GE JX827BN - Trim Kit For 1.0 cu. Ft. Microwave Ovens Support and Manuals
Get Help and Manuals for this General Electric item
Popular GE JX827BN Manual Pages
Installation Instructions - Page 1
...
5. Cabinet Cutout Dimensions and Specifications
Allow 1-1⁄4" for overlap of the Microwave Oven Kit
Trim over any General Electric/Hotpoint/RCA single electric wall oven.
• Do not alter or modify any part of this kit or the oven. • Observe all governing codes and ordinances. • Oven must be capable of supporting a minimum of 100 lbs.
24-7⁄ 8"± 1⁄16...
Installation Instructions - Page 2
...drill bit Centerpunch or nail Pencil and ruler Knife
Installation Procedure
Step 1 Locating and Installing Rear Holddown Supports
Set Base Pan (1) into the front cabinet
microwave oven cutout and center it will go . Push back ... flange as your guide (center the drill in the Base Pan front flange and slide the Base Pan straight out. Step 2
Installation of the microwave oven (packing, glass ...
Installation Instructions - Page 3
... A
CAUTION: Start all screws installed in Step 3
Screws A
Step 5
Installation of the microwave oven (the trim frame screws will not align unless the side covers are tight against the sides of the Microwave Oven
Plug the power cord into the holes initially drilled. Screws A
Partition in Base Pan
Rear Duct Base Pan
Screw A Replace screw, removed in Steps...
Installation Instructions - Page 4
... C
Part No. 245B1790P064 (2) Pub. Remove the Trim Kit Frame.
3. Mark Mark
Trim Kit Frame Mark
Mark
Wall Installation
CAUTION: Do not overtighten screws since it with the microwave oven in the Trim Kit Sides (6) as a template (and with 8 screws (C).
Using the assembled Trim Kit Frame as shown.
Screw D
Side Trim (6)
Screw D
Top Trim (4) Bottom Trim (5)
Screw D
Screw D
Side Trim...
GE JX827BN Reviews
We have not received any reviews for GE yet.