Page 18
...
- Latency Data transfer speed Buffering operation (Look ahead/Write cache)
All the above parameters contribute to the assertion of DRQ for NCQ
command (ms)* 0.5 0.2 0.2
not applicable
* SATA only
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 10
4.5 Performance characteristics
Drive performance is in the buffer excluding Physical seek time and Latency...
Specifications - Page 66
... HxP7250xxGLA3y0. This command does not support 80h as a response to the following working documents of Information technology with deviations described below.
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 58
Streaming Commands
When the device is in the section 6.3 "Deviations from Standard" on page 58
- The minimum time limit is not the same as...
Specifications - Page 71
....
This product does not support SERV bit. Since IDX=1 only for timing purposes. HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 63 RDY will be the interrupt acknowledge. DSC is capable of the Status Register will be read by the host, at which time the bit again indicates the current seek complete status. Error. The device sets ERR=0 when the...
Specifications - Page 77
... in SMART self-test log data structure. HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 69 All SMART attributes are updated accordingly during the self-tests, the device services the host command.
If a device receives a firmware modification, all self-test log data is discarded. The error log is not disabled when SMART is supported. If interrupted by SMART...
Specifications - Page 78
... command. Device Frozen mode
The device enables all commands. HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 70
Security Set Password Security Unlock Security Erase Prepare Security Erase Unit Security Freeze Lock Security Disable Password
('F1'h) ('F2'h) ('F3'h) ('F4'h) ('F5'h) ('F6'h)
8.6.1 Security mode
Following security modes are supported for...
Specifications - Page 85
...accessible including the protected area by following.
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 77 Any BIOSes, device drivers, or application software access the HDD as if that native device Maximum LBA is the 6.2GB device because the device acts exactly the same as BIOS code within the protected area. The password does not persist over a power cycle but...
Specifications - Page 88
... subcommand is incomplete, then only words 0 and 2 are set shall be disabled via the SET FEATURES command or use of FEh. HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 80 A device needs a SET FEATURES subcommand to spin-up to the Standby state when the timer times out or the device's Advanced Power Management algorithm indicates that the response is...
Specifications - Page 92
..., the device shall operate according to enable/disable caching shall not affect caching for streaming commands.
8.16.1.3 Not Sequential bit
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 84 If Stream ID is not set of commands:
Configure Stream
Read Stream PIO
Write Stream PIO
Read Stream DMA
Write Stream DMA
Read Log Ext
Support of...
Specifications - Page 95
... setting established by the SET FEATURES command with subcommand code of 03h.
U
U
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 87
SET FEATURES (Reverting to Defaults): The reverting to hard reset and a non-commanded COMRESET may be preserved across COMRESET are listed below. 8.19 Software Setting Preservation
When a device is decremented as part...
Specifications - Page 100
... Action Codes are two ways to access the log pages: using log page E1h.
SCT commands that is supported, but SCT commands cannot be nested. Both sets of one. to unlock the device, all data transfer - In most cases, however, ATA read/write commands may not be inserted in between
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev...
Specifications - Page 104
... Invalid Feature code in Feature Control command Invalid New State value in Feature Control command Invalid Option Flags in Feature Control command Invalid SCT Action code Invalid Table ID (table not supported) Command was aborted due to transfer (Sector Count register) in background
Table 62 Extended Status Code
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 96...
Specifications - Page 132
Bits 7:0 of this word contain the value A5h. The data
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 124 Bits 15:8 of this word contain the data structure checksum. Word
Content
0
0002h
Data Structure revision
1
Multiword DMA modes supported
15-3 Reserved
2 1 = Multiword DMA mode 2 and below are supported
1 1 = Multiword DMA mode 1 and below are ...
Specifications - Page 147
...
10 Host Protected Area feature set
9 DEVICE RESET command
8 SERVICE interrupt
7 RELEASE interrupt
6 LOOK AHEAD
5 WRITE CACHE
4 PACKET Command feature set
3 Power management feature set
2 Removable media feature set
1 Security feature set
0 SMART feature set
Identify device information --Continued-- HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 139
Specifications - Page 210
... Idle mode
01 - 7Fh --- Sector Count Value
Description
01h
Non-zero buffer offset in DMA Setup FIS
02h
DMA Setup FIS Auto-Activate optimization
03h
Device-initiated interface power state transitions
04h
Guaranteed In-Order Data Delivery
06h
Software Settings Preservation
10.38.4 Advanced Power Management
When the value in Sector Count register as Disable Advanced...
Hitachi HDP725050GLA360 Reviews
We have not received any reviews for Hitachi yet.