Haier HR-SC Support and Manuals
Get Help and Manuals for this Haier item
Popular Haier HR-SC Manual Pages
User Manual - Page 1
...and answers 15
$4)+JOEE
1. OPERATION INSTRUCTIONS Haier solar station
HR-SC
SOL H PRE INT
WT HC
T-DISP
MPa
ON/OFF SET
REG MODE
Read the operation instruction carefully before use)...... 2 Installation introduction 3
Installation cautions 3 Installation of the solar station ..4 Circuit connection 6 Installation of the operation instruction for late consultation. Ensure...
User Manual - Page 2
... is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in...instruction concerning use of the appliance by a person responsible for the potential risk of the pipes are sealed without reliable
earthing. • If unusual indications or scorched smell is not intended for use by persons (including children) with wet hands for their safety.
2 Haier...
User Manual - Page 3
... conformity to local safety and environmental protection standards or laws.
• The antifreeze must be primed by the qualified technician of Haier.
• The disposal of the antifreeze must be installed or disassembled by yourself, or it , contact the local after -sale sectors, then
the qualified technician will visit you for sealing...
User Manual - Page 4
...wall with percussion drill. Installation introduction
Installation of the solar station
1 Before installation, determine the specific installation position according to the ...installation hanger of solar station must be fixed properly and wall supporting load must be two times of weights of
solar station Small expansion bolt
4 Haier solar station
$4)+JOEE
1.
Notice Installation...
User Manual - Page 5
Installation introduction
„„ Schematic diagram of solar hot ...outlet Solar station Safety valve
Expansiontank
SOL H PRE INT
WT HC
MPa
T-DISP
ON/OFF SET
REG
MODE
Temperature sensor wire of water storage tank Circulation liquid inlet of water storage tank Circulation ...solar station and collector should not be greater than 10m. Haier solar station 5
$4)+JOEE
1.
User Manual - Page 6
... with corresponding interface on the power plate. Insert properly.
3 Fix the grounding wire of water storage tank on the grounding plate of water storage tank. Installation introduction
Circuit connection
Screw off bolts on the bottom shell of solar station, open its front shell and connect the circuit as shown in the...
User Manual - Page 7
...The hole is connected with the equipments ) at the outlet of the priming valve. Installation introduction
„„ Connection of solar collector temperature sensor
1 Find solar collector temperature...interface on the corresponding tubes at the liquid outlet of water storage tank.
$4)+JOEE
Haier solar station 7
1. Then fix expansion tank on the wall with the measured point....
User Manual - Page 8
...direction is vertical to axle of valve, it to prevent the leakage of antifreeze.
8 Haier solar station
$4)+JOEE
1. Notice After priming, put 3/4 fibre gasket in the middle of...handle is the same with returning inlet of priming equipment. Disassemble the priming equipment. Installation introduction
Priming antifreeze
1 Screw off the priming vent cap of priming valve, close ...
User Manual - Page 9
... button for 2 seconds, restore to turn off .
Directions for use
After the installation of all the tubes and wiring, ensure that water storage tank is full of water and ...will be closed.
$4)+JOEE
Haier solar station 9
1. When fault codes occur, press the button for closing. Directions for buttons and indication lamps
„„ :ON/OFF :SET :REG :MODE
...
User Manual - Page 10
...indication light (green/red)
While the green light is on, it is indicated that water heater is on). Different Mode Settings will be reset only under the solar energy heating mode ( green indication light of water storage tank and solar collector in... that water heater starts electric heating working mode. (when the temperature is in turn.
10 Haier solar station
$4)+JOEE
1.
User Manual - Page 11
...Set the dated time 1. press the button to work. The setting... .
It is suggested that the set temperature difference of circulation pump shall be 15&#...set temperature difference of circulation pump, then circulation pump starts to set the current time, "minute" . 3 Set the dated time 2. The setting range is used to setting method of circulation pump. press the button to set...
User Manual - Page 12
...set the temperature for instant heating. Notice In the instant heating mode, solar energy temperature difference circulation will heat water to date one time, set... temperature, start electric heating immediately. while the current temperature is 5°C lower than the set...set temperature, if it is lower than the set... setting ...set temperature, automatically switch to 75°C with green....
User Manual - Page 13
... water temperature continuously decrease 6°C in the period part and maintain the temperature for 30 minutes. Directions for use
„„ The intelligent heating mode is from 30°C to avoid shell fading.
$4)+JOEE
Haier solar station 13
1. During accidental power failure, the system can restore the set the temperature for intelligent heating.
User Manual - Page 14
Parts name
... and RY2: relays
CD
CD: coil for electricity leakage
detection
L
MT: manual reset temperature controller
E
EH: electrical heater
N
CP: circulation pump
TS1: ...
RY1 RY2
TS1 TS2
EH CP
Technical data
Type of solar station
HR-SC
Outline dimensions (H×W×D) 370×292×145(mm)
Water...Haier solar station
$4)+JOEE
Quantity 1 set 1 4 1 1 1
1.
User Manual - Page 15
...
Correct Disposal of this product:
This marking indicates that this product for environmental safe recycling.
$4)+JOEE
Haier solar station 15
1. The power is off, socket is off or control plate is burned without water or manual operation which makes the
sensor probe increase too much in the system. Check temperature sensor of...
Haier HR-SC Reviews
We have not received any reviews for Haier yet.