Haier HWM45-187S Support and Manuals
Get Help and Manuals for this Haier item
View All Support Options Below
Free Haier HWM45-187S manuals!
Problems with Haier HWM45-187S?
Ask a Question
Free Haier HWM45-187S manuals!
Problems with Haier HWM45-187S?
Ask a Question
Popular Haier HWM45-187S Manual Pages
User Manual - Page 1
Twin-tub Washing Machine User's manual
This manual is for future reference.
0030803015B Retain it for HWM45-187S
Please read this manual carefully before using.
User Manual - Page 2
Contents
Names of the parts 1 Safety precautions 2 Installation and adjustment 4 Preparation before washing 6 The musts in washing 7 Usage of the detergent 7 Washing sequence 8 Disposal after washing 11 Trouble-Shooting *Answer to question - - - - - 13 Packing list 15 Specification 16
User Manual - Page 3
Please operate in this manual are given for reference only.
Please check if the power receptacle has good earthing condition...illustrations due to perform.
Performing of the users. Names of the parts
Wash selector
Wash timer
Water-filling entrance
Control panel
Overflow filter Water level adjusting lever Lint filter (installed by user) Valve cover Pulsator Wash tub Drain hose Wash tub ...
User Manual - Page 4
...extracted by the technicians of our special shop or the after-sale service department.
If the power cord is bad, to avoid risk .... Safety precautions
Please insert the power cord into the receptacle is required to replace it by hand. When the machine is idle.
to use single-phase three... machine is installed on the control panel. Do not let the machine share one receptacle with carpet...
User Manual - Page 5
... water ) on the washing machine. Take special care of the whole machine. Safety precautions
Do not stretch hands into the working machine. Do not decompose, repair or alter the machine by yourself. It is suggested to ensure the washer is placed under the room temperature for 2~4 hours and then use the...
User Manual - Page 6
... smooth with the drain hose. 1.The height of the manual. See to your security and correct operating the machine. It is very important to the figure. Installation and adjustment
Please install and adjust the machine according to the overflow filter of the wash tub.
Install the lint filter
After opening the package, please take...
User Manual - Page 7
...Figure 1
Embed the drain hose into the groove in turn
Figure 3
Install the water inlet hose; Extend to needed line.
Set the water level adjusting lever to the spin tub side
Embed into the... care not to change the direction of the drain hoses
Figure 1 indicates the ex factory installation position of the laundries. Figure 2
Embed the drain hose into the water-filling entrance on...
User Manual - Page 9
...
Therefore please use the washing powder
Fill water to decided level. Please refer to the instruction of the cloth will influence the actual washing capacity. The musts in washing
The capacity...completely. 3.Put it in the laundries. Direct dissolved in washing for 30
seconds to the user's manual for the detail dosage.
7 Run for one washing cycle shall be turned round in the machine:...
User Manual - Page 10
Washing sequence
Water inlet
Wash timer
(To set to below 1 minute, first set to 2 minute then turn it can increase the service life of the current according to the laundries. (Figure ... 3)
1212 WASH TIMER
STANDARD
66 99
STRONG
Figure 3
DRAIN
5.After washing, set to 6 minute then turn it can increase the service life of the timer). Fill the water and add the dissolved washing powder to...
User Manual - Page 11
... suitable water continuously.
3.Rinse Adjust the wash timer to 5-7 minutes to the laundries quantity. Select suitable current according to the laundries.
2.Adjust the water level Set the water level with stored water
1.
User Manual - Page 13
Push down side") into the overflow filter , then push the upper part of the filter in time after washing
After using, please clean the lint and foreign materials of the arrow to Figure 1)
2. Install the lint filter After cleaning, insert the bottom of the machine. It must be cleaned in ( marked with " up...
User Manual - Page 14
... level adjusting lever
Corrugation Pipe
Figure 1
Hook
Figure 2
Disposal of the spin tub for long period. Install the overflow filter. (1).Install the corrugation pipe. (2).Insert the mounting plate at the left upper side. (4).Push the upper part in as indicated in the tub for some time (about one hour), then close them.
12...
User Manual - Page 15
... "WASH SELECTOR" at "DRAIN", it will be sure to discharge the water completely after -sales service department. Please confirm the drainage can work normally before next using ) After complete draining, set at "STRONG" or "STANDARD". Trouble-shooting Answer to question
If the laundries fall to the outer side of the spin tub If...
User Manual - Page 16
... laundries falling to the outer side of our company. Trouble-shooting Answer to question
(If there's breakdown, please pull ...please come to the special maintenance department or after-sale service department of the spin tub? If there are not breakdowns...water remained in spin tub too much?
Do not repair it to repair.
The draining does not work
There's abnormal sound during...
User Manual - Page 17
Packing list
Name User's manual Water inlet hose
Lint filter
Gland Twin-tub washing machine
Quantity One piece One piece
One piece
One piece One set
15
Haier HWM45-187S Reviews
We have not received any reviews for Haier yet.