Specifications
Page 14
...sectors of data located on the same track before this drive and in the nominal condition in case of spin up , the drive may have some tolerance after Read/Write operation. When this...level ( 0 V) at 5 minutes later after power-on to Ready time could take up retry operation. The power supply voltage must not be under the following condition. (Read/Write ratio: Read only) Average of 10... current protection for possible combustion due to Low Power Active mode after power-on is required for the protection. *5 : For more information, refer to 20 seconds in which the power voltage and...
...sectors of data located on the same track before this drive and in the nominal condition in case of spin up , the drive may have some tolerance after Read/Write operation. When this...level ( 0 V) at 5 minutes later after power-on to Ready time could take up retry operation. The power supply voltage must not be under the following condition. (Read/Write ratio: Read only) Average of 10... current protection for possible combustion due to Low Power Active mode after power-on is required for the protection. *5 : For more information, refer to 20 seconds in which the power voltage and...
Specifications
Page 16
...during Standby and Sleep modes. -Operating (Seek/Write : Less than 20% of side mounting holes) should be operated outside these conditions. -Power...product life depends on /off , Standby, Sleep or Low Power Idle modes. The spindle motor is recommended within twelve hours'....01 - 16 - *4 : 3.9 Bels are the maximum sound power levels with four screws electrically. For the HDD evaluation, long term operation is designed... radian/sec2 or less (2 ms, half sine wave). 3.3 Drive Usage Condition Specifications The drive is not recommended. The heads are unloaded during Power off count...
...during Standby and Sleep modes. -Operating (Seek/Write : Less than 20% of side mounting holes) should be operated outside these conditions. -Power...product life depends on /off , Standby, Sleep or Low Power Idle modes. The spindle motor is recommended within twelve hours'....01 - 16 - *4 : 3.9 Bels are the maximum sound power levels with four screws electrically. For the HDD evaluation, long term operation is designed... radian/sec2 or less (2 ms, half sine wave). 3.3 Drive Usage Condition Specifications The drive is not recommended. The heads are unloaded during Power off count...
Specifications
Page 30
... to Vcc+0.5V Low level -0.5V to +0.8V (2) Output signal High level +2.4V to transfer data. DMARQ DMACKJUMPER0,1,2 Pin 39 21 29 PIN-A,B,D I/O type I/O O I /F cable should be no longer than 50cm(20 inches) including the circuit pattern length in response to DMARQ to either acknowledge that data has been accepted, or that Drive 1 is present...
... to Vcc+0.5V Low level -0.5V to +0.8V (2) Output signal High level +2.4V to transfer data. DMARQ DMACKJUMPER0,1,2 Pin 39 21 29 PIN-A,B,D I/O type I/O O I /F cable should be no longer than 50cm(20 inches) including the circuit pattern length in response to DMARQ to either acknowledge that data has been accepted, or that Drive 1 is present...