ProLiant 1600 Ram

Configuration and Tuning of Sybase System 11 for NetWare on Compaq Servers

Page 30
... 11.0.1 system running on Novell NetWare 4.10: • Design your database with performance in mind from the start • Start with minimum of 64 MB RAM • Avoid memory fragmentation, do not load and unload unnecessary NLMs and utilities at the server • Perform administrative tasks at client workstation whenever possible...

I/O Performance Tuning of Compaq Servers

Page 19
... provides tools to the caching and OS variables, you should • Collect relevant, useful data. • Be aware of RAM that can enable your server and the impact each bottleneck will be retrieved more client requests faster. Each tool provides different insight ...implements data caching differently. Novell NetWare, Microsoft Windows NT, SCO UnixWare, and SCO OpenServer have limits on your server to any RAM limitations. Finally, tune hardware and configure the operating system to handle other requests, which hardware elements may not be in Microsoft ...

I/O Performance Tuning of Compaq Servers

Page 31
... 6,000,000.00 4,000,000.00 2,000,000.00 4 8 16 20 24 28 32 36 40 44 48 52 56 57 Number of Clients 128MB RAM Figure 21. Relative performance of a 7-disk, RAID 5 array of 10k rpm drives and a 7-disk, RAID 5 array of the test. These results were obtained using NetBench...

Performance of Microsoft Exchange Server 4.0 on Compaq ProLiant Servers

Page 1
.... Ultimately, this time, Compaq and Microsoft have worked together to optimize Microsoft Exchange Server on Compaq ProLiant Servers, specifically the ProLiant 4500 and the ProLiant 5000. Furthermore, the paper should provide the reader with many features and capabilities. As people must... other useful information pertaining to Microsoft Exchange Server configuration and performance tuning, as well as CPU, RAM, and disk utilization on Compaq ProLiant Servers Electronic messaging is consistently becoming more pervasive in order to satisfy the requirements of Microsoft Exchange ...

Performance of Microsoft Exchange Server 4.0 on Compaq ProLiant Servers

Page 10
That is the number of RAM installed in the system. After the processor subsystem, it will merely amplify the existing weakness in the system. and the processor subsystem is theLoadSim Score. ...

Performance of Microsoft Exchange Server 4.0 on Compaq ProLiant Servers

Page 20
... 4 Kbytes in size, so a net of Users 1500 39 MB 167 MB Figure 9. Note that the entire additional 128 Mbytes of RAM. This is because the extra IS buffers are relieving the disk subsystem of a certain amount of adding extra IS buffers produces significant benefit,... • The benefit of the I/O load. 444A/0696 WHITE PAPER (cont.) 2...0 PENTIUM PRO/166 EXCHANGE SERVER HARDWARE CONFIGURATION Machine Class Compaq ProLiant 5000 Processor Subsystem 1 Pentium Pro/166, 512 Kbyte L2 cache System Memory 128/ 256 Mbytes Disk Subsystem Integrated Fast Wide SCSI-2 controller Pagefile ...

Performance of Microsoft Exchange Server 4.0 on Compaq ProLiant Servers

Page 21
..., and it generally holds true. Although RAID 5 imposes a performance penalty for configuring an Exchange Server computer. the cost of extra disks, adding RAM may be a cost effective alternative to adding disks to a RAID set in order to become memory constrained and start paging. You should be fault...is to the random I/O nature of this section is a good fault tolerance configuration. They are observed, sometimes by too much without adding extra RAM, you have to make it to support the claim, the Pentium Pro/166 with 512 Kbyte L2 cache will likely outperform the Pentium Pro/200...

Performance of Microsoft Exchange Server 4.0 on Compaq ProLiant Servers

Page 22
... time. Depending upon your user load, that provides good sequential write performance and excellent fault tolerance. System Memory • 128 Mbytes of RAM is most cases there is unused memory available on a consistent basis, allocate a portion of it after the initial setup of the log volume..., many disks in the system and allocating it enabled on the Log volume. However, donot over-allocate RAM. 444A/0696 WHITE PAPER (cont.) 2...2 • The log volume mustalwaysbe fault tolerant. Due to the sequential write-only nature of Exchange ...

SMART-2DH Array Controller Reference Guide

Page 39
... existing array controller, you want the order of the integrated SCSI controller to adopt a storage device from another system that : t Contain more than 3 GB of RAM t Contain more than Second, scroll (usually down) to the Embedded Compaq Integrated Controller and set to No Overlay. Online Recovery Server Status This function indicates...

SMART-2DH Array Controller Reference Guide

Page 75
... data guarding when using the Compaq System Configuration Utility, do not select mirroring while using INSTALL.NLM. Using a large block size decreases the amount of RAM required to mount the volume, while Block Sub-Allocation allows intraNetWare to use the Block Sub-Allocation feature of intraNetWare. s Use of linear memory provides...

SMART-2DH Array Controller Reference Guide

Page 177
Array Accelerator Memory Size Change Detected. If more than 32 logical drives, this message will resume when Array Accelerator RAM allocation is Temporarily Disabled (followed by : Auto-configuration failed: Too many logical drives. Expansion will be configured in Remove or reconfigure the conflicting ISA card, ...

Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide

Page 61
A board was installed that has a different revision date. Run the System Configuration Utility and correct. RAM failure. Continued Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide Run Diagnostics. Replace failed assembly as indicated. Run the System Configuration Utility and correct. 3-7 178-Processor Configuration Invalid None 179-System Revision Mismatch 180-Log Reinitialized 201-Memory Error None None None Processor type or step does not match configuration memory.

Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide

Page 62
... error. xx and yy have corresponding bit set properly during installation or upgrade. Replace failed assembly as indicated. Verify placement of Problem 203-Memory None RAM failure. Verify the speed of the memory modules installed and replace. Replace cache with 256K cache.

Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide

Page 70
... when Array Accelerator battery reaches full charge. Run the latest Systems ROMPaq Utility to Conflict With an ISA Card. Expansion will resume when Array Accelerator RAM allocation is temporarily disabled (followed by the System Configuration Utility. Please remove or reconfigure your System ROMs. Remove or reconfigure conflicting ISA cards, especially any...

Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide

Page 84
... timer load data test For error codes 110-xx through 106-xx, replace the processor board and retest. 107-xx 108-xx 109-xx CMOS RAM test failed. 3-30 Diagnostic Tools 5. If this occurs, you must enter the password to error codes 107-xx through 109-xx. 1. If you do not...

Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide

Page 103
3-49 7000-11 7000-12 7000-13 7000-14 7000-15 7000-21 7000-22 7000-23 7000-24 Processor (80186 Timer) Processor (80186 Registers) Processor (Watch Dog Timer) Processor (8570 RAM) Processor (8570 RTC) Memory Memory Write/Read Memory Address Memory Refresh Alert For error codes 7000-11 through 7000-46, replace the Server Manager/R board and retest. Continued Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide

Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide

Page 110
... replace the array accelerator board. Place the array controller in the proper slot or run the System Configuration Utility to reconfigure nonvolatile RAM to be flushed to disk. A hardware problem has occurred; Board not attached NVRAM configuration present, controller not detected Compatibility port problem...reference accelerator is no board in posted status: Valid write memory at reset Data will be taken. replace the IDA controller. EISA nonvolatile RAM has a configuration for a different controller from the system or a board has been placed in the slot. Either a board has ...

Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide

Page 111
Old versions of the System Configuration Utility could cause this. Continued Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide 3-57 signature is zero nonvolatile RAM contains a configuration signature that is zero. System Configuration Utility to configure the controller and nonvolatile RAM.

Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide

Page 112
...drives have been moved to the controller in a different slot and run the System Configuration Utility to configure the nonvolatile RAM. If none appear and drive swapping did not occur, run the System Configuration Utility to the latest firmware revision. ... locations, there may not function properly. Run Options ROMPaq to upgrade the controller to configure the controller and nonvolatile RAM. 3-58 Diagnostic Tools DAAD Diagnostic Messages Continued Message Description Configuration Array accelerator board signature configured for special video control signals...

Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide

Page 114
...drive bay X enabled. Drive Monitoring is below the latest Recommended Action Run the System Configuration Utility to configure the controller and nonvolatile RAM. Drive (bay) X firmware needs Firmware on this physical drive is The monitor and performance NOT enabled for other errors occur,... attempting attempting to access physical to access: X drive X, believed to be present (unconfigured) or the signature present in nonvolatile RAM may be bad. Replace the drive. Run the System Configuration Utility to initialize the monitor and performance features. Message followed by ...

ProLiant 1600 Ram - HP